10 kg of R-134a fill a 1.3206 m^3 rigid container at an initial temperature of 24 C. The container is then heated until the pressure is 200 kPa. The final temperature in C is? "The pressure of an automobile tire is measured to be 198 kPa (gage) before the trip and 225 kPa (gage) after the trip at a location where the atmospheric pressure is 97 kPa. If the temperature of air in the tire before the trip is 29 C, the air temperature in C after the trip is?"

10 kg of R-134a fill a 1.3206 m^3 rigid container at an initial temperature of 24 C. The container is then heated until the pressure is 200 kPa. The final temperature in C is? "The pressure of an automobile tire is measured to be 198 kPa (gage) before the trip and 225 kPa (gage) after the trip at a location where the atmospheric pressure is 97 kPa. If the temperature of air in the tire before the trip is 29 C, the air temperature in C after the trip is?"

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 17RQ: At a constant pressure, how does a volume of gas vary with respect to the absolute temperature?

See similar textbooks

Similar questions

A bicycle tire with a volume of 0.00212 m3is filled to its recommended absolute pressure of 495 kPa on a coldwinter day when the tire’s temperature is −15 °C. The cyclist thenbrings his bicycle into a hot laundry room at 32 °C. (a) If the tirewarms up while its volume remains constant, will the pressureincrease be greater than, less than, or equal to the manufacturer’sstated 10% overpressure limit? (b) Find the absolute pressure inthe tire when it warms to 32 °C at constant volume.
Consider a U-tube whose arms are open to the atmosphere. Now equal volume of water and light oil (ρ=790 kg/m3) are poured from different arms. A person blows from the oil side of the U-tube until the contact surface of the two fluids moves to the bottom of the U-tube, and thus the liquid levels in the two arms are the same. If the fluid height in each arm is 102 cm, determine the gage pressure the person exerts on the oil by blowing.
Solve this question very carefully write clearly and circle the final answer for the” final temperature” in Celsius And The volume of the tank for a final pressure of 10kpa in units of m^3
One kilogram of R-134a fills a 0.090-m3 rigid container at an initial temperature of –40°C. The container is then heated until the pressure is 280 kPa. Determine the initial pressure and final temperature.
A 10 ft3 vessel of hydrogen at a pressure of 305 psia is vigorously stirred by paddles until the pressure becomes 400 psia. Determine the change in internal energy.
Identify the state of the fluid: R134a at 400kPa, with a specific volume of 0.0223m3/kg
The tanks will befilled at 20 °C to a pressure of 100.0 atm. What maximum and minimum pressureswould you expect to observe in a full tank if the ambient temperature will rangefrom -20 °C to 30 °C?
A rigid tank holds 20 lbm of air at a pressure of 20 psi and a temperature of 70°F. Increase the amount of air introduced into the tank until the pressure and temperature reach 35 psia and 90 degrees Fahrenheit, respectively. Calculate the amount of air that should be pumped or added into the tank.
Water in a rigid container has a pressure of 1000 kPa and specific volume of 0.1 m3/kg . The quality x is:
The temperature and pressure at the surface of Mars during a Martian spring day were determined to be -56 oC and 433 Pa, respectively. (a) Determine the density of the Martian atmosphere for these conditions if the gas constant for the Martian atmosphere is assumed to be equivalent to that of carbon dioxide. (b) Compare the answer from part (a) with the density of the earths atmosphere during a spring day when the temperature is 18 oC and the pressure 101.6 kPa (abs).
A hydraulic lift is to be used to lift a 550 kg weight, the piston–cylinder of the hydraulic lift contains oil at a pressure of 603 kPa. The piston has a mass of 6 kg and a diameter of 10 cm. In this case the local atmospheric pressure is ..............
A closed vessel contains air at a pressure of 160 kPa gauge and temperature of 30°C. The air is heated at constant volume to 60°C with the atmospheric pressure of 759 mm Hg. What is the final gauge pressure (kPa)? Answer: 185.8606 kPa