Answered: 13. Susceptance and conductance add to…

Engineering

Electrical Engineering

13. Susceptance and conductance add to form. A. Impedance. B. Inductance. C. Reactance. D. Admittance.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: RMS value ?

A: Given waveform,

Q: A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle…

A: In the question, Find the source voltage if output current waveform is given. Duty cycle=50%…

Q: a) Biefly explain the importance of reactive power in the analysis of power system performance.

A: (a) AC power system has two types of power. Active Power Reactive Power The power which is…

Q: (a) Consider the single-phase AC circuit shown in Figure Q1(a) below. Analyze the circuit by…

A: Given,V=100cos104t=1002∠0° Vω=104 rad/sL=20mHXL=ωL=20×10-3×104=200ΩXc=1ωC=12×10-6×104=50Ω…

Q: For the sinusoidal waveform shown in Figure Q9 (1), Estimate: i. Frequency ii. Amplitude ii.…

A: In the waveform Find the frequency Time period Amplitude Rms value

Q: 1: Theory 1.1 Describe briefly a sinusoidal signal and ALL its properties. Give example with…

Q: Discuss the following term in a reactive circuit: a. Real Power b. Apparent Power c. Power Factor

Q: . What effect does changing the frequency on the effective value of sinusoidal voltage? 2. What…

A: Consider a sinusoidal voltage voltage shown below, Here v=Vmsinωt The peak voltage is Vm and ωt=α…

Q: A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source…

A: According to question:

Q: The waveforms below represent one full cycle of the applied voltage vs and the supply current is.…

A: We can tell phase nature of waveforms by observing their peak positions with respect to time.

Q: Electrical generator has coil rotating in a magnetic field to generate sinusoidal voltage waveform.…

A: According to question: EMF induced in a generator is given as ε=Blvsin(θ) Where B is the magnetic…

Q: Consider the sinusoidal given in the figure below, determine the amplitude, period, frequency and…

Q: a) Define the complete response in transient circuits? b) Plot [v() =5u(-t+1) - Su(-t- 1)]? c) What…

A: Note: Since you have posted a question with multiple subparts, we will solve the first three…

Q: Find RMS

A: In the given waveform. Find the rms current ? Rms = root mean square value

Q: Discuss the following term in reactive circuit? a) Real power b) Apparent power G) Power factor 1.

Q: What is the value of form factor of sinusoidal voltage?

A: form factor is the ration of the rms value to the average value

Q: (S4.3c) A single-phase load has a measured fundamental voltage of 230V, fundamental current of 18A…

Q: The resistance and inductance of a coil can be obtajned by connecting the coil in series with a…

A: The solution is given below

Q: The sinusoidal ac source in the figure has an rms 20 value of V. Considering all possible values of…

A: Solution is explained down !!

Q: A source of 100 volts rms is supplying a resistance 80 ohms in parallel with a 200 mH inductor. To…

Q: ١-The PMSM used in the industry due to: a- Their low noise. b- Their easy control arrangement. c-…

A: 1) The permanent magnet synchronous motor(PMSM) is used in industry due to their low power…

Q: ow do we figure out what our phase relationship in a series reactance and resistive circuit?

A: Question How do we figure out what our phase relationship in a series reactance and resistive…

Q: A load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the…

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: a.) determine the undamped natural frequency b.) determine the damping ratio c.) determine the…

Q: What impedance vector (0- j15) Ohms represents: A. A pure resistance. C. A pure capacitance.…

A: Since real part is 0, so it can't be resistor. So option A is wrong.

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: Given

Q: A capacitor is connected to an AC source, the current is a) leading or lagging? b) by many degrees?…

A: In this question we will write about inductor ans capacitor voltage and current relationship and…

Q: Describe what happens to the power in this RLC series circuit as the capacitance decreases. Explain…

A: Given: A series RLC circuit as shown below and a table for real power, reactive power, power…

Q: (b) Design the circuit by finding the value for the capacitor, C and the line voltage Vpri(rms) to…

A: Capacitor- capacitors are widely used in electronic circuits to block direct current power while…

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: In this question, Voltage Vs and current I phasor are given. Find the total impedance Z? We know…

Q: summarize about Sinusoidal Steady State Circuit Analysis

A: Steady state indicates absence of transients. This state is achieved after 5 time constants when…

Q: Determine the rms value for each of the waveforms shown in figure below.

A: The root mean square value of any function represents it's effective value affecting the working…

Q: 2. What is the relationship between inductive reactance and frequency? n canacitivIe reactance and…

A: In this question 2, What is relation between frequency and inductive Reactance.

Q: Figure 3P.2 shows two capacitor banks, C, and C2, in a substatior C is enercized, but C, is…

A: The circuit diagram with two capacitor banks C1 and C2 is shown below, Where the capacitor C1 is…

Q: P3/ A A sinusodail signal shown in figure (1) be low: PP =RV Time (t)

A: Solution- Given, T = 0.08 sec VPP = 12 V f = 1/T = 1/0.08 = 12.5 Hz n = 4 bit Quantizer-…

Q: Please draw the voltage and current curves versus ωt for inductor with sinusoidal AC power supply.…

A: Let the current through the inductor is Now, It means voltage leads current by 90 degrees in…

Q: Solve for the Vrms (magnitude only) across the capacitive reactance if R2 = 1058 ohms and Xc = 2351…

Q: Figure P5.12

A: Using KVL at positive terminal of op amp Here vn is the voltage at negative terminal

Q: For the circuit shown, what is the reactive power, Q, delivered by th voltage source? (Assume the…

Q: What impedance vector - j25 represents: A. A pure resistance. C. A pure capacitance. B. A…

Q: What is the average power in ghe single phase ac circuit with the purely resistive load? It is…

A: According to the Ohm’s law:

Q: Another name for reactive power is?

Q: Determine the capacitance value that, when placed in parallel with this load, would produce a unity…

A: Given Voltage V=230 V Frequency f=60 Hz When capacitance is placed in parallel with the load which…

Q: Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average…

Question

13. Susceptance and conductance add to form.
A. Impedance.
B. Inductance.
C. Reactance.
D. Admittance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source voltage is 20 V and the frequency of the chopper is set to 100Hz and the on-time to 5 ms. Determine the average voltage and current, maximum and minimum load currents.
Derive Vout in terms of waveform generator.
b) Determine the voltage ?(?) and current ?(?) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors ?L, ?r and ?c. e) Sketch the phasor diagram showing ?s, ?r, ?r, ?c and ?.
Q.4Determine the current flowing in the capacitor(-j25ohm) and its direction as shown in Figure below. Assume the voltage source to have negligible impedance.
Construct a graph to represent the recurring nature of partial discharge pulse sequences under sinosoidal alternating voltage (applied voltage) using internal discharges as a typical example. The graph should consist the voltage accross the dielectric, voltage across the void and current impulses.
Design a circuit limit a 25 V rms sinusoidal voltage to a maximum positive amplitude of 18 V of using 12 V dc source.
Determine the rms value for each of the waveforms below.
How do I find the phase of this sinc function?
in all forms (sine-cosine, amplitude-phase, complex-exponential form)
A coil has resistance of 5 ohm and capacitive reactance of 6 ohm . a) what is the impedance of the coil? b) what is the admittance of the coil?
Write a report to compare between Ac Through capacitance and AC through in inductance then: For the circuit shown beside, find the total impedance between a and b and Circuit current (I)