14 D1 R1 5V 1K Determine the voltage across the resistor R1. (assume LED forward voltage is 2.1 volts)

Q: find the inductance at A and the resistance

A:

Q: P5.1 What is the minimum sampling frequency needed to sample the following signals to prevent…

A: The solution is given below

Q: Redraw the assigned x(t) and y(t) signals as shown in Figure 1 and Figure 2, respectively. (b) x(t)…

A: Given here two signals and asked to redraw the the signals x(t) and y(t) as shown in the figure 1…

Q: In the circuit shown, determine the voltage across resistor R1. D1 R1 6V 1K D2 Kt

A:

Q: Kindly show complete solution and Box the Answers. Thank you!

A:

Q: Determine the total flux in the core as given in Figure Q1-3. [Answer: 0 = µNih/ 2t[In (b/a)] b a +…

A: A magnetic core is shown in the question. The core is a toroid with rectangular cross section. We…

Q: If the internal noise is reduced in a nonideal amplifier, the output signal-to- noise power ratio…

A: The solution is given below Correct option is 1-d 2-c

Q: 1. Determine the following: 201 а. VL b. 12 IT 60 2 SOLUTION: 20 V 20° Xc 100 X 401

A:

Q: 240 V, 4-pole shunt motor running at 1000 rpm gives 15 h.p. with an armature current of 50 A and…

A:

Q: 12.42 In a rectangular resonant cavity, identify the dominant made when (a) a b > c (c) a = c > b

A: According to the question, we need to find the dominant mode of the rectangular resonant cavity,…

Q: Example3/ An open wire T-L with G=0.29x 10-6U/Km ,L=3.52 mH/Km , C-1 K U7 find 7

A:

Q: DRAW A SCHEMATIC DIAGRAM TO PROVE THE TRUTH TABLE OF INVERTER USING IC-7404

A: I am solving this problem by using Thinker CAD

Q: Q9: Find a, ßand V2 12v 5.6kn -2.7 v -4 V 2.4kn -10v

A:

Q: Comparing an electric dipole attenna and a magnetic dipole attenna, if the frequency is the same and…

A: According to the question, Comparing an electric dipole antenna and a magnetic dipole antenna, if…

Q: Q4 Based on Figure Q4, find v, using nodal analysis. 12.5 A 80 2Ω 10 4Ω 100 V 100 V Figure Q4

A:

Q: Using mesh analysis find I 0. 4 2 I3 5/0° A -j2 Q j10 Ω ll 20/90° V 8Ω I = -j2 N (+1)

A:

Q: Determine the output for each of the following input signals (sin(2t) (b) x2(t) = at Need part B…

A:

Q: What is the dynamic resistance of a diode if its ID = 2.48 mA? No need for a solution. Just write…

A: The solution is given below

Q: Questoin 7) The size of the pMOS transistor(s) for a standard size NOR3 pseudo-nMOS gate is…

A: A Pseudo-nMOS gate consists of a inverter, where it's gate is pulled to ground and uses a p-device…

Q: In the circuit of the figure the switch is closed. Determine: The potential difference across the…

A:

Q: R + G, G2 G, G4 H H

A:

Q: An open delta three phase transformer system has one transformer center tapped to provide a neutral…

A: It is given that: voltage from line to center tap=277 V

Q: Apply source tranformation to simplify the circuit and determined the power absorbed by 52 resistor.…

A:

Q: Discuss how you add more voltages using the summing amplifier. - If the values of the input…

A: A summing amplifier is a kind of amplifying circuit connection used to combine available voltages in…

Q: A cylindrical capacitor having a length of 130 mm is made of two concentric rings with an inner…

A:

Q: R5=1k Yb R7=1k R9=1k +YR5- R6 R8 V1 5V V2 10V 3.3k 3.3k Figure 5.2

A: The solution is given below

Q: Find the Thevenin equivalent of the following circuit and hence calculate the power consumed by the…

A:

Q: 6. [Chapter 4.7] Let s(t) be an angle modulated signal that arrives at a receiver s(t) = 2 cos[10ʻnt…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: Example3/ An open wire T-L with G=0.29× 10-6U/Km ,L=3.52 mH/Km , C=8.7 nF/Km ,R=6.74 KQ/Km at F=1…

A:

Q: Determine the voltage across the resistor R1. (assume LED forward voltage is 2.1 volts

A: In this question,   We need to determine the the voltage across the resistor R1. (assume LED forward…

Q: R= 180 2 120 V 30 mH 1000 Hz coil Solve for total circuit Z. Copy paste these in as needed 2° (No…

A: The solution is given below

Q: 5 Determine the current flowing through the LED. (assume an LED forward voltage of 2.1 volts) * A D1…

A: The solution is given below

Q: 1. Given the following Boolean functions: f(a, b, c) =(c'+b'c').(b+c).(a+bc') A. Find the…

A:

Q: Question 2 Given Vcc=12V, at first the voltage inputs at Pin 6 and Pin 2 are both 10V. Decide the…

A: The solution is given below

Q: 1. Consider the mechanical system shown in figure below. If x.(t) is the input, obtain the transfer…

A: In this question,   We need to determine the transfer function?  We are solving this problem using…

Q: F1 = x(y +y')z =xy'z' E(0, 5, 7) F2 = xy'z' +xy +xy(z + z') = E(2, 3, 4) F3 = x'y'z + xy(z + z') =…

A:

Q: 3.14 Using the formula % regulation = [ V(cos 02 + Rpu)2 + (sin62. +Xpu)2 -1]100% %3D determine the…

A: 3.14 It is given that: KVA=50240:120f=60 Hzr1=0.13ohm       r2=0.03 ohmx1=0.20ohm      x2=0.05 ohm

Q: If the signal power is twice to its noise power, the information capacity will: Select your answer.…

A: The solution is given below

Q: R1 2.2k. +8V Si Vi Vo EAV -8V

A:

Q: Question No.26 The four arms of bridge network has ZAB = 100 z 30° Q , ZBc = 100 2 -30° Q. ZcD = 50…

A: Given four arms of the bridge network has, ZAB=100∠30° ΩZBC=100∠-30° ΩZCD=50∠-60° ΩZDA=?

Q: Question For the series-parallel network shown in the following figure, find: (a) the supply…

A:

Q: 41. For the network of Fig. 15.148: a. Calculate E, Ig. and Iz in phasor form. b. Calculate the…

A: In this question,  A current is given  We need to determine the E, current in  the resistance R and…

Q: The net voltage gain around the feedback loop must be unity or larger, and the net phase shift…

A: Brief description : Here in the question they are interested in the concept of oscillator circuit.…

Q: 3. The figure below shows a logic circuit and its incomplete truth table. Complete its truth table.…

A:

Q: The waves transmitted from the source in the open circuit lines suffer complete regression, so the…

A: When transmission line is open circuited its impedance is deoendent on the output impedance of the…

Q: Use DTFT properties and transform-pair tables to find time-domain or frequency-domain signal as…

A: As per our policy, we can solve only first three parts

Q: Which of the following electroanalytical methods are correctly described? I. Voltammetry involves…

A: Voltmeter is used to measure the potential. Ammeter is used to measure the current. Coulometry is…

Q: R2 2K D1 R1 9V 2K 1.5V

A: Current is a rate of flow of charges, resistance is a property opposing the flow of current,…

Q: (b) Apply the Fourier series on the train impulse :

A:

Q: What is the dynamic resistance of a diode if its Ip = 4.06 mA? No need for a solution. Just write…

A: The solution is given below

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.