2-10. The soaking bin contains ethyl alcohol used for cleaning automobile parts. Suction pump C is to vary the pressure of the trapped air in enclosure B. If the pressure in the trapped air is Ps = -5.50 kPa, determine the pressure developed at point A and the height h of the ethyl alcohol level in the bin. Take pa = 789 kg/m². B 25 m h 0.5 m

2-10. The soaking bin contains ethyl alcohol used for cleaning automobile parts. Suction pump C is to vary the pressure of the trapped air in enclosure B. If the pressure in the trapped air is Ps = -5.50 kPa, determine the pressure developed at point A and the height h of the ethyl alcohol level in the bin. Take pa = 789 kg/m². B 25 m h 0.5 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

an open circular vessel is 1m in diameter and 2m height. it contains water filled to a depth of 1.5m. if the cylinder rotates about its vertical axis, what is the pressure intensity at the corner of the bottom if w= 6 radians/second Unit of the correct answer: kPa
With the chamber-pipe system in the figure, the ideal fluid (water) taken from the infinitely sized chamber A is poured into the atmosphere with a 40 cm fixed diameter BCDEF pipe. Since zB=29, zC=10, zD=28.5, zE=5 and zF=28 meters according to the comparison plane;a) Calculate the flow of the system.b) Draw the relative load (energy) and piezometer lines of the system.c) Determine where the greatest pressure will be observed throughout the system and calculate its relative value.
The container is partially filled with oil. Water and air as shown. Determine the pressure at A, B and C assuming Pwater=1000kg/m^3 and Poil=830 kg/m^3
Water at 15°C (? = 999.1 kg/m3 and ? = 1.138 × 10−3 kg/m·s) is flowing steadily in a 30-m-long and 6-cm-diameter horizontal pipe made of stainless steel at a rate of 10 L/s. Determine (a) the pressure drop, (b) the head loss, and (c) the pumping power requirement to overcome this pressure drop.
A 4.1 m diameter tank having equal layers of water, oil(SG=0.87), and another liquid with SG=1.74, with each layer is 0.84 m in height is being observed. Find the gage pressure(in kPa) at the bottom of the oil layer.
A cylindrical tank 1 m diameter and 3 meter high contains 1m of water, 1.2 m of oil (SG=0.8) and air under a pressure of 15 kPa. Find the discharge through a 5 cm diameter orifice 30 cm above the bottom of the tank, if c=0.61
An 83-mm-diameter siphon is drawing oil (SG = 0.85) from an oil reservoir, as shown in the figure. If the velocity of flow in the pipe is 'v', the head loss from point 1 to point 2 is 6v2/2g, and the head loss from point 2 to point 3 is 2v2/2g. Find the absolute pressure (in kPa) at point 2. Use atmospheric pressure, Patm = 102 kPa. Use y1 = 5 m., and y2 = 7 m.
1. A pipe has a slope of 1 in 100 and its length is 300 meters. Its diameter is 0.6 meter at the lower end while 1.2 meters at the higher end. The rate of flow through pipe is 5400 liters/min. Find the pressure at the lower end if the pressure at higher end is 68.07 kPa. Neglect losses.
A tank contains gasoline sp. gr. = 0.90, oil sp. gr. = 0.8, and seawater sp.gr. = 1.03. If the depths of the liquids are 0.5 m. for oil, 0.6 m. gasoline, 1 mseawater. respectively. Find the pressure IN kPa at a depth of 1.4 m. Use 3decimal places.
5.10 The water is supplied at the rate of 3 m3 per minute from a height of 4 m to a hydraulic ram, which raises 0.3 m3/minute to a height of 30 m from the ram. The length and diameter of the delivery pipe is 100 m and 70 mm respectively. Determine the D' Aubuisson's efficiency of the hydraulic ram if the co-efficiency of friction f = .009.
1. An orifice in the side of a vertical tank discharges oil (sp. gr. = 0.82) under a head of 4.0 m. and 25 KPa pressure acting on the surface of the oil. If the diameter of the orifice is 5 cm, the coefficient of contraction is 0.62, and the head lost on the orifice is 45 cm, determine the discharge, coefficient of velocity, and the coefficient of discharge.
A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev. 15m). The head loss from the reservoir (point 1) to the summit (point 2, elev. 22m) is 2.5 times the velocity head in the siphon and head loss from the summit to the discharge end is 4 times the velocity head in the siphon. What is the absolutepressure at the summit (point 2) assuming the atmospheric pressure to be 101.3 kPa?