2. An electron, released in a region where the electric field is uniform, is observed to have an acceleration of 3.00 x 10^14 m/s^2 in the positive x direction. Determine the electric field producing this acceleration. Assuming the electron is released from rest, determine the time required for it to reach a speed of 11,200 m/s, the escape speed from the earth's surface.

2. An electron, released in a region where the electric field is uniform, is observed to have an acceleration of 3.00 x 10^14 m/s^2 in the positive x direction. Determine the electric field producing this acceleration. Assuming the electron is released from rest, determine the time required for it to reach a speed of 11,200 m/s, the escape speed from the earth's surface.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter7: Electric Potential

Section: Chapter Questions

Problem 41P: An electron is to be accelerated in a uniform electric field having a strength of 2.00106 V/m. (a)...

See similar textbooks

Similar questions

An electron is to be accelerated in a uniform electric field having a strength of 2.00106 V/m. (a) What energy in keV is given to the electron if it is accelerated through 0.400 m? (b) Over what distance would it have to be accelerated to increase its energy by 50.0 GeV?
A doubly charged ion is accelerated to an energy of 32.0 keV by the electric field between two parallel conducting plates separated by 2.00 cm. What is the electric field strength between the plates?
A simple and common technique for accelerating electrons is shown in Figure 18.55, where there is a uniform electric field between two plates. Electrons are released, usually from a hot filament, near the negative plate, and there is a small hole in the positive plate that allows the electrons to continue moving. (a) Calculate the acceleration of the electorn if the field strength is 2.50104 N/C. (b) Explain why the electron will not be pulled back to the positive plate once it moves through the hole.
An evacuated tube uses an accelerating voltage of 40 kV to accelerate electrons to hit a copper plate and produce x rays. Non-relativistically, what would be the maximum speed of these electrons?
You are working on a research project in which you must control the direction of travel of electrons using deflection plates. You have devised the apparatus shown in Figure P22.28. The plates are of length = 0.500 m and are separated by a distance d = 3.00 cm. Electrons are fired at vi = 5.00 106 m/s into a uniform electric field from the left edge of the lower, positive plate, aimed directly at the right edge of the upper, negative plate. Therefore, if there is no electric field between the plates, the electrons will follow the broken line in the figure. With an electric field existing between the plates, the electrons will follow a curved path, bending downward. You need to determine (a) the range of angles over which the electron can leave the apparatus and (b) the electric field required to give the maximum possible deviation angle. Figure P22.28
Lightning can be studied with a Van de Graaff generator, which consists of a spherical dome on which charge is continuously deposited by a moving belt. Charge can be added until the electric field at the surface of the dome becomes equal to the dielectric strength of air. Any more charge leaks off in sparks as shown in Figure P25.52. Assume the dome has a diameter of 30.0 cm and is surrounded by dry air with a "breakdown" electric field of 3.00 106 V/m. (a) What is the maximum potential of the dome? (b) What is the maximum charge on the dome?
Review. From a large distance away, a particle of mass m1, and positive charge q1 is fired at speed in the positive x direction straight toward a second particle, originally stationary but free to move, with mass m2, and positive charge q2. Both particles are constrained to move only along the x axis. (a) At the instant of closest approach, both particles will be moving at the same velocity. Find this velocity, (b) Find the distance of closest approach. After the interaction, the particles will move far apart again. At this time, find the velocity of (c) the particle of mass m1, and (d) the particle of mass m2.
A certain five cent coin contains 5.00 g of nickel. What fraction of the nickel atoms’ electrons, removed and placed 1.00 m above it, would support the weight of this coin? The atomic mass of nickel is 53.7, and each nickel atom contains 28 electrons and 28 protons
Integrated Concepts An electron has an initial velocity of 5.00106m/s in a uniform 2.00105N/C strength electric field. the field accelerates the electron in the direction opposite to its initial velocity. (a) What is the direction of the electric field? (b) How far does the electron travel before coming to rest? (c) How long does it take the electron to come to rest? (d) What is the electron’s velocity when it returns to its starting point?
A charged particle moves through a velocity selector at constant velocity. In tire selector, E=1.0104NC and B = 0.250 T. When the electric field is turned off, tire charged particle travels in a circular path of radius 3.33 mm. Determine the charge-to-mass ratio of the particle.
The planetary model of the atom pictures electrons orbiting the atomic nucleus much as planets orbit the Sun. In this model you can view hydrogen, the simplest atom, as having a single electron in a circular orbit 1.061010 m in diameter. (a) If the average speed of the electron in this orbit is known to be 2.20106 m/s, calculate the number of revolutions per second it makes about the nucleus. (b) What is the electron's average velocity?
A simple and common technique for accelerating electrons is shown in Figure 7.46, where there is a uniform electric field between two plates. Electrons are released, usually from a hot filament, near the negative plate, and there is a small hole in the positive plate that allows the electrons to continue moving, (a) Calculate the acceleration of the electron if the field strength is 2.50104 N/C . (b) Explain why the electron will not be pulled back to the positive plate once it moves through the hole. Figure 7.46 Parallel conducting plates with opposite charges on them create a relatively uniform electric field used to accelerate electrons to the right. Those that go through the hole can be used to make a TV or computer screen glow or to produce X- rays.