13-1II. A 0.2-kg spool slides down along a smooth rod.If the rod has a constant angular rate of rotation= 2 rad/s in the vertical plane, show that the equationsof motion for the spool are i – 4r – 9.81 sin 0 = 0and 0.8i + N, - 1.962 cos 0 = 0, where N, is the magnitudeof the normal force of the rod on the spool. Using themethods of differential equations, it can be shown thatthe solution of the first of these equations isr = Cje " + Cze – (9.81/8) sin 2t. If r, i, and 0 are zerowhen i = 0, evaluate the constants C, and C, determine rat the instant 0 = 7/4 rad.%3D-21e = 2 rad/s

Given Data mass of spool, m =0.2Kg angular velocity θ.=2rad/s

Answered: 13-1II. A 0.2-kg spool slides down…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The spring-held follower AB has a mass of 0.4 kg and moves back and forth as its end rolls on the contoured surface of the cam, where r = 0.15 m and z=(0.02cos2θ)m. The cam is rotating at a constant rate of 30 rad/s. The spring is uncompressed when θ = 90. Determine the maximum force component FzFz the follower exerts on the cam. Determine the minimum force component FzFz the follower exerts on the cam.
15-102. The two spheres each have a mass of 3 kg and are attached to the rod of negligible mass. Determine the time the torque M = (8t) N·m where, is in seconds, must be applied to the rod so that each sphere attains a speed of 3 m/s starting from rest
A railroad car that is assumed to be rigid and has a mass of 80 Mg ismoving forward at a speed of v = 0.2 m>s when it strikes a steel 200 mmby 200 mm post at A, Fig. a. If the post is fixed to the ground at C,determine the maximum horizontal displacement of its top B due to theimpact. Take Est = 200 GPa.
The 4-lb collar C fits closely the smooth shaft. The spring in unstretched when s=0 and its stiffness is 6 lb/ft. AT s=0 ft, the collar is given a velocity of 19ft.s-1. The height is 0.6-ft. determine the position of the collar when its velocity is 0 ft.s-1
The spring-held follower AB has a mass of 0.5 kg and moves back andforth as its end rolls on the contoured surface of the cam, where r = 0.15 m and z =(0.02 cos 2θ) m. If the cam is rotating at a constant rate of 30 rad/s, determine theforce component Fz at the end A of the follower when θ = 30°. The spring isuncompressed when θ = 90°. Neglect friction at the bearing C.
F14-1. The spring is placed between the wall and the 10-kg block. If the block is subjected to a force of F = 500 N, determine its velocity when s = 0.5 m. When s = 0, the block is at rest and the spring is uncompressed. The contact surface is smooth. S00N Prob. F14-1
The two spheres each have a mass of 3 kg and are attached to the rod of negligible mass. If a torque ? = (6?0.2?)?. ?, where t is in seconds, is applied to the rod as shown, determine the speed of each of the spheres in 2s, starting from rest.
The mass m = 5.0 kg resting on a frictionless horizontal table is connected to a horizontal spring with stiffness constant k = 170 N/m. The mass is pulled a distance to the right so that the spring is stretched a distance x0 = 1.3 mm initially, and then the mass is released from rest. e)? g)?
If the force exerted on cable AB by the motor is F = ( 110 t 3/2 ) N, where tt is in seconds, determine the 55-kg crate's velocity when ttt = 5 s . The coefficients of static and kinetic friction between the crate and the ground are μs = 0.37 and μk = 0.29, respectively. Initially the crate is at rest. (Figure 1)
Given a 1400 kg car traveling along a route with an increasing vertical profile y=0.0003x^2. Determine the x-component of the car's velocity (m/s) and the total force (kN) if the constant velocity is 30 m/s and the distance is 210m. Hint: A line's slope is equal to tan theta, where theta is an angle measured from the x-axis.
If the rod of negligible mass is subjected to a couple moment of M = (30t^2) N⋅⋅m, and the engine of the car supplies a traction force of F = (15t) N to the wheels, where t is in seconds, determine the speed of the car at the instant t = 12.5 s. The car starts from rest. The total weight of the car and rider is 1.5 kN. Neglect the size of the car.
P13-2. The 10-kg block is subjected to the forces shown.In each case, determine its velocity at s=8m if v=3m/sat s=0. Motion occurs to the right.

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS