13. One end of a uniform bar with mass 5.00 kg and length 0.800 m is attached to a vertical wall by a frictionless hinge. The bar is held at an angle of 36.9° by a light horizontal rope that is attached to the other end of the bar. What is the tension in the rope? (a) 40.9 N (b) 32.7 N (c) 24.5 N (d) 16.4 N (e) none of the above answers 36.9

13. One end of a uniform bar with mass 5.00 kg and length 0.800 m is attached to a vertical wall by a frictionless hinge. The bar is held at an angle of 36.9° by a light horizontal rope that is attached to the other end of the bar. What is the tension in the rope? (a) 40.9 N (b) 32.7 N (c) 24.5 N (d) 16.4 N (e) none of the above answers 36.9

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter14: Static Equilibrium, Elasticity, And Fracture

Section: Chapter Questions

Problem 33PQ: Problems 33 and 34 are paired. One end of a uniform beam that weighs 2.80 102 N is attached to a...

See similar textbooks

Similar questions

A person carries a plank of wood 2.00 m long with one hand pushing down on it at one end with a force F1 and the other hand holding it up at .500 m from the end of the plank with force F2. If the plank has a mass of 20.0 kg and its center of gravity is at the middle of the plank, what are the magnitudes of the forces F1 and F2?
Suppose the weight of the drawbridge in Figure 9.34 is supported entirely by its hinges and the opposite shore, so that its cables are slack. (a) What fraction of the weight is supported by the opposite shore if the point of support is directly beneath the cable attachments? (b) What is the direction and magnitude of the force the hinges exert on the bridge under these circumstances? The mass of the bridge is 2500 kg.
A 20.0-kg horizontal plank 4.00 in long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 N
Suppose a 900-kg car is on the bridge in Figure 9.34 with its center of mass halfway between the hinges and the cable attachments. (The bridge is supported by the cables and hinges only.) (a) Find the force in the cables. (b) Find the direction and magnitude of the force exerted by the hinges on the bridge.
A uniform drawbridge must be held at a 37.5 ∘∘ angle above the horizontal to allow ships to pass underneath. The drawbridge weighs 45000 NN, is 16.5 mm long, and pivots about a hinge at its lower end. A cable is connected 3.00 mm from the hinge, as measured along the bridge, and pulls horizontally on the bridge to hold it in place. 1)What is the tension in the cable? 2)Find the magnitude of the force the hinge exerts on the bridge. 3)Find the direction of the force the hinge exerts on the bridge. 4)If the cable suddenly breaks, what is the initial angular acceleration of the bridge?
A 45.1 kg man is walking on a 147 kg uniform beam that is attached 19.0 m below the top of a building and is 21.2 m long. If a wire is attached to both the top of the building and end of the beam, and is able to handle 1.52E3 N of tension, how close to the end can the man walk before the wire breaks?
A uniform beam of length 12.0 m and weight 690 N is connected to a wall by a bolt, and is supported by two cables. Cable 1 makes an angle of 25.0 Degrees with the beam, is attached 5.00 m from wall, and has a tension of 312 N. Cable 2 makes an angle of 39.0 Degrees with the beam and is attached to the end of the beam. The system is in static equilibrium. What is the tension in cable 2?
A 557-N force is applied to stretch a cable, 66-m long and has a cross-sectional area of 2.8 mm^2. Young's modulus for the cable is 1.0 × 10^11 N/m^2. How far does the cable stretch?
Suppose the weight of the drawbridge in the figure is supported entirely by its hinges and the opposite shore, so that its cables are slack. The mass of the bridge is 2500 kg. What percent of the weight is supported by the opposite shore if the point of support is at the very end of the drawbridge? What is the magnitude, in newtons, of the force the hinges exert on the bridge under these circumstances?
One end of a uniform rod of weight w = 73.5 N and length L = 2.55 m is supported by a cable at an angle of ? = 37.0°above the rod. The other end rests on a small frictionless support and presses into a wall as shown in the figure. Determine the magnitude n of the vertical normal force exerted by the support on the rod and find the magnitude T of the tension in the cable.
21.A uniform ladder weighing 100N leans against a smooth vertical wall with its lower endresting on a rough floor, the ladder making an angle of 70o with the horizontal. Find (a)the force exerted by the wall on the ladder and (b) the force exerted by the floor atthe lower end of the ladder.
A uniform platform with mass M=30kg and length L=15m is placed on two supports as shown. The distance between the supports is a=6m and F=340N is applied as shown with distance b=4m. The system is in static equilibrium. a) Find Normal force FN1 in Newtons. b) Find Normal force FN2 in Newtons.