2. Find the force in members BC, BE, EF using the method of section. Show the free body diagram with required dimension's and inclinations: Olncluded in manual solution ONot made The force in member EF: N [Tension:+, Compression: -] The force in member BC: N [Tension:+, Compression: -] The force in member BE: N [Tension:+, Compression: -] (Answer upto 1 decimal place for all values)

2. Find the force in members BC, BE, EF using the method of section. Show the free body diagram with required dimension's and inclinations: Olncluded in manual solution ONot made The force in member EF: N [Tension:+, Compression: -] The force in member BC: N [Tension:+, Compression: -] The force in member BE: N [Tension:+, Compression: -] (Answer upto 1 decimal place for all values)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Assuming that P = 48 000 lb and that it may be applied at any joint onthe line FJ, determine the location of P that would cause (a) maximum tension inmember HI; (b) maximum compression in member CI; and (c) maximum tensionin member CI. Also determine the magnitude of the indicated force in each case
Determine the force in member EG, and indicate whether the members are in tension or compression. if P=11kN. 24.75kN (T) 24.75kN (C) 39.66kN (T) 39.66kN (C) 41.25kN (T) 8.25kN (C) 8.25kN (T) 41.25kN (C) ORONORCORORORORC
Using the section method, determine the member forces of BD, CD, and CE. Don't forget to specify whether you're performing with compression or tension.
USING THE METHOD OF SECTION/JOINT ,DETERMINETHE AXIAL FORCE IN EACH MEMBER.THE LOAD AT POINT G IS 1kN.
Use the method of sections todetermine the forces inmembers AB, FG, AH, and GH.State whether the forces are intension or compression.
Thecable of length 15m supports the forces W1 = W2 = W at B and C. (a) Derive the simultaneous equations for β1, β2, and β3. (b) Show that the solution to these equations is β1 = 41.0◦, β2 = 9.8◦, and β3 = 50.5◦. (c) Compute the force in each segment in terms of W.
Replace the loading system by an equivalent resultant force and specify where the resultant’s line of action intersects the member AB measured from A.
Two rods and one cable are attached to the support at O. Two of the forces are as shown and the resultant of the three forces is vertically downward with a magnitude of 1200 lb. Determine the magnitude of force F. Determine direction of the third force F.
Determine the resultant of the force system acting on the beam shown and find where it intersect the beam measured from point O.
Find the internal force of HG using Section of method.
15. If Q = 1261.26 N, calculate the force in member BE in kN. Indicate whether the member is in compression (-) or tension (+).
w=140 N/m. Determine the horizontal and vertical components of force lin A of the member frame. Ax, Ay = Determine the horizontal and vertical components of force at pin C of the two member frame. Cx,Cy=