2. A compound thin cylinder has a common diameter of 100 mm, and the inner cylinder has a thickness of 2,5 mm. The radial pressure between the two cylinders is 200 kPa and the difference between the two common diameters before shrinkage was 4,305x 10-3 mm. E = 200 GPa. Determine a. Thickness of the outer cylinder b. Resultant hoop stresses in both cylinders if the compound cylinder is subjected to an internal pressure of 180 kPa.

2. A compound thin cylinder has a common diameter of 100 mm, and the inner cylinder has a thickness of 2,5 mm. The radial pressure between the two cylinders is 200 kPa and the difference between the two common diameters before shrinkage was 4,305x 10-3 mm. E = 200 GPa. Determine a. Thickness of the outer cylinder b. Resultant hoop stresses in both cylinders if the compound cylinder is subjected to an internal pressure of 180 kPa.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

When a thin cylinder is subjected to an internal pressure p, the tangential stress should be the criterion for determining the cylinder wall thickness. Explain.
A steel rod whose ends are restrained is placed in a structure when the temperature is 80 F (degrees Fahrenheit). If the modulus of elasticity is taken as 29,000,000 psi, what unit stress is produced in the rod due to shrinkage when the temperature is 43 degrees F? A. 6970 psi B. 8100 psi C. 15,080 psi D.18,850 psi
Determine the young modulus and the poisson's ratio of this steel.
The figure below shows a rectangular OB element made of 0.5 cm thick aluminum sheet, attached to the ground at one end and supported by a coil spring at point A. The spring was measured with a force of 10 kN, a 1 mm shrinkage. Find bending at point B using the Castigliano method.
What are principal stresses?
How can the theory be applied to find the maximum allowable shear stress for thick walled cylinders?
Where can the complex stress distributions arise?
What are the principal stresses? How can they be determined?
The femur, the long bone in the thigh, can be modeled as a tube of compact bone for most of its length. The cross-section area of the compact bone in the femur of a 70 kg person is 4.8 x 10-4 m2, a typical value.a. If this person supports his entire weight on one leg, what fraction of the tensile strength of the bone does this stress represent?b. By what fraction of its length does the femur shorten?
The assembly shown consists of an aluminum shell (Ea = 70 GPa, αa = 23.6 × 10−6/°C) fully bonded to a steel core (Es = 200 GPa, αs = 11.7 × 10−6/°C) and the assembly is unstressed at a temperature of 20°C. Considering only axial deformations, determine the stress in the aluminum when the temperature reaches 185°C. The stress in the aluminum is − _____ MPa.
Figure 6.23 shows the tensile engineering stress– strain curve in the elastic region for a gray cast iron. Determine (a) the tangent modulus at 25 MPa (3625 psi) and (b) the secant modulus taken to 35 MPa (5000 psi).
A steel beam is used in the roadbed of a bridge. The beam is mounted between two concrete supports when the temperature is 23 °C, with no room provided for thermal expansion. What compressional stress must the concrete supports apply to each end of the beam, if they are to keep the beam from expanding when the temperature rises to 42 °C? Assume that the distance between the concrete supports does not change as the temperature rises.