2. From the figure below, Fig. 1, if the voltage drop across the 7 0 is 24 V, find the supply voltage. And also, find the power consumed by each resistor. 70

Q: Find I in the circuit below 10V 12 V -8 V

A:

Q: A boost regulator has an input voltage of 8V. The average output voltage and current are respectivel...

A: In this question, we will find ripple current and peak current of inductor in boost converter....

Q: 2. A wire carries a current i = 3cos314t A. What is the average current over 6 seconds?

A:

Q: 3. Determine the value of the current given the forward voltage drop of the LED is 2.1V and R=100 Ω(...

A: Voltage drop across LED = 2.1 V Battery voltage = 9 V Therefore, voltage drop across resistance = 9 ...

Q: Voltage=12 voltage Resistance =2 ohms Determine  current

A:

Q: A silicon sample of unknown doping has the dimensions of W=0.05 cm, A = Area of cross-section = 1.25...

A: It is given that: W=0.05 cmA=1.25×10-3 cm-2I=2 mAB=2×10-4 Wbcm2H=10 mV

Q: 10 mA( ↑ -25 V • What is the power of the current source (with appropriate ± sign)? • What is the po...

A:

Q: (a) A digital thermometer has a scale of -110 to + 350 °C. The meter accuracy is guaranteed to ±2.5%...

A: Given:A digital thermometerScale of thermometer= -110oC to+350oCMeter accuracy guranteed to ±2.5% or...

Q: in the event of a blackout at diablo dam a bank of batteries could be used to get system back online...

A:

Q: AC-DC power supply circuits are one of the most common circuit configurations in electronic systems....

A: Electronic system: This system deals with devices in which light current is used and this system is ...

Q: Examples: 1.Consider the block diagram shown in the following figure. Let us simplify (reduce) this ...

A:

Q: The voltage across and current through the terminals of a circuit element are shown in Fig. 1(a) and...

A:

Q: i. In pn-junction diodes, the reverse saturation current stays constant regardless of the ambient te...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Consider a continuous time system with the following input output relation y(t) = x(sin (t)) a) Is t...

A: Causal and Linear System When the output of the system depends on past and current inputs but not fu...

Q: The power absorbed by a non-linear device is p = 9(e0.16t – 1). if v = 3(e0.4t + 1), how much charge...

A: Given,Power P=9e0.16t2-1Voltage V=3e0.4t+1Therefore,Current I=PV=9e0.16t2-13e0.4t+1=3e0.16t2-1e0.4t+...

Q: The differential-mode input voltage, Vair, is the voltage difference between v* and v 3 Pdiff = Vin ...

A:

Q: Activity 1: You are testing an electrical device which can be modelled by the figure shown below: 18...

A: "As per our guidelines, we are supposed to answer only one question. Kindly repost the other questio...

Q: Do DI -Y 10 So Y D2 1 11 12 1 13 14 1 D3 1 1 15 16 Y = S¡'.So'.Do + S¡'.So.D1 + S1.So'.D2 + S1.So.D3

A: The above circuit and the expression of Y refers to a 2*4 multiplexer.   

Q: A cavity radiator has its maximum spectral radiance at a wavelength of 9x10-7 m. If the body is heat...

A: It is given that: λ=9×10-7mTTo=1.1b=2.897×10-3 m.K

Q: Determine the frequency at which a 2µF capacitor and an 80 mH inductor will have the same reactance.

A:

Q: 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequenc...

A:

Q: Sketch the output waveform of the given circuit, assuming that the voltage of the battery is 1V and ...

A:

Q: 5. A Michelson interferometer is used to measure the spectrum line width of the light beam generated...

A:

Q: Vp 10 kn 0.1 M2 k - 2.5 mA/V? Vt=0.5 V 10 MN Fig. Q3a i. Draw the small ac signal equivalent circuit...

A:

Q: Consider the following amplitude modulated signal: S (t) = cos (2000 t) + 4 cos (2400 nt) + cos (280...

A: The solution can be achieved as follows. 

Q: Based on the diagram, where should I place the terminals of the Ohmeter to measure the resistance ac...

A: This question belongs to circuit theory . It is based on calculation of resistance between terminals...

Q: Two points A(2,2,1) and B(3,-4,2) are given in the cartesian system. Obtain the vector from A to B a...

A:

Q: A single phase transmission line is delivering 450 kVA load at 12 kV. Its resistance is 4.5 and indu...

A: Given,R=4.5ΩXL=6ΩcosϕR=0.9lagV.R.=Vs-VRVR×100 .....(1)Sending end voltage, Vs=VRcosϕR+IR2+VRsinϕR+IX...

Q: 7. The semiconductor used in Costin Calculator has 5 components with the consistency of 90%, 95%, 98...

A: Since you have asked multiple questions, we will solve only one question for you. If you want any sp...

Q: The rated secondary current of a current transformer (CT) is 5A. The plug setting of relay connected...

A: We have given the following problem

Q: Find the numerical value of ip.

A:

Q: Question 2. Questions regarding the 4-bit right shit register built in the experimental part. a. How...

A:

Q: 5. In the given circuit, find Vad and Veb. b + 7V - 12V 8V +) 6 V f - 2v + e - 5 V+ d

A:

Q: Skip part 54. The signal x[r] = (1. –2,3, –4,0.4. –3,2. –1). has Fourier transform X(e»"). Find the ...

A: Given

Q: Power Transmission and Distribution Discuss the advantages and disadvantages of single-phase and th...

A:

Q: capacitor, and a 10.5 V voltage source. --> The student discharges C1 and charges C2 to 10.5 V. Whe...

A:

Q: - Y B- 에 C-

A: Note in the given circuit NMOS C and D are in OR configuration. C+D

Q: 3.51 In the circuit shown in the image below, if V1 = 93 V and R1 = 9 Q, determine voltage vo in V.

A: The node voltage Vo can be obtained by using nodal analysis method and by applying kirchhoff's curre...

Q: Find I in the circuit below 10V 12 V

A:

Q: 4. An incandescent lamp, rated at 100 W, gives a certain amount of light when placed across the 120 ...

A:

Q: Question 1g: Determine the signed magnitude binary encoding of the number 11

A: The solution can be achieved as follows.

Q: Determine the capacitance required to establish a capacitive reactance that will match that of 20 mH...

A:

Q: An amplifier has an open loop voltage gain of 1,00,000. With negative voltage feedback, the voltage ...

A: Given, an amplifier has An open loop voltage gain, Avf=1,00,000 Voltage gain with negative feedback,...

Q: The upper cutoff frequency of an amplifier is 32 kHz. The output at that frequency is 6.71 V p-p. Wh...

A: Option A  9.49 Vpp is the correct answer Find the magnitude ratio at given frequency and calculate o...

Q: 30 k2 20 k2 50 k2 10 kN Reg 40 k2. 20 kN 40 kN • What is the value of equivalent resistance Reg? 30 ...

A:

Q: R2-502 R3-2502 V-180V R=1002 R4=2002 R3=202 Ry=1502 R=3002

A: SOLUTION- a) Total Resistance-       The resistors R4 and R5 are in series. R4+R5 = 30+50 = 80 Ohm...

Q: Find the Fourier series of the function. Write out the terms up to n = 3.

A:

Q: 4.67. A vertical, infinitesimal in length (I = 1/50), monopole is placed on top of a police car, and...

A: It is given that: l=λ50f=10 MHzPrec=10μwatts

Q: Problem: The 20 V source shown below supplies 4 W of power to the rest of the circuit. The alue of v...

A:

Q: EXAMPLE 2.0 FIND ALL THE ROOTS OF x. ((3275°- j3794)2- 4e [(12- 42° + el30")• – (2 – j5)*]) (7/15° +...

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.