12) You have an inductor that produces 50.0 (mH] of magnetic field. 12a) What is the characteristic time constant of this inductor if it has a resistance of 2.00 [Q]? 12b) If it is connected to a 9.0 V battery, what is the current after 10 [ms]?

12) You have an inductor that produces 50.0 (mH] of magnetic field. 12a) What is the characteristic time constant of this inductor if it has a resistance of 2.00 [Q]? 12b) If it is connected to a 9.0 V battery, what is the current after 10 [ms]?

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Inductance

Section: Chapter Questions

Problem 17P

See similar textbooks

Related questions

Q: 1. A magnetic circuit which has a total flux of 3 x 10-3 weber, drawing a current of 4 amperes in a…

Q: 8) A stationary conducting loop of radius a is placed in a time-varying magnetic field B = 2B, sin…

A: Induced EMF is given by: EMF = -N*d(phi)/dt phi = Magnetic flux through loop = B*A w = angular…

Q: (23%) Problem 4: Consider a transformer, used to recharge rechargeable flashlight batteries, that…

Q: 4) A current of 5A is passed through a 1000-turn coil wound on a circular magnetic circuit of radius…

A: Given that : Current (I) = 5 A; Number of turns (N) = 1000; Radius (r) = 120 mm or 0.12 m

Q: A light conducting ring is placed on top of an iron core with a wire wrapped around it as shown.…

Q: 11.. A coil of radius 0.5 m consisting of 1000 loops is placed in a 500 T magnetic field such that…

Q: 45. It is desired to construct a solenoid that will have a resistance of 5.00 N (at 20.0°C) and…

Q: 7. A conducting loop has an area of 280 cm² and resistance 15 . It is perpendicular to a spatially…

Q: Solve it correctly please. I

Q: What is the type of core material of the transformer? a. Silicon steel b. Iron c. Copper d.…

Q: 4. List the magnetic permeability and inductance values of some important materials: iron, steel,…

Q: 3. An inductor used in a de power supply has an inductance of 12.0 H and a resistance of 180 Q. It…

Q: 10) In the figure, the current in a solenoid having no appreciable resistance is flowing from b to a…

Q: The conducting bar illustrated as shown moves on two frictionless, parallel rails in the presence of…

A: Given data *The bar has mass is m *The bar has a length is l *The bar is given with an initial…

Q: Why Hysteresis Losses of DC motor is constant? a. It does not depends on load current b. none…

A: Why Hysteresis Losses of DC motor is constant?a. It does not depends on load current b. none of the…

Q: 4. For the following scenarios determine A) the direction of the External magnetic field B) if the…

A: This question contains marks mentioned in it. Since the student is saying this is not graded, we are…

Q: Suppose there is a steady current in an inductor. If you attempt to reduce the current to zero…

A: The current voltage relationship for an inductor is given by the following equation. Here, L is the…

Q: 1. How does increasing the number of loops strengthen the magnitude of the induced EMF or…

A: To explain: The reason why the increasing number of loops strengthen the magnitude of the induced…

Q: (11%) Problem 3: Suppose that a 0.325 m radius, 500 turn coil produces an average emf of 8550 V when…

A: Given:Radius of the coil = 0.325 mNumber of turns = 500Average emf, εavg = 8550 VTime = 4.08 ms

Q: 25.0-H inductor has 100 A of current turned off in 1.00 ms. (a) What vollage is induced to oppose…

Q: If a magnet is held stationary and a coil is moved towards the magnet with high speed then, O a.…

A: As we move the coil towards magnetic, the magnetic field changes and hence induces an emf in the…

Q: 20%) Problem 4: A single-turn rectangular wire loop has a resistance equal to 1.8 2 and ne…

Q: 14. In the figure, a bar magnet moves towards the solenoid. The direction of the induced current…

A: By Using lenzs law The direction of induced current from through resistor is from a to b. Thus…

Q: 8. When current is flowing through the solenoid wire the pole that will be created at location I is…

Q: 3. What is the mutual inductance of two coils if an average electromotive force of 0.15 V was…

Q: 9. Suppose the wire in a cars alternator is wrapped 500 times. It takes an average of 2.5x10 seconds…

A: Write a given values of this question. N=500t=2.5×10-4sϕ=2×10-4Web

Q: 85. The emf induced in an 80-mH inductor is -0.72 V when the current through th inductor increases…

Q: A bicycle generator rotates at 1,975 rad/s, producing a 17.5 V peak emf. It has a 46-turn, 1.00 by…

Q: Which of the following represents the variation of current and inductance of inductor? D O a. A O b.…

Q: A simple AC generator consists of 10 turns of coils with an area of 1 000 cm2. It rotates at a…

A: Concept used is rate of change of magnetic flux gives emf in coil

Q: 8. The straight wire carries a current I. In which direction (clockwise or counterclockwise) does…

A: Straight Wire carries current I in the upward direction. The direction of magnetic field can be…

Q: induced=-NAD, At В What will increase the Voltage produced by a moving magnet? OIncreasing the area…

A: The induced voltage is given by the expression : Vinduced = - N ×∆ϕB∆t where ϕB = magnetic flux =…

Q: (III) A simple generator has a square armature 6.0 cm on aside. The armature has 85 turns of…

A: Given: Square armature 6.0 cm on a The armature has 85 turns of 0.59-mm-diameter Rotates in a 0.65-T…

Q: 60. What are the directions of the currents in the loop and coils shown in Figure 22.61? Bin B B (a)…

A: From figure (a), the magnetic field is pointing in the inward direction, hence from the right-hand…

Q: 7. The 4.50 A current through a 7.10 mH inductor is switched off in 9.50 ms. What is the emf…

Q: 29. The length of the solenoid is 85.0cm and the cross-section is 17.0cm^2 ?, and 6.60A of current…

Q: 99. State the direction of the induced current for each case shown below, observing from the side of…

A: Solution:

Q: 2. If the current in a solenoid is reversed in direction while keeping the same magnitude, the…

A: 2. Direction of current in the solenoid

Q: A bicycle generator rotates at 1,800 rad/s, producing a 15.5 V peak emf. It has a 45-turn, 1.00 by…

Q: A solenoid has a length of 20 cm, a radius of 0.8 cm, and 350 turns, and carries a 2.9-A current.…

Q: 4. (I) If the solenoid in Fig. 21-59 is being pulled away from the loop shown, in what direction is…

A: Explanation: The current will be in such a way that it will try to pull solenoid inside, so the…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

12) You have an inductor that produces 50.0 [mH] of magnetic field.
12a) What is the characteristic time constant of this inductor if it has a resistance of 2.00 [Q]?
12b) If it is connected to a 9.0 V battery, what is the current after 10 (ms)]?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A magnetized sewing needle has a magnetic moment of 9.70 mA m2. At its location, the Earths magnetic field is 55.0 T northward at 48.0 below the horizontal. Identify the orientations of the needle that represent (a) the minimum potential energy and (b) the maximum potential energy of the needlefield system. (c) How much work must be done on the system to move the needle from the minimum to the maximum potential energy orientation?
Since the equation for torque on a current-carrying loop is =NIABsin, the units of N (m must equal units of A (m2 T. Verify this.
How would you place two identical flat coils in contact so that they had the greatest mutual inductance? The least?
What current is needed in the solenoid described in Exercise 22.58 to produce a magnetic field 104 times the Earth’s magnetic field of 5.00105T ?
It you want a characteristic RL time constant of 1.00 s, and you have a 500 (resistor, what value of self-inductance is needed?
A circular loop of wire is located in a uniform and constant magnetic field. Describe how an emf can be induced in the loop in this situation.
You intend to move a rectangular loop of wire into a region of uniform magnetic field at a given speed so as to induce an emf in the loop. The plane of the loop must remain perpendicular to the magnetic field lines. In which orientation should you hold the loop while you move it into the region with the magnetic field to generate the largest emf? (a) with the long dimension of the loop parallel to the velocity vector (b) with the short dimension of the loop parallel to the velocity vector (c) either way because the emf is the same regardless of orientation
Suppose you have a supply of inductors ranging from 1.00 nH to 10.0 H, and registers ranging from 0.100 (to 1.00 M What is the range of characteristic RL time constants you can produce by connecting a single resistor to a single inductor?
A strong electromagnet produces a uniform magnetic field of 1.60 T over a cross-sectional area of 0.200 m2. A coil having 200 turns and a total resistance of 20.0 is placed around the electromagnet. The current in the electromagnet is then smoothly reduced until it reaches zero in 20.0 ms. What is the current induced in the coil?
An example of magnetohydrodynamics (MHD) comes from the flow of a river (salty water). This fluid interacts with the Earth’s magnetic field to produce a potential difference between the two river banks. How would you go about calculating the potential difference?
Measurements affect the system being measured, such as the current loop in Figure 22.56. (a) Estimate file field the loop creates by calculating the field at the center of a circular loop 20.0 cm in diameter carrying 5.00 A. (b) What is the smallest field strength this loop can be used to measure, if its field must alter the measured field by less than 0.0100%?
Draw a diagram and use RHR-l to show that the forces on the top and bottom segments of the motor’s current loop in Figure 22.34 are vertical and produce no torque about the axis of rotation.