Q1. Find the values of resistance R and inductance L in the circuit of Fig. 1.

Q: < Notes What are the characteristics of an ideal operational amplifier? 8

A: In this case, the characteristics of an ideal operational amplifier are to be determined.

Q: (a) Given the voltage-divider bias configuration of Figure 2. Assume R₁ = 56kN, R₂ = R2 8.2k, Rc =…

A: We need to find out the current and voltage for given circuit

Q: Find Ic, lb, Vce, Vc, Vb, Vrc,Vrb for all the CE amplifier circuit shown in fig. 1 Draw the DC load…

A:

Q: the past is said to be O Memoryless O Stable O Time Invariant O Invertible. O Linear O Causal O None…

A: We need to select correct option for given statement

Q: the circuit shown in the figure, assume LED1 has a forward voltage of 2 volts and 2002 forward…

A: In this question,  We need to determine the current I1 as shown the circuit.  LED froward voltage VD…

Q: 1. Use the concept of mesh current analysis to find io in the circuit shown. Note: to, the branch…

A: Given,

Q: what is bus impedance matrix ? how it is useful in symmetrical fault analysis?

A: Impedance bus matrix : Impedance bus matrix is a algorithm method to form a bus impedance matrix on…

Q: Using a block diagram, show how to implement the following roll-off rates using a single-pole and a…

A:

Q: 3. For the circuit in Fig. find the branch currents I₁, I2, and I3 using mesh analysis. 12V + 502 i₁…

A:

Q: Explain the principles of push-button switches and illustrates their different types. Support your…

A: Different types of push button switches:

Q: Explain hybrid operation of wind farms

A: Hybrid operation of wind farms: Any combination of wind energy with another additional form of power…

Q: The Laplace transform of the following function is: f(t)=2*e-3tcos(5t) u(t) O a. F(s)=2*e 3s(s²+25)…

A: Use laplace transform properties and laplace transform table to find laplace transform of the given…

Q: When a unit ramp input is applied to the unity feedback system having closed loop transfer function…

A: Given the unity feedback system having closed loop transfer function CsRs=Ks+bs2+as+b Where, a&gt;0,…

Q: Convert 100 watts of power into dBW? Show all steps

A: In this case, 100 W of power needs to be converted into its equivalent power in dBW.

Q: G(s) 100 s²+12S+100

A:

Q: At what rate is thermal energy being generated (The power) in the 2R-resistor when - 16 V and…

A: We need to find out power for given resistor for the given circuit

Q: 4. The amplitude spectrum of the signal x(t) is shown as follows: | X()| 2 A -3500 -3450 -2000 0…

A:

Q: Determine the total potential energy stored, in microjoules, in a cylinder of radius 9 m and height…

A: The potential energy stored in the body placed in an electric field is given by the expression as…

Q: Find the output waveform from the given circuit and input waveform. 2V KO 10 k V m 20

A:

Q: alent circuit for the network in fig 4. through terminals A B and C in fig 5. ΚΩ C 15 Ω 100 V 7Ω 11…

A: For the given electrical circuit we need determine its thevenin equivalent circuit for node A B.

Q: A 10 mH inductor, a 1 uF capacitor, and a variable resistor are connected in parallel in the circuit…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Three charged particles are placed on the corners of an equilateral triangle of side 1.20 cm. The…

A: It is given that: d=1.20 cmQ1=+4μCQ2=-8μCQ3=-6μC

Q: OR e) What is BILS? Explain their significance in power system studies.

A: BILS : BIL is stand for basic level insulation which is also known as lighting impulse voltage or…

Q: Question (1): (i) What is the noise figure F of a cable with an attenuation factor a = 1.5 dB/m and…

A: Noise figure :- It is uses the logarithmic scale and it is noise factor  which is expressed in…

Q: Explain insulation coordination

A: Coordination is required in electrical systems for proper functioning of the equipments. Insulation…

Q: 1. Find and draw the Fourier Transform of the signal shown if figure below: f(t) -T coswot T

A: 1) To find and draw the Fourier transform of the signal f(t) = cos(wot)

Q: Figure 1 shows a unity feedback system where the transfer function is given as 1 G(s): s(s² + 100s…

A:

Q: If a finite number of blocks are connected in cascade configuration, then how are the blocks…

A:

Q: V, is a 60Hz source with a peak voltage VP-120V is feeding a rectifier, assume ideal diode. The load…

A: Given circuit, Peak voltage, VP=120 V Load resistance, R = 10 kΩ Ripple voltage, Vr=2 V

Q: a) Calculate the resistances R1, R2, RS and RD so that ID E [0.4, 0.8]mA, Zi = 400K and that VDS is…

A: MOSFET Small Signal Model :MOSFET Model has a Large input resistance value at the gate terminal. it…

Q: A single phase synchronous motor gives an output of 9.46kW at 0.9pf lagging with 600V. If the stray…

A:

Q: For the given circuit and input waveform determine the output waveform. a. b. C. d. 15 a b -10 20 20…

A:

Q: A zener diode has a power rating of 4W and zener voltage of 20V. The maximum current it can safely…

A: Given: A zener diode has Power rating, P=4 W Zener voltage, Vz=20 V

Q: B R1 www VR3 = 1.85 V ) VR3 = 5.43 V VR3 = 3.65 V www R7 R5 R6 R2 www R4 R3 The circuit above has R1…

A: Given, The circuit is, R1=820 ΩR2=220 ΩR3=470 ΩR4=910 ΩR5=560 ΩR6=330 ΩR7=680 ΩVAB=100 V

Q: How much silicon diode current is there in the figure with the diode approximation? R1 -12.7V 2.7k O…

A:

Q: 5.a) A 4 pole, 3 phase induction motor operates from a 50 Hz supply. Calculate (a) Speed at which…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Use a 0.05-µF capacitor to design a high-pass filter to have cutoff frequency of 100 krad/s. Draw a…

A: The required circuit can be designed with the help of capacitor and resistor. The capacitor will…

Q: 7. Space diversity s also known as a) Frequency diversity b) Antenna diversity c) Polarization…

A: The solution is provided in the following section.

Q: (a) (b) 1 A -4 -2 p(f) -0.5 24 1 0.5 ► f T =

A:

Q: Notes Convert 100 watts of power into dBW? Show all steps Done

A:

Q: Baded generator with a pre-fault voltage 1 pu has the following sequence impedance: Zo = 0.15 pu, Z₁…

A: Given, An unloaded generator with pre fault voltage, E = 1 p.u. Having following sequence impedances…

Q: A moving coil instrument of resistance 10 ohms has a 50 division scale and indicates 1 micro ampere…

A: Given,Moving coil resistance, Rm=10 The moving coil has 50 divison scale and shows 1 μA per…

Q: A bulb rated 110V, 60Watts is connected with another bulb rated 110V, 100 Watts across a 220V mains.…

A:

Q: 1. The hot resistance of a 250V filament lamp is 625 2. Determine the current taken by the lamp and…

A: Given, Voltage across filament lamp, V = 250 V Resistance of filament, R=625 Ω

Q: 1) Figure below shows two possible ways to design feedback control loop to obtain a desired rate of…

A: AIM:: 1.To find the sign of the gain values,kv for each valves=? 2.controller must be used in direct…

Q: Determine the Fourier series representation for the signal x (t) shown in Fig. P. 4.2.9.

A:

Q: Given the lower and higher cut-off frequency of a band-pass filter are 2.5 kHz and 10 kHz. Determine…

A: Given, A band pass filter has Lower cutoff frequency, fL=2.5 kHz Higher cutoff frequency, fH=10 kHz…

Q: 6.1 A Car battery is rated for 12 Volts, 5 Ah rechargeable battery can be operated for about 10…

A: Given, A battery with V=12 VQ=5 Aht=10 h

Q: D1.8. Transform the following vectors to spherical coordinates at the points given: (a) 10ax at P(x…

A:

Q: D1.8. Transform the following vectors to spherical coordinates at the points given: (a) 10a, at P(x…

A: It is given that: a) 10ax at Px=-3,y=2,z=4b) 10ay at Qρ=5,ϕ=30°,z=4c)10az at Mr=4,θ=110°,ϕ=120°