Determine the capacitance value that, when placed in parallel with this load, would produce a unity power factor. Assume that the source is 230 V at 60 Hz. The Q shown is a positive Inductive reactive power, which would have to be “offset” by the same value of Reactive Capacitance Power.

Q: ) the power consumed by the speaker. -) the capacitance C. ) the power factor seen by the source.

A:

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 2, (b)…

A: In this question, find the instantaneous current with different different impedance.  Draw the…

Q: Two loads, A and B, are connected in parallel across a 1-kV-rms 60-Hz line, as shown in Figure…

A: For load active power is given, Power factor is given, Therefore, apparent power is,  Reactive…

Q: Voltage

A:

Q: Problem 2 A capacitor is used to correct the power factor of the load of the following figure.…

A: Capacitance value not given It might be 50 Hz or 60 Hz  So taking both the cases... It is a simple…

Q: Assuming that a nonzero ac source is applied, state whether the power and reactive power are…

A: Assume the power angle is θ and complex power is S, and the relation is given by, a).  Pure…

Q: 1. How much value of capacitance should you place to correct the power factor of a load consisting…

A:

Q: What impedance vector 10 + j22 represents: A. A pure resistance.         C. A pure capacitance. B. A…

A:

Q: a. Sketch a power triangle for an inductive load, label the sides, and show the power angle. b.…

A: Power triangle for inductive load is given by,

Q: A sinusoidal 50 Hz voltage of 200 V (rms) supplies the following three circuits which are in…

A:

Q: Calculate the current drawn from the source with and without the capacitor connected. Determine the…

A:

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A:

Q: Derive an expression for V(rms)» fundamental and harmonic components of the load voltage as a…

A:

Q: Faraday and Henry are the units for inductance and capacitance. Select one: True False

A: In this question , we will write units of inductance and capacitance .

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: The solution is given below

Q: (S4.3c) A single-phase load has a measured fundamental voltage of 230V, fundamental current of 18A…

A:

Q: A 480-V rms source supplies a load that absorbs 100 kW at a 0.7 lagging power factor. A capacitor is…

A: The solution is given below

Q: Two loads, A and B, are connected in parallel across a 1-kV-rms 60-Hz line, as shown in Figure…

A: Given data: Real Power of load A, PA = 10 kW Power factor of load A, cosφA = 0.9 Apparent Power of…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A:

Q: resistance of 20 Ω, an inductance of 0.2H and a capacitance of 100μF are connected in series across…

A: In this question , series RLC circuit is given....We have to find out impedance , current , voltage…

Q: (a). Write the instantaneous currents across the three circuit elements in terms of Vm amp > angular…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Find the rms value of the current waveform shown in Figure P5.13.

A: Given data: T=4 The expression for the rms value of the current is given as, Irms=1T∫0Ti2tdt

Q: -j3N Is IL IR Vc Vs j6n 3 ViR 120 Figure QI(b) (b) An ideal voltage source is connected with one…

A: In this question,  Ideal voltage source and frequency is supplied to the capacitive and inductive,…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A:

Q: A small industrial plant has a 12-kW heating load and a 25-kVA inductive load due to a bank of…

A:

Q: A load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the…

A:

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: In this question, we need to determine the total impedance, current I, frequency domain waveform…

Q: What impedance vector (0- j15) Ohms represents: A. A pure resistance.         C. A pure capacitance.…

A: Since real part is 0, so it can't be resistor. So option A is wrong.

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: Given

Q: A capacitor is connected to an AC source, the current is a) leading or lagging? b) by many degrees?…

A: In this question we will write about inductor ans capacitor voltage and current relationship and…

Q: Describe what happens to the power in this RLC series circuit as the capacitance decreases. Explain…

A: Given:  A series RLC circuit as shown below and a table for real power, reactive power, power…

Q: Q.11: The non-sinusoidal total current in the circuit shown is: (i=5+20sin1000t+ 10sin3000t) Amp. 1.…

A:

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 Ω, (b)…

A: Given: Alternating voltage f=50 HzVrms=150 V

Q: Q.1. If an RMS current of 5 A at 60 Hz flows through an inductor of 10 mH, what is its average…

A:

Q: An industrial process requires a power of 10 kW with a lagging power factor of 0.6 in a single-phase…

A:

Q: 60 hz voltage of 220 volts from a convenience outlet is impressed on a capacitance of 800 pF.…

A: Given capacitor of capacitance 800 pF is connected across 220 volts rms source. capacitive reactance…

Q: P5.94. A delta-connected source delivers power to a delta-connected load, as shown in Figure P5.94.…

A:

Q: a-Calculate and draw the load current for the steady-state condition b-Find the RMS values of the…

A: It is given that: Vs=300 Vf=50HzRL=2 ohmL=0.04 H

Q: pure resistance of 50 ohms is in series with a pure capacitance of 100 microfarads. The series…

A: In this question , we have given series RC circuit...We have to find out impedance , phase angle…

Q: a) The p.d across j5  ohmn inductance b)The p.d across -j10 ohmn capacitance c) the current in 20…

A:

Q: By correcting the power factor of the load in the figure using the capacitor C: 12 Vi V2 P2, Q2…

A: We need to select correct option for given circuit.

Q: 4. A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 n,…

A:

Q: Another name for reactive power is?

A:

Q: Add the two voltages below together (phasor voltages are RMS). ?ଵ =60 ? ∠ 0° ?ଶ =80 ?∠ 270° a) What…

A: a) The two voltages are            V1 = 60 ∠0°            V2 = 80  ∠270° The resultant Voltage  = V1…

Q: An inductive impedance of 40 + j40 ohms is connected in parallel with a pure capacitor. What must be…

A: Given,  Inductive impedance = 40+j40 ohms Input voltage (V) = 230V Let reactance of capacitor be Xc…

Q: The current waveform for a capacitor is shown in the following figure. Determine the a) average…

A: AVERAGE VALUE: The average value is nothing but the ratio of total (net) area under the curve for…

Q: Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average…

A: