Answered: 12. A loaded zener regulator is shown…

12. A loaded zener regulator is shown in Figure 3-76. Vz = 5.1 V at Iz = 49 mA, IZK = 1 mA, Zz = 72, and IZM %3D %3D %3D 70 mA. Determine the minimum and maximum permissible load currents. %3D

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter22: Magnetism

Section: Chapter Questions

Problem 22PE: A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall...

See similar textbooks

Related questions

Q: 3. Does KCL hold true for the circuit, prove that?

A: KCL- Kirchhoff's Current Law, often shortened to KCL, states that “The algebraic sum of all currents…

Q: A circular loop of fle initial circumferenc but its circumferenc

Q: Two cables are tied together at C and are loaded as shown. Deter- mine the tension (a) in cable AC,…

A: Solution: Given that load W =400 N

Q: 4. The ring of negligible size is subjected to a cylinder of 250 lb, as shown below. If the tension…

Q: 1. Sketch the waveforms for the load current and voltage for Figure 2–73. Show the peak values. +5 V…

A: For given circuit in the question, to sketch the waveform for the load current and voltage and show…

Q: For the following equilibrium system, assuming all strings are ideal. If the mass M = 50, and the…

A: Given:β=50oθ=30oM=50 kgg=9.81 m/s2To solve this problem we will take the help of free body diagram…

Q: Section 2 - Does resistance depend on length? 1. (1) Compare the resistance for coils A and C 2. (2)…

A: As per guidelines , only 3 subparts are solved here. Section 2. 1.(1) Resistance of coil A =…

Q: The average power at resonance (when Vmax=100 V , R=100 ohm) is: a-99.49W b-45.98W c-49.98W…

A: The expression for the maximum power dissipated at resonance will be,

Q: •6 Figure 30-37a shows a circuit consisting of an ideal battery with emf & = 6.00 µV, a resistance…

A: Given,

Q: Q5) W. bridge at state of balance when first arm 1000, second arm 2000, third arm 100Q and forth arm…

A: A Wheatstone's bridge works using the principle of Bridge Balance. When the resistances across the…

Q: A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall…

A: Given: l = 2.5 m v = 6 m/s B = 5 x 10-5 T

Q: How can we calculated power drawn from the 12-2 DC supply ww 3-62 w A₁ Svolts

Q: 7. A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the…

A: Given, Earth's magnetic field, B = 5×10-5 T Diameter of the wire, d = 2.50 m water velocity, v =…

Q: 6. If h goes to the right through Ri, k goes to the right through R2, and a goes to the right…

A: It is given that, I1 goes to the right through R₁, I2 goes to the right through R₂, and I3 goes to…

Q: 7. Two 50 M F capaators are connected in porallel. The equivalent copacitance of the combinaton is…

Q: he figure shows a wire loop made of copper wire with a radius of 0.1 cm with side lengths of 20 cm x…

A: Given Radius of wire- 0.1cm Crossection of the loop- 20*80 cm B=30T (perpendicular to the loop)…

Q: 400 mm, -1100 mm- A B. 960 mm C

Q: 1.31 Resolve the 360-lb force into components along the cables AB and AC. Use a = 55° and ß = 30°.

A: Given that: The force is 360 lbs. the angle is: α=55°β=30°

Q: 2-29. The characteristic equation of a parallel RLC circuit shown in Fig. P2.29 is given as 1 2+ RC+…

Q: dir to I个

A: The direction of Current is in upward direction. .

Q: RI R2 Jhe loops are abh ga I dand Loob 2- R6 ن E2 bcdhb R3 R4 feo 3 - g hdefg g abcefa acdga Rs Joop…

A: Refer the current distribution in branches as assumed next step. By KVL we have .

Q: Which of the following describes Ampere's law? Curl(B) = | Divergence (B) = J %3D Curl(E) = B %3D…

Q: 3. An air-core solenoid 50 cm long has 4000 loops wound on it. Compute B in its interior when a…

Q: Determine the frequency of the given instantaneous equation e=10(1000t - 69 degrees) V O 159.1Hz O…

Q: 8) when a I- 10A conductor is placed in the middle of the aîr gap in z direchion; How much of the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Q: In resonance condition , current .............. voltage A- lags B- leads C-Is greater than D-…

A: Here we are considering RLC circuit but it could be any resonant circuit like series LC or parallel…

Q: An air-core solenoid consists of 200 turns of wire wound on a form that is 75 cm long and has a…

Q: 22) Determine the, , (rms), of a half-wave rectifier circuit connected to 1 KO. 1:1 230 V V ip :1 K

A: Primary to secondary turns is: N1/N2= 1 RMS primary voltage =…

Q: B F 75 900 N The tension in cable AC is 500 N. Determine the tension in cable AB and the angle 0.

Q: A large water main is 2.50 m in diameter and the average water velocity is 4.90 m/s. Find the Hall…

A: Average water velocity (v) = 4.90 msDiameter (d) = 2.50 m Magnetic field (B) = 4.90×10-5 T

Q: ACTIVITY #2 – PROBLEM-SOLVING A closely wound solenoid of 1,250 turns has an axial length of 98cm…

A: Given: The number of turns is 1250. The leght of the solenoid is 98 cm. The radius of the solenoid…

Q: 1- Find the Value of the electre Current I in the followinig Circuit 3. 2. ww 4 12V

A: Given Data : The voltage of the battery is given as V = 12V. The resistance of 5Ω and 6Ω are…

Q: 5. In the following circuit, the output Y for all possible inputs A and B is expressed by the truth…

Q: The purpose is to determine the current, and sometimes the phase difference between the voltage…

A: In an LCR circuit, the maximum current will occur when the capacitive reactance is equal to the…

Q: 2. shown in Fig. 2552. <ひこk0 Sin34ピ Galueofthe Current flowingatany instant b The power Cons umed.

Q: The triangular block shown in Figure 206 is subjected to the loads P= 1600 KN and F= 800 KN, if AB=…

A: First, we find the angle of the block at C. In ∆ABC, Let ∠ACB = θo Now using the tan function, tan θ…

Q: Q 2. In the fra, shown below. Resolve the fore l00lb into faio Components one abng AB and the other…

Q: The loop rule applied to loop abda will give a. 12-18.0 I+ 6.00 I=0 b. 12-18.0 I1-6.00 I2 0 c. 6.0 +…

Q: V = 3.2V I= 2.4 Elkctnc motor %3D a, (denver) = 9.796MISIS 2.1 23 dy = 1.66 m 2.06 Power Sorce time:…

A: given m = 0.1074 kg g = 9.796 m/s2 h = 1.66m time = (2.1+2.3+2.06)/3 t = 2.153 v = 3.2v i = 2.4 A

Q: The triangular block shown in Fig. P-010 is subjected to the loads P = 1600 lb and F = 600 lb. If AB…

Q: Q) Rs in the DC Wheatstone Bridge, null type is adjusted to 20Ω at balance. Find Rx, when Ra = 10Ω,…

A: given: Ra = 10 ΩRb = 2.5 ΩRs=20 Ω

Q: The voltage across a solenoid is shown in the figure, measured by an oscilloscope. What would be the…

A: Given data, Peak value of the AC voltage = 40 mV

Q: 4-34.Determine the load in members AC and BC in Figure P4-34. 9 m 12 m C В 61.2 kg

Q: Circuit Diagam rn m: R5: 0.50 R = 0.50 R: 0.52 R, : 0.50 R,: 0.8 R, = 0.S2 R: 0.5 2 calcula hiens

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

Number 12. And assume Zz = 0 ohms.

12. A loaded zener regulator is shown in Figure 3-76. Vz = 5.1 V at Iz = 49 mA, IZK = 1 mA,
Zz = 72, and IZM
%3D
%3D
%3D
70 mA. Determine the minimum and maximum permissible load currents.
%3D

Expert Solution

Step 1

Given values,

$\begin{array}{rcl} V_{z} & = & 5.1 V \\ I_{z} & = & 49 mA \\ I_{zk} & = & 1 mA \\ Z_{z} & = & 0 o h m s \\ I_{zm} & = & 70 mA \end{array}$

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A cylindric mica insulator to be used between a 100 kV DC line and ground has a diameter of 5 cm. The insulator is expected to prevent currents of more than 1 nA^1 . Find the minimum required length of the porcelain cylinder.
Using information in Example 20.6, what would the Hall voltage be if a 2.00T field is applied across a 10-gauge copper wire (2.588 mm in diameter) carrying a 20.0-A current?
A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall voltage produced if the pipe runs perpendicular to the Earth's 5.00105T field.
Review. A novel method of storing energy has been proposed. A huge underground superconducting coil, 1.00 kin in diameter, would be fabricated. It would carry a maximum current of 50.0 kA through each winding of a 150-turn Nb3Sn solenoid. (a) If the inductance of this huge coil were 50.0 H. what would be the total energy stored? (b) What would be the compressive force per unit length acting between two adjacent windings 0.250 in apart?
For the circuit shown below, =20V , L = 4.0 mH, and R = 5.0 . After steady state is reached with S1 closed and S2 open, S2 is closed and immediately thereafter (at t = 0) S1 is opened. Determine (a) the current through L at t = 0, (b) the current through L at r = 4.0 x 10-4 s, and (c) the voltages across L and R at t = 4.0 x 10-4 s.
Integrated Concepts (a) Using the values given for an MHD drive in Exercise 22.59, and assuming the force is uniformly applied to the fluid, calculate the pressure created in N/m2. (b) Is 1his a signi?cant fraction of an atmosphere?
1-7 List four input transducers and describe how they are used.
6. A large water main is 2.50 m in diameter and the average water velocity is 4.90 m/s. Find the Hall voltage produced if the pipe runs perpendicular to the Earth’s 4.90×10-5–T field. This is not and will not be graded
5- The 5 cables in the figure are perpendicular to the screen and in the directions shown in the figure; They carry a current of i1 = i2 = 0.75 A and i3 = i5 = 0.50 A. So, for the Ampere Ring in the figure, if $B.di = 1.90 x 10-6 T.m, which of the options is the value of i4 correctly? (Ho = 4pi * 10-7 T.m/A) A) 2,50 A B) 2,00 A C) 0,50 A D) 1,00 A E) 1,50 A
Find the equations of 4 junction and 7 loops for the figure given Given that: R1=25,R2=45,R3=10,R4=15,R5=20,R6=40,E1=10,E2= 35
A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall voltage produced if the pipe runs perpendicular to the Earth’s 5.00×10−5-T field.
How do you get the I0 = 10^-12 W/m^2 ?