Answered: 2. The radial heat conduction through a…

2. The radial heat conduction through a hollow cylinder increases as the ratio of outer radius to inner radius a. increases b. remain the same c. decreases

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter2: Steady Heat Conduction

Section: Chapter Questions

Problem 2.25P: Show that the rate of heat conduction per unit length through a long, hollow cylinder of inner...

See similar textbooks

Related questions

Q: The inner surface of a 2 inch wall is 70C and its outside surface temperature is 34C. Determine the…

A: To find: The steady state heat transfer. Given: The thickness of the wall is t=2 in. The inner wall…

Q: 7. The only mode of heat transfer that does not need a medium. 8. A mode of heat transfer that…

A: given = one word answer or fill in the blank

Q: The wall of a cold room consists of a layer of cork sandwiched between outer and inner walls of…

A: Given Data The heat transfer coefficient is :Q=42 W/m2 Inside temperature is : Ti=-20°C Atmospheric…

Q: A truncated cone 30 cm high is constructed of aluminum. The diameter at the top is 7.5 cm, and the…

Q: An infinitely long pin fin, attached to an isothermal hot surface, transfers heat at a steady rate…

Q: 2. The cabin air in an empty aircraft on the ground in a tropical country is maintained at a…

A: Given : Ta=35 CTc=21 Cha=39 W/mKhc=9 W/mK To find : Power

Q: Consider a hollow sphere of internal radius 0.150 m and external radius 0.600 m. The sphere is made…

Q: The steady-state heat conduction _____ is constant in the radial direction for a spherical system

A: The given statement is TRUE

Q: The outer surface of a long cylinder is kept at a constant temperature. There is no heat generation…

Q: Calculate the heat transfer per unit area of a concrete which has a thickness of 300 mm, the…

Q: Which of the following is source of sensible and latent heat A. Infiltration B. Light C. Radiation…

A: Correct answer: Infiltration

Q: odynamics The temperature gradient in a slab at steady conduction is -1000°C/m. The slab conducts…

A: Given:temperature gradient=dTdx=- 1000o C/mQ=250 W/m2

Q: Suppose that heat conduction occurs at a constant rate of đQ/dt in a hollow sphere with an inner…

A: dQ/dt = -kAdT/dr is integrated to get the solution.

Q: Using the general conduction equation for a Cartesian system, derive the expressions for the…

Q: A slab of thickness L with one side (x=0) insulated and the other side (x=L) is maintained at a…

A: Write the expression temperature variation. ∂2T∂x2+q˙gk=0∂T∂x+Pxk=C1T+Px22k=C1x+C2

Q: List one type of heat energy transfer in your residence. Be sure to justify your answer with a brief…

A: Introduction: The solar energy is transported to the earth's crust via the earth's atmosphere. Some…

Q: With an increase in the thickness of insulation around a circular pipe,heat loss to surrounding due…

A: Given that a circular pipe is insulated, Let t be the thickness of insulation, ri be the inner…

Q: A rectangular wall of length "L" m and height "H" m is made from a thick bricklayer. The rectangular…

Q: 3) When sleeping under a blanket in a cold room, heat from your body leaves via conduction through…

A: following is the answer

Q: 9. A plane wall 6.2 cm thick generates heat internally. The wall is made of a material with thermal…

Q: b. A slab of stone of area (3600 + R) cm² and thickness 10 cm is exposed on the lower surface to…

A: Draw diagram of slab for better understanding

Q: 1) Briefly explain the following. Why the temperature of heat conduction study bench should not…

A: Heat conduction is a medium of heat transfer in which the heat is transferred to the whole material…

Q: A cubical piece of heat-shield-tile from the space shuttle measures 0.17 m on a side and has a…

A: a) Given, A cubical piece of heat-shield-tile from the space shuttle. Thermal conductivity of the…

Q: [Plane wall conduction with heat generation] When passing an electrical current I (A), a copper bus…

Q: (The overall heat transfer coefficient, The critical thickness of insulation and the steady of heat…

A: To find :- All heat transfer coefficient Critical thickness of insulation steady state heat…

Q: The outer surface of a long cylinder is kept at a constant temperature. There is no heat generation…

Q: what is 3 dimensional heat conduction?

A: Heat conduction in practice can be in any direction provided there is a temperature difference…

Q: The surfaces of a wall with uniform heat generation of 16535W/m³ are at 269°C and 108°C. If the wall…

Q: Identify the correct statement O a. The thermal resistance of conduction decreases with increase in…

A: Option C is the correct answer.

Q: A 12-by-12 in. open pan containing water at 140 °F is placed in the exact center of a 16-by-20 ft…

A: Given - A=12×12 in2=0.093m2 , T1=140°F=333.15K, T2=75°F=297.04K The shape factor will be 0.5 as pan…

Q: 1.In this experiment, heat is transferred by and rate of energy transfer increases with 2. Good…

A: Given are questions related to heat transfer. 1. In this experiment, heat is transferred by ____ and…

Q: To solve heat conduction equation, we have assumed O steady case O all of the above O constant…

A: The heat conduction equation is based on the Fourier law. It states that the heat transfer per unit…

Q: 1- A solid infinitely long cylinder, radius 2 cm, has uniform internal heat generation. The…

Q: The inner and outer surfaces of a 5m x 10m brick wall of thickness 30 cm and thermal conductivity…

A: As per given question Determine the rate of heat transfer through the wall, in W. [Note: State all…

Q: Heat conduction is a physical process analogous to mass advection.

A: FALSE

Q: Q2/ Choose the Correct Answer: 1-The heat transfer is not constant when: (b) temperature decreases…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: If the unit of heat flux is [X] and the unit of heat transfer rate is [Y] None of the above. [X]…

Q: A rod of square cross section (4 inch by 4 inch) and 10 feet long is buried in the ground. The rod…

A: Heat transfer is the form of energy that transfers from one system to another system by the virtue…

Q: A slab 20 inch thick is made up of a material having a thermal conductivity of 33 Btu/hr-ft-°F. The…

Q: A spherical container ( k= 30 W/moC ) with inner radius r1 = 2 m and outer radius ro=2.1 m is is…

A: Write the expression for the heat equation and the boundary conditions.

Q: Heat transfer through the walls can be considered as steady under the assumption that the highest…

A: Given :- Heat transfer through the walls can be considered as steady under the assumption that the…

Q: A building consists of two zones A and B (see Figure 5.5). Only zone A is heated by a furnace, which…

Q: A truncated cone 30 cm high is constructed of aluminum. The diameter at the top is 7.5 cm, and the…

A: Given Data: The height of the truncated cone is h = 30 cm. The diameter of the top is d = 7.5 cm…

Q: 3-The temperature distribution across a wall 0.3 m thick at a certain instant of time is as T(x) = a…

Q: A hollow cylinder 6 cm internal diameter and 12 cm outer diameter has a heat generation rate of 5 ×…

A: Heat transfer can be carried out by three phenomenon 1) Conduction 2) Convection 3) Radiation

Question

100%

Choose the right answer

2. The radial heat conduction through a hollow cylinder increases as the ratio of outer
radius to inner radius
a. increases
b. remain the same
c. decreases

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1:Introduction

VIEW

Step 2: Explanation

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2.34 Show that the temperature distribution in a sphere of radius . made of a homogeneous material in which energy is released at a uniform rate per unit volume , is
A plane wall 15 cm thick has a thermal conductivity given by the relation k=2.0+0.0005T[W/mK] where T is in kelvin. If one surface of this wall is maintained at 150C and the other at 50C, determine the rate of heat transfer per square meter. Sketch the temperature distribution through the wall.
1.76 Explain a fundamental characteristic that differentiates conduction from convection and radiation.
2.2 A small dam, which is idealized by a large slab 1.2 m thick, is to be completely poured in a short Period of time. The hydration of the concrete results in the equivalent of a distributed source of constant strength of 100 W/m3. If both dam surfaces are at 16°C, determine the maximum temperature to which the concrete will be subjected, assuming steady-state conditions. The thermal conductivity of the wet concrete can be taken as 0.84 W/m K.
2.44 To determine the thermal conductivity of a long, solid 2.5-cm-diameter rod, one half of the rod was inserted into a furnace while the other half was projecting into air at . After steady state had been reached, the temperatures at two points 7.6 cm apart were measured and found to be and , respectively. The heat transfer coefficient over the surface of the rod exposed to the air was estimated to be 22.7 . What is thermal conductivity of the rod?
1.10 A heat flux meter at the outer (cold) wall of a concrete building indicates that the heat loss through a wall of 10-cm thickness is . If a thermocouple at the inner surface of the wall indicates a temperature of 22°C while another at the outer surface shows 6°C, calculate the thermal conductivity of the concrete and compare your result with the value in Appendix 2, Table 11.
1.37 Mild steel nails were driven through a solid wood wall consisting of two layers, each 2.5-cm thick, for reinforcement. If the total cross-sectional area of the nails is 0.5% of the wall area, determine the unit thermal conductance of the composite wall and the percent of the total heat flow that passes through the nails when the temperature difference across the wall is 25°C. Neglect contact resistance between the wood layers.
2.29 In a cylindrical fuel rod of a nuclear reactor, heat is generated internally according to the equation where = local rate of heat generation per unit volume at r = outside radius = rate of heat generation per unit volume at the centerline Calculate the temperature drop from the centerline to the surface for a 2.5-cm-diameter rod having a thermal conductivity of if the rate of heat removal from its surface is 1.6 .
The heat transfer coefficient between a surface and a liquid is 57 W/(m2K). How many watts per square meter will be transferred in this system if the temperature difference is 10C?
Energy transfer by conduction is primarily restricted to liquids fluids gases solids Which is correct?
Two cylindrical metal rods-one copper, the other lead-are connected in parallel with a temperature of 22.0 ∘C at one end and 113 ∘C at the other end. Both rods are 0.640 mm in length, and the lead rod is 2.76 cm in diameter. If the combined rate of heat flow through the two rods is 33.1 J/s , what is the diameter of the copper rod?
A truncated cone 30 cm high is constructed of aluminum. The diameter at the top is 7.5 cm, and the diameter at the bottom is 12.5 cm. The lower surface is maintained at 93°C; the upper surface, at 540°C . The other surface is insulated. Assuming one dimensional heat flow, what is the rate of heat transfer in watts?