2- A 12 ft length of steel pipe is held aloft by a crane, as shown. Determine the tension on the cable sliding ACB if the pipe weights 600 lb and the cable length is 16 ft. ( it is a common practice to attached the crane hook at mid-point between A and B. in practice sliding is prohibited.). 600 Ib -12 ft-

2- A 12 ft length of steel pipe is held aloft by a crane, as shown. Determine the tension on the cable sliding ACB if the pipe weights 600 lb and the cable length is 16 ft. ( it is a common practice to attached the crane hook at mid-point between A and B. in practice sliding is prohibited.). 600 Ib -12 ft-

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.65P: Cable AB supports the uniformly distributed load of 4 kN/m. If the slope of the cable at A is zero,...

See similar textbooks

Similar questions

Cable AB supports the uniformly distributed load of 4 kN/m. If the slope of the cable at A is zero, compute (a) the maximum tensile force in the cable; and (b) the length of the cable.
Bar AB of negligible weight is supported by a ball-and-socket joint at B and two cables attached at A. Draw the FBD for the bar, recognizing that it is a two-force body. Determine the number of unknowns.
The bar ABC is supported by three identical, ideal springs. Note that the springs are always vertical because the collars to which they are attached are free to slide on the horizontal rail. Find the angle at equilibrium if W = kL. Neglect the weight of the bar.
Physics Use the figure to determine the tension (inpounds) in each cable supporting the load.
A horizontal board weighing Wb = 600 N is hinged to a vertical wall. A personweighing Wp = 400 N stands at the end of the board 5 m from the wall. A rope is attached to theboard at a point 3 m from the wall and makes an angle of θ = 40° with theboard. Determine the tension (T) in the rope
A boom hinged at the base of a vertical mast is used to lift a 2000 lb load. Find the tension in the cable and the reaction R at the end of the boom. The angle of the boom is 40 degrees with the horizontal and the cable is 60 degrees with the vertical mast. Pls include given, formula, fbd, and solution.
For the weight and tension in the figure shown, find T1, T2 and T3. Put the final answers for each tension.
The pulley system below is in static equilibrium, where load W3 is 730 N, angle α = 50O and angle θ = 30O. Determine the value of loads W1 and W2, then calculate the ratio of (W1/W2). Give your answer as a ratio of (W1/W2) to two decimal places.
2. Forces (Figures Needed) 2.2. A load of 100 lbf hung from the middle of a rope, which is stretched between tworigid walls 30ft apart. Due to the load, the rope sags 4ft in the middle. Determinethe tension in the rope. 1 Free-body Diagram only
Find the tension in each of the supporting cables in the figure when the weight of the crate is 500 newtons.
A uniform bar 3.00 m long is held by ropes at the ends making angle 60.0 and 30.0,respectively, with the horizontal. A weight of 200 N is hung 0.500 m from the leftend where the 60.0 rope is attached. Find the tension in the ropes (T1 & T2) andthe weight (W) of the bar
The simplest truss consists of two rods and is loaded by the block. Given: block weight Q = 9,4 kN. Angle α = 31 degrees. Find: the algebraic (positive or negative) value (in kN) of normal force N1 in the rod 1, considering that N1>0 for tension and N1<0 for compression.