11 Determine the current flowing through resistor R2. (assume Zener voltage is 3 volts and Diode forward voltage is 0.7V) * R2 1K R1 D2 1K 5V D1

Q: .Three resistances have the following ratings : R1= 25+ 5% R2= 43+ 3% R3= 85+5% Determine the…

A:

Q: If a Si diode at room temperature (25°) has a leakage current Is = 48 nA, k = 5,800, and Vp = 0.53…

A: Given,  The reverse saturation current, IS=48nA=48×10-9A k=11,600η, for silicon, η=2Hence,k=5,800…

Q: Example1/ An open wire T-L with R=10 KO/Km ,L=3.7 mH/km ,C=8.3× 10-°F/Km and G=0.4x 10-6U/Km , find…

A:

Q: 30 V: 5k0

A: The solution is given below

Q: Three impedances of value Z1=4+4j _Z2=5+6j Z3=6+4j are connected in parallel. Determine the…

A:

Q: for given conductor is AC resistance is 25 Ohm the the DC resistance is =________Ohm?

A: RAC=RDC K F K=Wire gage factorF= frequency Generally, Rac is 1.2 to 1.3 times Rdc

Q: Example4/ A telephone cable with R=52.5 KO/Km, C=62 nF/Km , G=0 and L=1.1 mH/Km, find ,x ,B ,Vp and…

A: The solution is given below

Q: DRAW A SCHEMATIC DIAGRAM TO PROVE THE TRUTH TABLE OF INVERTER USING IC-7404

A: I am solving this problem by using Thinker CAD

Q: Given that the potential V = 2x²y³ + 4xyz2 Find E at (4,5,8). Give expression for pr c/m³. mv.

A: We need to find out electric field and volume charge density for given potential function .

Q: C2 R4 ww R2 R3 R1 E(s) E(s)

A:

Q: #8. For the next two questions, refer to the emitter follower circuit below. Assume Vs = -1V and the…

A:

Q: In the circuit shown, determine the circulating current.

A:

Q: Example3/ An open wire T-L with G=0.29x 10-6U/Km ,L=3.52 mH/Km , C=8.7 nF/Km ,R=6.74 KN/Km at F=1…

A: Given Data is  G=0.29×10-6,L=3.52mH/km, C=8.7nF/km and R=6.74k Frequency 1kHz thus, ω=2πf=6.28kHz.…

Q: Design an LC passive low-pass filter for a hi-fi woofer crossover with the following specifications:…

A: given data  1) For a buttis with filter  H(ij)2= 11+(ffc)2N In db…

Q: (b) Apply the one-sided and double-sided spectral amplitude and phase on a given practical signal of…

A:

Q: SYNCHRONOUS MOTOR motor = 2 ohms/phase 1. A three-phase 2,300-V, Y-connected wound rotor synchronous…

A: The power angle is an angle described between Terminal voltage and internal voltage of a…

Q: The convolution of a step function with another step function gives a O a. step function Ob. none of…

A: We need to select correct option for given statement .

Q: Compute the V2(peak) Half of 2nd windings, Vout(peak), Vout(DC), fout in the center tapped rectifier…

A: Given: Consider the following circuit: To find: Compute the V2(peak) Half of 2nd windings,…

Q: Find the nwer absorbed by the element ANSWE i = 2 A Ute =4 V Uab =-4 V

A: We need to find out power absorbed .

Q: Question 2 Given Vcc=12V, at first the voltage inputs at Pin 6 and Pin 2 are both 10V. Decide the…

A: The solution is given below

Q: Q3 (а) Figure Q3(a) shows a system that produces output m(t) from the input x(t) given in Figure 1.…

A:

Q: In the circuit shown, determine the current flowing through the resistor R1.

A: In this question we need to find a current through resistance R1.

Q: الملزمة/5 Example1/ An open wire T-L with R=10 KO/Km ,L=3.7 mH/km , C=8.3x 10-°F/Km and G=0.4x…

A:

Q: 2. In the emitter follower discussed in the lectures, the output (emitter) voltage is 0.7V below the…

A: The given circuit diagram  is shown below: The given graph is shown below:

Q: 6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll

A: In this question,   We need to determine the peak voltage Across the load and average power P?  We…

Q: The following circuit is at steady sta before the switch closes. Find the inductor current after the…

A:

Q: From the circuit, calculate the capacitor voltage and inductor current immediately after the switch…

A:

Q: Vout (s) for the two circuits shown below. 6. Wr ite the transfer function, Vin (s) ' R1 R1 R2

A:

Q: Compare and contrast the Closed and Open loop Control System

A:

Q: 8s+6 (a) Given, G(s) +1. Using phase variable canonical form, convert the transfer s2+8s+3 function…

A:

Q: Create a truth table with solution

A:

Q: 3 Determine the voltage across the resistor R2. (assume LED forward voltage is 2.1 volts) * A R2 1K…

A:

Q: 2. Find derivation of formula and solved example for the following circuit. Voltage Comparator…

A:

Q: 1. Consider the circuit below +12V R1=12K R2 The light-dependent-resistor (LDR) R2 is 1M2 when itť's…

A: Given: Consider the following circuit: The light-dependent resistor (LDR) R2 is: R2=1 MΩ⇒When it is…

Q: 4.22 A 50 KVA; 600/240-volt; 25 cycle transformer has a core loss of 200 watts of which 30% is eddy…

A: Given data, Rating of transformer 50 KVA, 600/240 V Core loss = 200 W. Full load copper loss = 650…

Q: Example3/ An open wire T-L with G=0.29× 10-6U/Km ,L=3.52 mH/Km , C=8.7 nF/Km ,R=6.74 KQ/Km at F=1…

A:

Q: Chose a suitable range for n to depict the signal or sequence by calculate to prove the discrete…

A: According to the question, we need to select the suitable range for n of the following signals a)…

Q: P5.1 What is the minimum sampling frequency needed to sample the following signals to prevent…

A: The solution is given below

Q: In the circuit shown, determine the current flowing through the resistor R1.

A: The given circuit is:

Q: a R C The switch in the circuit above has been in position a for a long time. The variables in the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: For the circuit below, find Thevenin's equivalent circuit between terminals 1-2. 30 ww

A:

Q: (s+6)(s + 2) s2 + 20s + 116 R(s) K →C(s) Figure Q1 A unity feedback control system is given in…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: (a) the value of resistor Ry such that the total power dissipated in the circuit is 2.5kWatt, (b)…

A: General procedure to solve any circuit DC circuit with any number of resistors Suppose n number of…

Q: 12.42 In a rectangular resonant cavity, identify the dominant made when (a) a b > c (c) a = c > b

A: According to the question, we need to find the dominant mode of the rectangular resonant cavity,…

Q: Q5) write true or false in the following sentences: 1. Load torques which always oppose the motion…

A: We are authorized to answer only 3 question at a time since you have not mentioned which question…

Q: 3. Find the Vout and io (a) (b) 20 kQ 8kQ ww 10 kN ww 6 k2 ww- 6k2 1.5 V 2V 4 kN 4 kN 1.2 V

A:

Q: R= 180 Q 120 V 30 mH 1000 Hz coil Solve for the Apparent Power delivered by the power supply to the…

A:

Q: Given R, = 8 ohms, v = -10V, iz = 2A and R3 = 1 ohm, find %3D

A: For KVL equations- Summation of voltage drops in a closed loop is  always zero. For KCL equations-…

Q: For the circuit of Figure 5.1, calculate the value of VA for each stepped value of VS and place the…

A: The given circuit is shown below:

Q: A voltage-controlled oscillator (VCO) is an oscillator that oscillates at a constant frequency and…

A: In this question we will write about voltage control oscillator...

Analysis of Diode

It is a semiconductor device in electronics applications where only a one-way current is required. It is like a one-way switch that allows current to flow in one direction only. A diode has two terminals, a cathode, and an anode. The cathode is the negative terminal that carries electrons, while the anode is the positive terminal that carries holes. Although no element has holes, it just means that there is a free space for electrons. Diodes are used to convert AC to DC. As we know, AC shifts between positive and negative cycles and DC stays positive constantly. As the diodes allow current only in one direction, they filter out the AC signal’s negative cycle and only keep the positive one.

Working and Construction

In civil engineering, construction means the application of principles of science and mathematics for building bridges, dams, buildings, roads, highways, tunnels, airports, structures, etc. Different branches of science, like physics and chemistry, are extensively applied to design and analysis in construction. Material properties, the science of atmospheric conditions (like solutions, mixtures, etc.), the impact of environmental factors like, corrosion and acidity are some of the primary knowledge of chemistry which are used by civil engineers to carry out construction. Estimation of forces, application of laws of mechanics, fluids mechanics, soil mechanics, etc. are some of the fundamental concepts of physics, which are well applied in construction works. Building construction and structural engineering are two of the most primary areas in civil engineering that parallelly applies principles of both chemistry and physics to carry on construction works.

Property of Diode

An electronic component that facilitates the directional flow of current is known as a diode. According to the direction of the flow of current, the resistance of a diode changes from zero to Infinity.