2) Aşagıdaki voltajlar ve empedans per-unit cinsinden verilmistir. a) Buna gore Ybus'i bulunuz? ell j1.00 j0.4 mo j0.5 rele 1.1020⁰ 70.25 (2 j0.2 m j0.125 j0.5 moo + mo -CHUPUI ..... ell presi j1.25 HOUS MOI +0.902-30° uzr

2) Aşagıdaki voltajlar ve empedans per-unit cinsinden verilmistir. a) Buna gore Ybus'i bulunuz? ell j1.00 j0.4 mo j0.5 rele 1.1020⁰ 70.25 (2 j0.2 m j0.125 j0.5 moo + mo -CHUPUI ..... ell presi j1.25 HOUS MOI +0.902-30° uzr

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: the resistance

Q: 5 Find the average power delivered to the 3- resistor in the circuit shown in Fig. 11-12. 10 0° 4 *…

Q: 5. Please refer to the parallel-based clipper circuit shown below for this problem. For simplicity,…

A: Given: Required: (a) Plot the output V0(t) for 0≤t≤T (b) Plot the voltage…

Q: Q2:- Determine the value of voltage (V1) in figure (2-31)by using voltage divider rule. 64 V- 20 Ω…

A: Given data, Vin=64V R1=20ohm R2=60ohm

Q: The response of the system is given by Y(s) = Find the final value of the system output. (5+3)(5+4)…

A: Given data, Transfer function, Ys=s+3s+4ss+22s+1

Q: Two identical synchronous machines having same inertia constant are connected in parallel and…

A: Given: Two identical synchronous machines having same inertia constant are connected in parallel and…

Q: What is tungsten,CFL,led bulb... Which one save electricity and why ?

A: Please find your answer below.

Q: A series RLC circuit with L=160 mH, C= 100 micro F and R=40 ohm is connected to a sinusoidal voltage…

Q: What are rotor faults in alternators

A: The rotor of an alternator is directly connected with field winding of the alternator whenever there…

Q: Determine the power output of a DC armature having 1152 lap connected conductors carrying 150 A and…

Q: 1 5v T Voltage Voltage 2 V Resistor 1: 47-2 Resistor 2 = 68 Resistor 3 = 39 Current I = ? Current 2…

Q: 9. If the output voltage of an amplifier is 1.2 V rms and its voltage gain is 50, what is the rms…

A: Given: Output voltage, V0=1.2 V Voltage gain, Av=50

Q: * E B A F Find any Hamiltonian circuit on the graph above. Give your answer as a list of vertices,…

Q: In an attempt to boost DC voltage, two students thought of using a transformer to accomplish such…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Calculate the losses in the machine and its efficiency if the power input is 18,000 watts, under…

A: To find the losses in the machine and it's efficiency Given : power input = 18000 watts And output…

Q: Problem 15. A source of e.m.f. of 15 V supplies a current of 2A for six minutes. How much energy is…

A: In this question we will find energy provided by source ...

Q: Question 1 Match the description with the (non-ideal) filter type. Here, P refers to a passband…

A: Filter: It is a circuit that attenuates some signal and passes the other signal. It reduces the…

Q: Design a bandpass filter with a lower cutoff frequency of 26.1 kHz and an upper cutoff frequency of…

A: To design a Bandpass filter with lower cutoff frequency fL = 26.1 KHz and Higher cutoff frequency fH…

Q: Determine X(S) expressed as a rational polynomial with simplified numerator and factored denominator…

Q: What will be the value of R1 with the given RTL code XOR , where R1 is 1011 0110, R2 is 1100 0111

A: Given that in RTL code R1 is stored as R1 = 1011 0110 and R2 = 1100 0111 And the operation is XOR…

Q: 7- Define the term OFDM?

A: Given: OFDM

Q: What is the frequency of oscillation for RC phase shift oscillator with R = 10 kn and C= 0.001 µF in…

A: Given, A RC phase shift oscillator with each resistor and capacitor has R=10 kΩC=0.001 μF

Q: Use mesh-current analysis to solve i1,i2 and i3. 70 V + 20 Ω 14 Ω Μ Το 10 Ω 12 Ω Μ 12 + 42 V

A: Given circuit,

Q: -/ 1 Question 10 of 25 View Policies Current Attempt in Progress A square wire loop with 2.3 m…

A: Given data : The magnetic field B=0.035-0.84t The battery EMF E=16V Length of square L=2.3m

Q: 2. a) Give a formulation of the Nyquist criterion for stability in both cases, when the open- loop…

Q: A stationary closed Lissajous pattern on an oscilloscope has 3 horizontal tangencies and 2 vertical…

A: Given data, Number of horizontal tangencies Nh=3 Number of vertical tangencies Ny=2 Horizontal input…

Q: An integrated circuit is .. A. A complicated circuit B. An integrating device C. Much costlier than…

A: Integrated circuit is also called microchip or chip. It is kind of wafer that has millions of…

Q: what is variac? isadvantages please

A: An autotransformer is mostly used to modify line voltages in order to either change or maintain…

Q: A negative voltage feedback amplifier has voltage gain without feedback, A, = 1000 and feedback…

A: Given, A negative voltage feedback amplifier has, Voltage gain without feedback, Av=1000 Feedback…

Q: 2.18. Find Vout in the following circuit: 10 ΚΩ www + 5 V 15 V 40 ΚΩ Vout

A: Given,

Q: 7. What is the voltage at 2nd terminal in the given circuit? 135V + 2002 100 2 500 → 5A

A: Given circuit,

Q: A power station has a maximum demand of 2500 kW and number of kWh generated per year is 45 x 105.…

A: Given a power station with, Maximum demand = 2500 kW Number of kWh generated per year = 45×105

Q: Nyquist plot is it 2k/3 or 4k/3

Q: Vamp R Vout Figure 2: RLC circuit in a speaker system. rcuit has an input AC voltage with amplitude…

Q: A modulating signal given by m(t) = 5 sin[4 x 10³t 10 π cos(2π × 10³t)] V s fed to a phase modulator…

A: Phase modulated signal is given as xpt=Acosωct+kpxt Where, x(t) is the modulating…

Q: 5. How many electrons will pass through a conductor in 4 minutes and 30 seconds if the current is 45…

A: Given, Time, t=4 min 30 sec Current, I=450 mA

Q: Q1:- Determine the value of voltage across each resistance of the circuit in figure (2-30). 20 V= 10…

Q: List various kinds of faults that may occur in an alternator

A: There are two types of faults occuring in an alternator. These are A) Internal faults B) External…

Q: A potential barrier is 5.00 eV high and 0.900 nm wide. Find the probability that an electron will…

A: The probability that an electron will tunnel through the barrier is given by the expression as shown…

Q: wwww wwww Fig. 40.17 If in Fig. 40.17, R = 220 k2, and C= 500 pF, what will be the frequency of…

A: Given, A phase shift oscillator employing the network Where, Resistance, R=220 kΩ Capacitance,…

Q: I, 60/0° V +1 j15 Ω j100 Ω m j50 Ω j0 Ω ell 80 Ω j 10 Ω 40 Ω-j20 Ω ww j80 Ω +1 1, 20/90° V Find 11,…

A: Detailed solution is attached with the notes.please go through and follow up in case of queries.…

Q: arious possible impulse respons sidering the stability and causa

A: Given as,

Q: x [n] 5-4-3 -4-3-2 3 2 1 -2 U (a) 12 9.2. The discrete-time signals in Figure P9.2 are zero except…

Q: Sketch the root locus diagram for a unity feedback system G(s) = K(s+3)/s(s2+2s+2) (s+5)(s+9). Thus…

Q: Vo= 1 + 2R RR) (V₁ – V₂) = k(V₁ – V₂) Rp

Q: What are the Various type of faults in transformer

A: There are various type of faults in transformer which is given below- Overheating Overheating is…

Q: The simplified form of the Boolean expression Y = (ĀBC + D) (ĀD + BC) can be written as? ĀD + BCD

A: Given expression, Y=A¯BC+DA¯D+B¯ C¯

Q: What are the different type of air blast circuit breaker explain

A: There are three types of compressed air circuit breakers: axial flow, radial flow, and cross flow,…

Q: The response of a second order system when subjected to a step input is shown in Figure Q2. Use,…

Q: Discuss the significance current limiting reactor in power system

A: A current limiting reactor consists of a large inductance compared to its ohmic resistance

Question

100%

What is the Ybus ? voltages and impedances are given per-unit.

2) Aşagıdaki voltajlar ve empedans per-unit cinsinden verilmistir.
a) Buna gore Ybus'i bulunuz?
b)
ell
j1.00
@
j0.4
moo
10.5
rele
1.1020⁰
70.25
j0.125
j0.5
mt mon
(4)
0
j0.2
m
-COUPOI
5
ell
j1.25
-US
MOI
+0.90/-30°
uz?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incremental fuel costs in dollars per megawatthour for a plant consisting of two units are given by:dC(P)/dP = 0.0080 P1 + 8.0dC(P)/dP = 0.0096 P2 + 6.4Assume that both units are operating at all times, that total load varies from 250 to 1250 MW, and that maximum and minimum loads on each unit are to be 625MW and 100MW respectively. Find the incremental fuel cost and the allocation of load between units for the minimum cost of various total loads.Write your answers in the given format below.
Suppose a power system consists of two isolated regions: a western region and an eastern region. Five units have been committed to supply 3090 MW as shown below. The two systems are separated by a transmission line that can handle a maximum transfer of 550 MW in either direction. If losses are ignored, calculate the spinning reserve for the overall system and for each region. Comment on the adequacy of the spinning reserve of the overall system, and for each region. (consider the effect on the power supply in each of the regions if the various generators fail). Repeat the above calculations and analysis if an average of 8% of the output of the generators is lost in the transmission and distribution system before reaching the load.
Write factors that affecting the output power of wind turbine.
For a Natural Gas based Power Generation unit, which of the following cannot be an input quantity for plotting input-Ouiput characteristics? a. m^3 /h b. $/m^3 C. MBtu /h d. $/h
1) Explain the advantages of using per-unit in power system 2) Explain how, it was useful in Question1 and Question 2
Motor units all tend to be homogenous (similar) with resect to the amount of force they produce. a.) True b.) False
The yearly duration curve of a certain plant can be considered as a straight line from 300 MW to 80 MW. Power is supplied with one generating unit of 200 MW capacity and two units of 100 MW capacities each. Determine: Installed Capacity, Load Factor, Plant Factor, Maximum Demand and Utilization Factor.
Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
a. What is the unit load per ft2 for the general lighting load of a residence? ____ b. What are the demand factors for the general lighting load in dwellings? ____
(a) Give the condition for the loss of load in a power generation system in terms of outages in generation units (b) Give the assumption taken for the calculation of LOLP? [Write relevant Answers in 1 or 2 sentences in each part)
Unit commitment if the spinnind reserve not there in the power system what will happen?
Discuss the principles of electricity market operations, including spot markets, forward markets, and the role of independent system operators (ISOs).