2. Design the following Boolean function using appropriate Multiplexer and logic gates F(A, B, C, D) = E(1, 3, 4, 5, 6,10, 11, 12, 13, 14, 15)
Q: *7. Determine the level of Vo for each network of Fig. 157. Si Ge 2 ΚΩ +10 V 1.2 kQ Si 12 V 10 kΩ 4....
A: Note: As per the company policy, we experts are allowed to answer only one question. Kindly post the...
Q: 30 cm 5 cm 5 cm B (Tesla) 73 S/ mnging effect in the air gap increases the effective cross-sectional...
A:
Q: Discuss reversed polarity and why is it dangerous to reverse you wire connection
A: Wire connection There are three types of wire connections. They are live wire, a neutral wire, and g...
Q: An impedance coil is connected in parallel with a capacitance C of 12.5 μF. The input voltage to the...
A:
Q: 4. Determine the Norton equivalent for the network faced by RL. 5 kΩ 1 kN 300 mA ( ↑ 7 kΩ 6 kΩ RL 2....
A:
Q: Draw the common-emitter output characteristics of a pnp transistor and explain why collector current...
A: The common-emitter PNP transistor is shown below: The output characteristics of a PNP transistor i...
Q: How did he define the limits of the drawing from -3 to plus 3 we Knowthat Ac cos(27T e t) <EIy Ac SC...
A:
Q: 9 Listed are the factors affecting the capacitance except: A. voltage rating B. dielectric c...
A: Listed are the factors affecting the capacitance except: A. voltage rating B. dielectric constant C....
Q: 2. Described The basic principles of methods to start 3-phase induction motors below: A. Star-Delta ...
A: Three phase induction motor can't be started by direct supply as it draws high current which is mult...
Q: (a) Why Ge material has a lower Vhi than Si at T = 300 K and GaAs has a higher Vi than Si at T= 300 ...
A: a) At 300K, Material Energy band gap ...
Q: If you mistakenly delete a file and want to recover it, you must do the actions outlined below.
A: Given: Mistakenly deleted file
Q: 23.a. What type of squirrel-cage motor is ordinarily used with small air compressors equipped with a...
A: 23.a) Answer :B Design C motor.
Q: Solve for I, and V, 20 V Ge Si 2.2 k2 6 4 V
A:
Q: Find the value of the resistance (R) that results in 1 mA average current in the 50 Ω. Assume the di...
A:
Q: Find the minterms of the following Boolean expressions by first plotting each function in a map: (c)...
A:
Q: Solve the equation using Cramer's rule (10 + j20)I, -+ j10I, = 60/30° (13.3.1 For mesh 2, j101, + (j...
A:
Q: 11.a. If an a-c system requires a 250-hp motor to drive a machine at a uniform rate of speed, what t...
A: 11.a. Synchronous motor is the motor which provides uniform speed. So when an AC system required to ...
Q: An office in Oman has the following electrical appliances usage: (i) Twenty numbers of 15 Watt LE...
A: It is given that: Twenty numbers of 15 Watt LED lamps are used for half of the day. Fifteen numbers ...
Q: For the circuit shown, µnCox = 4 µpCox = 400 µA/V², [V¢| = 0.4 V, 2 = 0, L= 0.2 µm %3D and W = 1 µm....
A: The circuit diagram is shown below, Where,μnCox=4 μpCox=400 μA/V2Vt =0.4Vλ=0L=0.2 μmW=1 μm
Q: 5. Make an exhaustive list of all the electronic communication products that you own, have access to...
A: Electronic communication products A communication system that uses electronic media to transmit info...
Q: Find the Fourier series of the following waveform: flt) t -T -T/2 T/2 T Which is defined as 2t f(t) ...
A:
Q: Q1. Determine the value of the current ia in the circuit shown below. State any assumptions/theorems...
A:
Q: Find ix Hix 2u mA 9 2ix
A: Consider the given circuit,
Q: make V and
A:
Q: The power taken by a resistive coil made of copper wire is 1200W at 120V and 15 0C. Calculate the po...
A:
Q: w + -12w
A: Given, w+ -12w
Q: BHomework Problem: Reduce the below block diagrams into single transfer function by using Block Diag...
A: We are authorized to answer one question at a time since you have not mentioned which one you are lo...
Q: 1. Find voltage values at points A, B, C, andD shown in the circuit (Fig. 4-28) with respect to grou...
A:
Q: The following information is given in connection with a parallel connected impedances: Za = (13 – j...
A: The solution is given below
Q: 10.a. A certain pump is capable of delivering 625 gpm, efficiency is rated at 75%, and the sum of th...
A: The smallest amount of power necessary to move water is known as water horsepower. In other words, i...
Q: 6. In the circuit of Fig. 5-30, find V if 13=0.2 A. Then find IT. = 0.2A 20 1 20 N 10 Fig. 5-30
A:
Q: ww 20 V 1/8 F t = 0
A:
Q: Q1/(b) Calculate cutoff frequency high for the cct. below at R1=R2= 10K2 and C1=C2=0.002 µF *
A: The given circuit is shown below: R1=R2=10Kohm=10X103ΩC1=C2=0.002μF=0.002X10-6F
Q: 3. Draw circuit diagram of a half-wave controlled rectifier and draw the wave shapes of output volta...
A:
Q: B- For the following circuit, find the value of R given that i, is 15 mA. 3 k2 90 V 4 k2 ww
A:
Q: Vin(t) = 10 cos(500rt) + 10cos(2000rt) + 10cos(20000rt) R = 1000 318.3 N 5 µF Vour(1)
A: We need to find cut off frequency for given low pass filter and we will find out output voltage for ...
Q: In the circuit of Figure 2 with RL = 1 kilohm, determine the maximum value of Rs which will allow th...
A: A series combination yields the most resistance, whereas a parallel combination has the lowest resis...
Q: D: has been eaten
A: Answer According to given information
Q: 10 Another term for a capacitor is a/an ___________. Select one: a. capacitive resistor b. energ...
A: Given that another term for the capacitor.
Q: Consider the WAN, or wide-area network, as your preferred wireless access method. What makes this op...
A: Wide Area Network (WAN) - it is a big data system that is not limited to a single place. Through a ...
Q: 1. Explain the difference between a slip ring and a squirrel -cage motor.
A: Solution 1 - The rotor in a slip ring induction rotor has the same three phase winding as the stato...
Q: Use node method to find i
A:
Q: A very small discrete silicon diode (a “100µA diode”) is found to conduct 100 µA at 0.700 V and 1 mA...
A: This question belongs to analog electronics . It is based on current equation flowing through diode...
Q: I1 R1 R4 R6 Va Vb 3 5 4 12 V1 V2 13 R2 R3 12 6 12 20 3 R5 Vaend 10 Vaend Va
A:
Q: solenoid 10 cm long is wound with 300 turns of wire. The solenoid needs a current of 1 A in order to...
A:
Q: 1.Describe the following feedback control system in terms of simple block diagrams: a. DC motor posi...
A: (a) DC motor position control system: Consider the simple block diagram for the DC motor position co...
Q: Calculate the ohmic value of the following resistor color coded as Blue, Orange, Violet, Silver.
A:
Q: Use a multiplexer having three data select inputs to implement the logic for the function F = Em(0,1...
A: We need to design the given Boolean function by using of multiplexer
Q: Explain the stability analysis of a Dc system in a detail
A: Dc system - It’s main use is to power anything that has a battery. The battery is used mainly for th...
Q: KW demand I5 UUI 4. Explain the different voltage control methods [10 A 3-phase line having an imped...
A: Phase modifier: This is also known as the synchronous condenser that runs without mechanical load an...
Step by step
Solved in 2 steps with 2 images
- 1. Design a 16 - to - 1 multiplexer using 4- to-1 multiplexer. 2. Using K- Map, simplify the following Boolean expression : Y = Σ (1,3,5,7,9,10,11,13,14,) 3. Build the logic circuit for the following function using Programmable Logic Array (PLA). ?? = ??? + ??? + ??? + ??? ?? = ??? + ??? + ??? + ???Consider two binary numbers where the first is made of three bits whichcan be represented by X, Y, and Z, while the second is two bits and isrepresented by A and B. Design a logic circuit that multiplies X Y Z timesA B, using two half adders, one full adder in addition to AND gates.The following Boolean function Y=f(A,B,C,D,E) =Em (0,1,2,4,5,6,10,13,14,18,21,22,24,26,29,30). Design the function with minimal logic gates using: (A) Quine-McClusky method (Tabular method) (B) Karnaugh Map Method.
- Implement the following logic function using only 3-8 decoders and logic gates. ?(?,?,?,?)= Σ?(2,4,6,8,10,14,15)Q (A, B, C) = A' .B'. C +A' .B. C + A.B.C' + A.B.C Obtain the simplified function with the Karnaugh Map method in terms of minterms and maxters separately. Set the output functions separately with logic gates with ANDNOT for minterms and ORNOT for maxterms.Q (A, B, C) = A̅ .B̅. C + A̅ .B. C + A .B. Obtain the function given as C̅ + A.B.C, simplified by the Karnaugh Map method, in terms of minterms and maxters separately. Set the output functions separately with logic gates with AND NOT for minterms and OR for maxima.
- a. Construct a Karnaugh map for the logic function D=ABC+ A ¯ BC+AB C ¯ +BC b. Find the minimum SOP expression and realize the function, using AND, OR, and NOT gates. c. Find the minimum POS expression and realize the function, using AND, OR, and NOT gates.Minimize the logic function Y(A,B,C,D) = ∑(0,1,2,3,5,7,8,9,11,14) . Use Karnaugh map. Draw logic circuit for the simplified function.Q (A, B, C) = A̅ .B̅. C +A̅ .B. C + A .B. C̅ + A.B.C Karnaugh function given in the form Using the mapping method, you can use the simplified function separately in terms of minterms and maxters. obtain. Output functions with AND NOT for minterms and OR for maxters. Install separately with logic doors.
- Construct the corresponding logic circuit for the following expression using only AND gates and OR gates and INVERTERS. Do not simplify! x = AB(C+D) 6) z = (A + B + CDE) + BCDDraw the logic diagram to implement the following Boolean expression using only NAND gates.Y= A’(B+C) +DQ (A, B, C) = A̅ .B̅. C +A̅ .B. C + A .B. C̅ + A.B.C Karnaugh function given in the form Using the mapping method, you can use the simplified function separately in terms of minterms and maxterms. obtain. Output functions with AND NOT for minterms and OR for maxters. Install separately with logic doors.