2. Given that there is transport of 4 moles of A and 2 moles of B towards a permeable membrane from bulk. The film between the membrane and the bulk is 2 microns thick. The concentration of A at the b is CA, bulk = 1 µM and at the interface is C₁=0.5µM. Under steady state conditions, derive the concentrati profile (particular solution) of A and B for the following two conditions: (a) Neglecting convective fluxes in the film (b) Not neglecting convective fluxes in the film

2. Given that there is transport of 4 moles of A and 2 moles of B towards a permeable membrane from bulk. The film between the membrane and the bulk is 2 microns thick. The concentration of A at the b is CA, bulk = 1 µM and at the interface is C₁=0.5µM. Under steady state conditions, derive the concentrati profile (particular solution) of A and B for the following two conditions: (a) Neglecting convective fluxes in the film (b) Not neglecting convective fluxes in the film

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter14: Chromatography

Section: Chapter Questions

Problem 9P

See similar textbooks

Similar questions

If between 2 beakers there is a membrane of 50 MWCO and initially a concentration of 10 mM of NaCl is added to one of the beakers and deionized water to the other. How do you expect it to affect the time it takes to reach dynamic balance and the rate of diffusion if you then double that concentration to 20 mM of NaCl?
At 0°C and 1 bar, a monolayer of CO adsorbed on 1 g of Fe/Al2O3 catalyst occupies a volume of 4.25 cm3. What is the area of the catalyst? The area per adsorbed particle is 0.165 nm2. Give your answer in m2.
Substances A and B with capacity factors 6.3 and 11.4, respectively, are being carried by a mobile phaseflowing at a velocity of 0.53 mm/s. What is the length of a column required to separate these two substanceswith a resolution of 1? Assume that the sample zones for both A and B broaden based on the van Deemter equation H = 0.35 + 0.48/u+ 0.57u where Hand u are expressed in µm and mm/s, respectively.
The distribution coefficient, KD = (Cether)/(Cwater) = 3.5 for aspirin at 25 C. What volume of ether would be necessary to extract 0.95 g of aspirin from a solution of 1.0 g of aspirin in 100 mL of water in a single extraction? Show all calculations.
1. Sodium carbonate is recovered as decahydrate from 1000kg of 5% solution of sodium carbonate in water. If it is desired that 95% of Na2CO3 is to be recovered as decahydrate by cooling to 278 K, determine the following: a) the mass of water evaporated (b) the mass of crystals obtained (Na2CO3 ∙ 10H2O). The solubility of Na2CO3 in water at 278K is 9.0% (weight) 2. A copra batch contains 44% oil and is to be extracted with n-hexane. The extracted meal contains 0.07 kg of oil/kg oil free matter and the mass fraction of n-hexane in it is 0.05. The extract contains 49% n- hexane. If 10,000 kg of copra are to be processed, how many kg of n-hexane are required and the determine the amount of extract. 3. Absorption of sulphur dioxide is carried out in a packed tower. Gas containing 14.8% sulphur dioxide and the rest inert gases enters the tower while the leaving gases contains 1% sulphur dioxide. Water flows at the rate of 1m3/min. The tower handles 7380 m3/hr of gas at 303K and 1 bar. Find…
The %purity of a powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. a. How many moles of CO2 were collected? b. What is the percent purity of the sample? Round off to the nearest whole number
The %purity of a powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. What CASE does this experiment satisfy?
The aqueous solution of acetic with a flow rate of 1000 kg/hr contains 30% acetic acid by mass and will be extracted in a countercurrent multistage process with pure isopropyl ether (IPE) to reduce the acetic acid concentration in the final raffinate phase (LN) to 2% by mass. a) Calculate the minimum solvent flow. b) Determine the theoretical number of steps required when using a solvent of 1.5 minimum solvent flow rate. c) Determine the number of theoretical steps using the McCabe-Thiele method. Chart. Acetic acid (A)-Water (B)-isopropyl ether (IPE) (C) LIQUID-Liquid Balances at 1 atm pressure and 293 K Water layer (%) Water (B) Isopropyl ether layer (%) Water (B) 0.6 Acetic acid (A) IPE (C) Acetic acid (A) IPE (C) 98.8 1.2 99.4 99.3 98.9 0.69 98.1 1.2 0.18 0.5 1.41 97.1 1.5 0.37 0.7 2.89 95.5 1.6 0.79 98.4 91.7 1.9 1.0 97.1 6.42 13.30 25.50 36.70 1.9 93.3 4.82 11.40 2.3 84.4 71.1 3.4 3.9 84.7 71.5 21.60 31.10 58.9 4.4 6.9 58.1 48.7 10.6 10.8 45.1 37.1 44.30 46.40 16.5 36.20 15.1…
What is the actual or real-life application of volatilization gravimetry? Include the specific methodology.
Penicillin is hydrolyzed and thereby rendered inactive by beta-lactamase, an enzyme present in some penicillin-resistant bacteria. The mass of this enzyme is 30.0 kDa. The amount of penicillin hydrolyzed in 1 minute in a 1 mL solution containing 3 x 10-3 g of the enzyme was measured as a function of the concentration of penicillin. Calculate Km, Vmax , and kcat from the following data: (Clearly show where 1/Vmax and -1/Km are; clearly explain how to obtain your kcat value). [S] (mM) vo (mM s-1) 0.14 0.138 0.28 0.234 0.55 0.333 0.77 0.388 1.52 0.491
Can you help me answer this problem, a container of Atrazine (500 g) is dumped into a river 2.3 km upstream of a municipal water intake pipe. Cross-sectional area of the river is 5.7 m2. Assume that the Atrazine is dumped as a point source. The river flow is 8.25m3/s and the longitudinal dispersion coefficient is 0.1 m2/s, what is the maximum concentration (in ppm) expected at the intake. How spread out (in the direction of flow) is the atrazine at the time the peak concentration occurs at the intake pipe? Assume 2 standard deviations on either side of the peak is a good estimate of spread. Thank you
A fly ash aerosol of monodisperse particles with a density of 2.0 g/mL and particle diameter of 10.0 mm has a concentration of 1000.0 mg/m3. Calculate the settling velocity in cm/s and the settling rate in g/m2-s. Please answer very soon will give rating surely