19. Find the equivalent resistance. (Note: all resistors are 302) www

Q: Explain how transformers work.

A: Working principle of transformer: Transformer works on the Faraday law of electromagnetic induction…

Q: What is the value of gm1 needed to keep the noise figure of the mixer below 10 dB? Assume R₁=R₂=500…

A: Gm stands for trans-conductance. The term gain is frequently used to refer to the current to voltage…

Q: Find the Laplace of the function and also it's roc x(t)=u(t-to)

A:

Q: (c) Given a 50nF capacitor, calculate a suitable value of R to realise an RC LPF with a roll-off…

A:

Q: Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has…

A: i am giving answer of first subpart of this question.

Q: Find the current Ix if the voltage across the diode is 0.5V. The reverse saturation current of diode…

A: Given : The voltage across the diode: 0.5 V Cut in voltage of the diode: 0.6 V Reverse saturation…

Q: The maximum demand of a power station is 50 MW and the connected load is 100 MW. Average demand of…

A:

Q: A generator rated 100 MVA, 20 kV has X1=X2=20% and X0 =5% Its neutral is grounded through reactor of…

A:

Q: a - Design pesudo nMos 2 input NAND b-draw the stick diagram for your design

A:

Q: Consider the system defined by: a. O b. d. 8-618-00 2 3 X-6 0 The characteristic equation can be…

A: We need to find out characteristics equation for the given system

Q: Find the voltage Vo in the circuit. 4Ω 12 V - ΩΣ 8 Ω www + 8 ΩΣ "

A: We need to find output voltage for given circuit

Q: Q5: Find the maximum power transferred to the (452) resistor in the circuit shown below:

A: According to the question, for the given figure as shown below We need to calculate the maximum…

Q: kV A dielectric slab with 500 mm x 500 mm cross-section is 0.4 m long. The slab is subjected to a…

A:

Q: Assume R₁ =R₂=500 Q, y=2/3 and neglect of Cp. I/V Converter R₁ X LOHM₂ Current Switch "HI V² Ro X…

A:

Q: The state-space of a control system given a: 1 * = [_2_₁+₁ =[2] -2 -3. Design the state feedback…

A:

Q: A series RLC circuit having a resistance of 8 ohm, inductance of 50 mH and capacitance of 90 µF is…

A: We have been give an RLC circuit with, Resistance (R) = 8 Ω Inductor (L) = 50 mH = 50 * 10-3 H…

Q: The complete output controllable matrix for the following system: b. 11 a. [0402 0 40 20 1 0 31 0 1…

A:

Q: A 18600 W induction motor with six poles operates at 60Hz and shows a full-load slip of 6%: i) What…

A: Given: An induction motor has, Rated power, P0=18600 W Poles, P=6 Frequency, f=60 Hz Slip, s=6%=0.06…

Q: Calculate the 25 Ω inductor current using Norton's theorem. 80/60° j30 Ω 20Ω του 70Ω -j70 Ω (…

A:

Q: The absolute true error when approximating p = 1.000 by p*= 0.978 is 0.032 0.022 0.002 O 0.22

A: Given, Actual or true value, p*=0.978 Approximating value, p=1.000

Q: swer the following questions: State two advantages of the “orthogonal least square (OLS)' method in…

A:

Q: A child’s electronic toy is supplied by three 1.58-V alkaline cells having internal resistances of…

A: It is given that: Emf of alkaline cell,ε=1.58 VEmf of carbon-zinc dry cell,ε2=1.53 VResistance of…

Q: 1. A capacitor is formed by two concentric spherical shells of radius a and b that are held at…

A: Capacitor:Capacitor is having two opposite charged plates displaced at some distance in a dielectric…

Q: Question 17 Calculate the maximum current a 104 22, 1/3 watt resistor can have flowing through it…

A: Given, Resistance, R=104 Ω Power rating, P=13 watt

Q: 21. This circuit represents a model of a solar photovoltaic panel. Given that V₁ = 30V, R; = 2002…

A:

Q: For the waveform of current i shown in Figure 1.2, compute the total charge q transferred between

A: Given- For time t=0s to 3 s For time t= 0s to 9 s To find- Total charge transferred =?

Q: Example: 1.16 A moving coil instrument gives a full scale deflection of 10mA, when the potential…

A: It is given that: Full scale deflection=IFSD1=10 mA=10×10-3 APotential difference across its…

Q: x(t) = e 2¹u(t) + e¯³¹u(t)

A: The expression of the given function is  xt=e-2tut+e-3tut The Laplace transform of the given…

Q: Find the Laplace transform of x(t) = −e¯ªtu(−t) (1—)N„_Ə—

A: The expression of the given function is  xt=-e-atu-t The Laplace transform of the given function…

Q: 13. Find Re R₂ 2512 www 180 (2 www www 13 09: 13092

A:

Q: For Fig. 4.37, calculate the voltage gain. Given that: 8m = 4 mA/V, r = 45 ks2, RD = 20 k2, and R =…

A: We have an Circuit as shown in figure. Circuit uses an JFET. Given data, gm = 4 mA/V = 4 * 10-3 mA/V…

Q: e) Explain, with the help of annotated drawings, the definition and use of noise margins in logic…

A: The logic gates suffer various types of noise in their operation which can be of the following…

Q: A Multimeter is used to measure a) Only AC current b) Only DC voltage c) Both AC and DC quantities…

A: Given: A multimeter is used to measure _____.

Q: Find current | if V = 5V and -5V when VB = 2V, R₁ = 2K, R₂ = 4K and the diode is ideal.

A: Given- Voltage, V =5 V and - 5V VB = 2 V R1 = 2 kohm R2 = 4 kohm Diode is ideal To find- Current for…

Q: (II) Calculate the current through each resistor in Fig. 19–50if each resistance R=3.25 kΩ and V=…

A: The required parameters can be calculated by using the nodal analysis and the resistance reduction…

Q: Task Four: Hearing Aid Volume Control system The human ear reacts to various frequencies in a…

A:

Q: Q3: The following loads are connected to a common supply: Load A: 150 kVA at 0.707 power factor…

A:

Q: A 24.0 V battery is wired in parallel with three resistors, R1 10.0 Ohms, R2 - 60.0 Ohms, and R3 =…

A: The required parameters can be calculated by using the ohms law and current division rule.

Q: A 220 V, 1500 rpm, 10 A separately excited DC motor is fed from a single 292 phase fully controlled…

A: We have a separately excited DC motor which is fed from a single phase fully controlled rectifier…

Q: 2. Write the simplified Boolean expression for the following K-map. WX 00 01 11 YZ 10 00 1 0 0 01 11…

A: Given K-map,

Q: Question No.35 and are called as universal gates.

A: There are many kinds of logic gates. AND OR NAND NOR NOT X-OR X-NOR

Q: Capacitance per unit area at no reverse bias is two pF/cm². For a step graded diode of area 5cm²,…

A:

Q: 22. Consider the Wheatstone bridge given a. Calculate V, VI, and Val b. Rework part (a) if the…

A: We need to find out the voltage for given circuit

Q: Q24 (6) A shunt motor supplied at 230 V DC runs at 900 RPM when the armature current is 30 A. The…

A: Given data, Terminal voltage V = 230 V In first case, Armature current Ia1=30 A Speed N1=900 RPM…

Q: 3. An airplane, whose total mass is 50,000 metric tons, reaches a height of 32,808 feet in 20…

A:

Q: Consider the RLC circuit with R = 3 2, L = } H, C = { F, and E(1) = 2 cos ot V. Determine the cur-…

A: Given data: R=3ΩL=12HC=13FE(t)=2 cosωt

Q: Capacitance per unit area at no reverse bias is two pF/cm². For a step graded diode of area 5cm²,…

A: According to the question, it is given that Capacitance = 2pF/cm2 Area = 5cm² Reverse bias voltage =…

Q: d) Describe the schematic and operation of a Serial-Input, Parallel-Output shift register.

A: Shift Register: Shift register are used to shift binary data in series in data to parallel output,…

Q: For the op-amp circuit of Fig. 6.22, determine V V V and also power supplied/absorbed by Vp₁ the 4 V…

A: We have an operational amplifier circuit as shown above, The value of resistance are as mentioned ,…

Q: A 480 V single-phase AC motor is rated at 10 kW and operates at a power factor of 0.85 (lagging),…

A: I am attaching detailed solution image of this question.

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.