5 Find the average power delivered to the 3- resistor in the circuit shown in Fig. 11-12. 10 0° 4 * 13 0 m 130 -185 -1302 30 120

Q: The number of turns in the secondary coil of a 22 kVA, 2200V/220V single-phase  transformer is 50.…

A: It is given that:S=22 kVAV1=2200 VV2=220 VN2=50

Q: Given that x(t) = u(t) + u(-t) + t3 - cos (2t), show that x(t) is asymmetric and then determine the…

A: Given: xt=ut+u-t+t3-cos2t Required: Show that xt is asymmetric or odd and then find the symmetric…

Q: QUESTIONS (a) Figure Q.1 (a) represents a common emitter amplifier. Given ß-100, VON-0.7V, Vaq-1.7…

A:

Q: Write the expression “G. Boole” in ASCII, using an eight-bit code. Include the period and the space.…

A: Given: Treat the leftmost bit of each character as a parity bit. Each eight-bit code should have odd…

Q: Q5: Determine H at point P(0,1,0) in the field of 10A filamentary current which is directed from…

A: Magnetic field intensity (H):-It is produced by the flow of current through wire. It's SI unit is…

Q: The blood pressure is 80 mmHg diastolic and 120 mmHg systolic which equal to: O 10.640 kPa and…

A:

Q: A 25 KVA transformer supplies a load of 12 kW with a power factor of 0.6 lagging. Find the…

A: Transformer: The transformer works in the principle of electromagnetic induction. The transformer…

Q: 4.) A balanced Y-Y circuit is shown in Figure 3. Find the average power delivered to the load.

A:

Q: Cwi = 120 pF Cwo 10 pF Cbe = 40 pF Cbc = 10pF = 14pF Cce == 1. 5 ΚΩ 15 V www 4.7kΩ B = 100 1 μF - 4…

A: For the above given common base amplifier we need to derive all the AC parameters.

Q: QUESTIONS (a) Figure Q.1 (a) represents a common emitter amplifier. Given B-100, Ves(ON) -0.7V,…

A: The circuit diagram of common emitter amplifier is shown below, Where,β=100VBEon=0.7 VVBQ=1.7…

Q: A rural electric line supplies power to two industries by means of step-down transformers. Both…

A: Given as,       Transformer will be a static device that transfer electric energy from one circuit…

Q: 17. The atomic mass of iron, Fe, is 55.9349 u and the mass of Hydrogen, mH =1.007825 u and the mass…

A: It is given that: Number of protons=Z=26Mass of proton=mp=1.007825Number of neutrons=N=56-26=30Mass…

Q: Use the Mash analysis

A: The given circuit diagram is shown below:

Q: (b) For maximum output, the Q-point must be: 1. Near saturation. 2. Near cut-off. 3. midpoint…

A: 1) If Q-point is near to saturation then +ve clipping of input signal. So no maximum output.    2)…

Q: Ifa material is having a band gap of 1.42eV, then this material will produce a photon output at the…

A: Given, Material having bandgap, EeV=1.41 eV Photon output at the wavelength, λ=?

Q: In the network below, find the power associated to the current source, for V1 = 12 V. V1 + 24 +41 2…

A: Given, The circuit is, V1=12 V

Q: A balanced star load with impedances of 6∟45o ohms is connected to a three-phase, four-wire, 208…

A: Given data, Load impedance Zph=6∠450 Ω Line voltage, VL=208 V

Q: A 1-uC charge is located on each of the four corners of a square whose side measures 10 cm. What is…

A:

Q: A PN flip-flop has four operations: clear to 0, no change, complement, and set to 1, when inputs P…

A: A electronic device which has  stores a single bit (binary digit) of data know as a flip-flop.…

Q: Figure 2.1 shows the Asynchronous J-K flip flop and it truth table. Draw an output waveform, Q by…

A:

Q: EXAMPLE To illustrate calculations with the unit impulse function, consider evaluation of the…

A: NOTE:   As per our company guidelines we are supposed to answer only first 3️sub-parts. Kindly…

Q: (a) What is the resistance of a 220-V AC short circuit that generates a peak power of 96.8 kW? (b)…

A:

Q: Find the equivalent inductance between terminals A and B in the following figure. Assume no mutual…

A: If three inductors of inductance L are connected in parallel then equivalent inductance is L/3. If…

Q: Find the Thevenin equivalent (VTH and RTH) between terminals A and B of the circuit given below. R1…

A: Thevenin’s Theorem- Thevenin’s theorem states that it is possible to simplify any linear circuit,…

Q: blackboard.ncat.edu Remaining Time: 1 hour, 17 minutes, 25 seconds. A Moving to the next question *…

A: The given circuit diagram is shown below:

Q: For the network shown, determine Z; if loss = 12 mA, Yos = 40

A: here network is given that can be converted to small signal AC network for finding the Zin as

Q: Design a bandpass filter with a lower cutoff frequency of 26.1 kHz and an upper cutoff frequency of…

A: To design a Bandpass filter with lower cutoff frequency fL = 26.1 KHz and Higher cutoff frequency fH…

Q: How would I calculate capacitance of this? C1 C2 ㅔㅔ ㅔ C3 C4 H ㅏ

A:

Q: Name: (11) The supply voltage VCC equals 9V. The base resistor Rais 42. Take 0.6V for the knee…

A: For the given NPN transistor circuit we need to calculate collector resistance, collector current…

Q: ind the current through the diode in the folowing circuits. assume the diode to be ideal.v=10, R1

A: Given circuit:

Q: What is the pressure on a swimmer 10 m below the surface of a lake (density of water is 1000 kg/m3)…

A: Given data, Height h=10 m Density ρ=1000 kg/m3 Acceleration due to gravity, g=9.8 m/s2

Q: Select one: a. None of the answers O b. 2 diodes are reversely biased O c. the 10K resistor can not…

A:

Q: A rectangular waveguide is terminated with an unknown load. By using a slotted line, load VSWR is…

A: VSWR : VSWR stands for voltage standing wave ratio is directly proportional to reflection…

Q: A resistance R, capacitance C, and inductance L are connected in series to a voltage source with…

A: Note: As per the policy we can solve only 3 sub parts of a question, please re-upload the remaining…

Q: A 25 KVA transformer supplies a load of 12 KW at a power factor of 0.6 lagging. Find the percentage…

A: A 25 KVA transformer supplies a load of 12 KW at a power factor of 0.6 lagging. S=25 KVAP=12…

Q: Consider the following system, when G(s) = 1 s²+bs+24 R(s) + E(s) O a. 15.1 b. 2.3 c. 99.5 Od. 10.6…

A: Given data : Gs=1s2+bs+24 The settling time ts=1.8sec The overshoot is Mp=37.2%

Q: 3. Use figure 2 for answering questions a-f. a) b) c) d) 115 V rms 60 Hz Vpis 10:1 eeeee 00000 Dis…

A: For the given figure answer the following question: PIV for each diode. Average output Voltage,…

Q: Find the currents I0

A:

Q: What type is active filter shown

A: An active filter is a type of analog circuit that uses active components, typically an amplifier, to…

Q: Q4 - 3-phase, 6 pole, 400V 50Hz, I.M, has the stand still impedance of (0.04 + j 0.44) ohm/phase and…

A: Induction Motor: Relative slip is defined as the difference between synchronous speed to motor rotor…

Q: balanced delta connected load has one phase current Ibc=2 angle -90 degree A.  Find the other phase…

A:

Q: Determine the rms value for the waveform elin ( -9 ДЛД 0.1 0.2 0.3 0.4 0.5 r(s) -0.3 -0.2 -0.1

A:

Q: The filter cake will increase with time, as more solids build up on the filter thus acting as the…

A: The filter cake will increase with time, as more solids build up on the filter thus acting as the…

Q: A voltage divider amplifier shown in Figure 3 has an output current Ic = 4 mA. Based on the circuit…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: Q1-write the following quantities by using power of ten :- • 29000kw 7000Ω • 0.0003ms • 0.05A •…

A:

Q: The intrinsic carrier concentration of silicon sample of 300 K is 1.5x10¹6/m³. If after doping, the…

A: Given: The intrinsic carrier concentration, ni2=1.5×1016m3 After doping the number of majority…

Q: ww R₁ 1.0kQ R, 3.0kQ www R₂ 1.5kQ

A: Kirchoff's current law states that total incoming current at the junction is equal to total Outgoing…

Q: Write and verify: A behavioral HDL model of the BCD ripple counter described in Problem 6.13.

A: BCD ripple counter:- It is digital serial counter which counts ten digits. It is reset for the every…

Q: An AM transmitter uses high-level modulation of the final RF power amplifier, which has a dc supply…

A: Given data, Supply voltage Vcc=36 V Current I = 2.8 A Efficiency η=77%

Q: Consider the circuit below with i(t) = 80 cos(50t) mA for t> 0 and i(t) = 0 for t < 0. L1= 60 mH, L2…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.