14 in. 18 in. В VB 1500 ft/s 18 in. A 0.05-lb bullet is fired into the side of a 20-lb square panel which is initially at rest. Determine a) the angular velocity of the panel immediately after the bullet becomes embedded and b) the impulsive reaction at A, assuming that the bullet becomes embedded in 0.0006 s.

14 in. 18 in. В VB 1500 ft/s 18 in. A 0.05-lb bullet is fired into the side of a 20-lb square panel which is initially at rest. Determine a) the angular velocity of the panel immediately after the bullet becomes embedded and b) the impulsive reaction at A, assuming that the bullet becomes embedded in 0.0006 s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 18-kg rear hatch of a vehicle opens as shown in the figure and can be modeled as a uniform 0.6-m long slender rod. Knowing that the tailgate is released from rest in the position shown in the figure, determine the angular velocity of the tailgate as it impacts the car body. I have attached Solution Too, You can Refer It( There Mass=16 kg) In our Problem Mass=18 Kg That is Only difference.
A 10-kg homogeneous sphere S is fastened to the end of the 20-kg homogeneous rod OA as shown. The 0.04-kg bullet B is fired with a horizontal velocity of 600 m/s. The bullet passes through the centre of the sphere and emerges with a hor- izontal velocity of 100 m/s to the right. If the rod and sphere were stationary be- fore impact, determine their angular velocity after the bullet passes completely through thesphere. Solve all questions using Impulse and Momentum methods
In the helicopter shown; a vertical tail propeller is used to pre- vent rotation of the cab as the speed of the main blades is changed. Assuming that the tail propeller is not operating determine the final angular velocity of the cab after the speed of the main blades has been changed from I80 to 240 rpm. (The speed of the main blades is measured relative to the cab, and the cab has a centroidal moment of inertia of 650 lb.ft.s2. Each of the four main blades is assumed to be a slender rod 14 ft weighing 55 lb.)
as the thin square plate hangs at rest from pin A, a bullet of a mass of 40.0 g is fired horizontally with an initial velocity, v_bullet,o = 350 m/s into the square plate as shown in Figure 2.1 (Position 1). d. what's the magnitude of the angular velocity of the plate after the impact. e. what's the magnitude of the velocity of the mass center of the plate after the impact? f. what's the magnitude of the angular velocity when the plate rotates in a clockwise direction by 90°as shown in Figure 2.2 (Position 2).
Draw the impulse-momentum diagram and line of action for e. Solve for the following: 1. Determine the angular velocity of the slender bar (B) immediately after impact. angular velocity of A = 57.1 rad/s since there is no external torque 2. Determine the linear velocities of both the sphere (A) and the slender bar (B) immediately after impact at their centroids ANSWERS I GOT BUT ARE INCORRECT: (the unit is given) angular velocity of the slender bar (B) immediately after impact: 8.089 rad/s , 18.49 rad/s linear velocity of the sphere (A) immediately after impact at the centroid: 0.485 rad/s^2, 0.16 rad/s^2, 2.11 rad/s^2 linear velocity of the slender bar (B) immediately after impact at the centroid: 0.485 rad/s^2, 0.49 rad/s^2, 2.21 rad/s^2
If it is determined in this problem that Ī_AB=3 kg∙m², which of the following best approximates the magnitude of the angular velocity ω of the bar immediately after the bullet becomes embedded in rad/s? a. 0.866 b. 0.465 c. 0.981 d. 0.686
Consider a slender rod AB with a length l and a mass m. The ends are connected to blocks of negligible mass sliding along horizontal and vertical tracks. If the rod is released with no initial velocity from a horizontal position as shown in Fig.A, determine its angular velocity after it has rotated through an angle of θ (see Fig B) using the conservation of energy method. (Hint: Moment of inertia of rod about G = (1/12)ml2 The kinetic energy of a rigid body in plane motion is
Determine the height h at which the bullet of Prob. 17.108 should be fired (a) if the disk is to roll without sliding immediately after impact, (b) if the disk is to slide without rolling immediately after impact.
A 5-m-long ladder has a mass of 15 kg and is placed against a house at an angle 0 = 20°. Knowing that the ladder is released from rest, determine the angular velocity of the ladder and the velocity of end A when 0 = 45°. Assume the ladder can slide freely on the horizontal ground and on the vertical wall.
1. When kicking a football, the kicker rotates his leg about the hip joint. (a) If the velocity of the tip of the kicker's shoe is 45.0 m/s and the hip joint is 1.05 m from the tip of the shoe, what is the shoe tip's angular velocity? (b) The shoe is in contact with the initially stationary 0.500 kg football for 20.0 millisecond. What average force is exerted on the football to give it a velocity of 20.0 m/s?
The uniform slender rod AB of weight 5 lb and length 30 in. forms an angle β = 30° with the vertical as it strikes the smooth corner shown with a vertical velocity v1 of magnitude 8 ft/s and no angular velocity. Assuming that the impact is perfectly plastic, determine the angular velocity of the rod immediately after the impact. Please include a clear diagram.
The 10-Ib sphere and 7-ib block (shown in section) are secured to the arm of negligible mass which rotates in the vertical plane about a horizontal axis at O. The 5-Ib plug is released from rest at A and falls into the recess in the block when the arm has reached thehorizontal position. An instant before engagement, the arm has an angular velocity wo = 1.2 rad/s. Determine the angular velocity w(positive if counterclockwise, negative if clockwise) of the arm immediately after the plug has wedged itself in the block.