A cylindrical 00 AWG copper wire is coated with NEMA class B insulation. The normal operating temperature of the wire is . What is the maximum current the wire can carry for 1 second without exceeding the NEMA temperature rating?

Q: d) Describe the construction, principle of operation and application of i) Rod gaps ii) Expulsion…

A: Given types of arresters: Rod gaps Expulsion gap Valve type lightning arrester

Q: Explain the working principle and operation of any one types of solar collectors.

A:

Q: Identify and explain the different notational methods for describing the behavior of gases and…

A: Gates: It is an electronic circuit and has logical decisions based on applied input.

Q: 4. Explain the environmental impacts of Nuclear power plant

A: Nuclear power plant:- A nuclear power plant is a thermal power station.Heat source is a nuclear…

Q: List the three steps of nuclear fuel fabrication processes. Also sketch a schematic diagram and…

A: Steps are mentioned below :

Q: Describe the construction and operation of a TRIAC and give one practical application of the device.…

A: TRIAC: A TRIAC is a three-terminal electrical component which may conduct current in any direction.…

Q: Questions: 1. Are the experimental and theoretical values of voltages and currents match? Indicate…

A: Part (1): The experimental value is the measured value during the experiment. Whereas the…

Q: 10.C-Which part of the NEC standard proposes the switches requirements?   D-If the branch circuits…

A: The Given General living space is

Q: what are the advantages and disadvantages of fuse and circuit breaker? (in terms of their usage)

A: 1. Fuses has faster reaction because it has very few parts compared to circuit breakers because…

Q: What is the minimum trade size PVC conduit to contain 201 #12AWG TW75 Copper conductors.

A: First, determine the standard diameter of 12-AWG TW75 copper conductor from the NEC table. From the…

Q: What the need of testing insulators in the laboratory? Why insulators most likely to fail at lower…

A: Insulators are the substances that don't conduct electricity at all.

Q: What do you understand by Safety factor, puncture and Flashover of Insulator?

A: The safety factor is, Safety factor=Puncture voltageFlash over voltageFor example safety factor of…

Q: Relationship quantitatively and qualitatively. between leakage current and open circuit voltage in…

A: We show that parasitic leakage currents dominate the current voltage characteristics of organic…

Q: Explain the procedure involved to determine core loss and copper loss with neat diagrams (Scan and…

A: From the open circuit test in transformer, core loss is determined. From the short circuit test in…

Q: A) Explain with a neat sketch the process of solar cooling?

A: Solar Cooling- The solar cooling system is used for refrigeration and air conditioning with the help…

Q: Calculate the current, voltage and power for 120 degree conduction periods. Calculate the current,…

A: (1)120° conduction modeRMS value of phase voltage,Vphase=Vdc6=5006=204.12 VVphase=204.12 VRMS value…

Q: Name and explain the process to join any electrical component on strip board.

A: Stripboard: it is a circuit board that contains the parallel strips of the copper material on the…

Q: define fuel core

A: solve

Q: 9. If DS1 shorted, what is the voltage across L-N if a multi-tester set at 600V AC range?

A: Givewn that DS1 is shorted  Now draw the modified circuiut

Q: 1.List the three steps of nuclear fuel fabrication processes. Also sketch a schematic diagram and…

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: What is the important quantity to distinguish metals from insulators or semiconductors ?

A: Given: Metal, Insulators and semiconductors

Q: 1. What is the purpose of conducting Open Circuit (OC) test? 2. What is the purpose of conducting…

A:

Q: With a neat diagram explain the construction and working principle of Bourdon tube sensor.

A: According to the question we have to discuss With a neat diagram explain the construction and…

Q: alculate the maximum force that should be applied via a pulling eye to a 70 mm2, 3-core copper…

A: Given, The maximum force applied via a pulling eye to a 70 mm2, 3 core copper cable, For copper…

Q: 9. Draw and describe (stable/neutral/unstable) the type of system response one would expect from a…

A: We need to state the type of system response for the above diagrams.

Q: Design and describe a system to generate electricity from a fuel cell.

A: Fuel cells perform chemical reactions on reactive gases (Fuel) and produce electricity. It generates…

Q: how do i determine the creepage and cleareance distance for 150 kv high voltage insulator?

A:

Q: Draw the circuit diagram of microwave oven.

A:

Q: Identify and Explain with neat sketch of the 1. Pin Type Insulator

A: As per our policy, i have attempted one question. Pin type insulator - It is a device which is used…

Q: A- What are the advantages of a Nuclear power station? B- Several points should be taken into…

A: Advantages of nuclear power station :- * It is a cost effective system in terms of generating the…

Q: What do you understand by Safety factor, puncture and Flashover of Insulator

A: The part section of a pin type insulator is shown in  the figure below:

Q: State the functions of the components associated with the DOL starter

A: Explanation: The functions of the components associated with the DOL starter: Contactor and coil:…

Q: GGWP. A light conducting ring is placed on top of an iron core with a wire wrapped around it as…

A:

Q: What do you think is the main problem that might inhibit the widespread deployment of solar cells?…

A: A solar cell is an electrical device that is used to convert the sunlight energy into electrical…

Q: e density of carriers in the conduction and

A: NOTE- “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: write 4 points on working of nuclear power station

A:

Q: Compare dry-cells, alkaline batteries and nickel-cadmium, when it comes to improvements and…

A: Given data: dry cell Alkaline batteries Nickel-cadmium

Q: What is the purpose of conducting Open Circuit (OC) test? 2. What is the purpose of conducting…

A:

Q: Question: State the principle of reactance tube modulator?

A: It is asked to state the principle of a reactance tube modulator.

Q: Describe an Electrical circuit

A: An electrical circuit is a way in which electrical energy flows. The electrical circuit can be a…

Q: Which property of the material makes it suitable for the shielding process in electrical equipment.…

A: In the conductor, the electrical field present inside is totally 0. If it is wrong then a force will…

Q: State the function of insulator

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: A 2-wire d.c. distributor A B 500 metres long is fed from point A and is loaded as under : Distance…

A: Given values are =

Q: What is the relationship between the voltage and current in contact-probe measurements? 2. What…

A: 1. Among the most sensitive markers of changes in the type of chemical binding is electrical…

Q: 1-Identify and Explain with neat sketch of the a).Shackle Insulator   2-What do you understand by…

A: 1-a. Shackle Insulators These insulators are those insulators that are used whenever there is low…

Q: State two factors considered when selecting pv module site for domestic installation

A: The two factors that are considered when selecting a PV module site for domestic installation are:…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.