The outer surface of a long cylinder is kept at a constant temperature. There is no heat generation inside the cylinder. Accordingly, which of the following is correct. a.Temperature inside the cylinder increases linearly with the radius b.Temperature inside the cylinder decreases linearly with the radius c.Temperature inside the cylinder is independent of the radius d.Temperature inside the cylinder changes logarithmically with the radius e.none

The outer surface of a long cylinder is kept at a constant temperature. There is no heat generation inside the cylinder. Accordingly, which of the following is correct. a.Temperature inside the cylinder increases linearly with the radius b.Temperature inside the cylinder decreases linearly with the radius c.Temperature inside the cylinder is independent of the radius d.Temperature inside the cylinder changes logarithmically with the radius e.none

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter2: Steady Heat Conduction

Section: Chapter Questions

Problem 2.26P

See similar textbooks

Similar questions

1.10 A heat flux meter at the outer (cold) wall of a concrete building indicates that the heat loss through a wall of 10-cm thickness is . If a thermocouple at the inner surface of the wall indicates a temperature of 22°C while another at the outer surface shows 6°C, calculate the thermal conductivity of the concrete and compare your result with the value in Appendix 2, Table 11.
A plane wall 15 cm thick has a thermal conductivity given by the relation k=2.0+0.0005T[W/mK] where T is in kelvin. If one surface of this wall is maintained at 150C and the other at 50C, determine the rate of heat transfer per square meter. Sketch the temperature distribution through the wall.
All of the following are taken into account on a heat gain calculation except A. exterior walls. B. partition walls. C. basement floors. D. top-floor ceilings.
The outer surface of a long cylinder is kept at a constant temperature. There is no heat generation inside the cylinder. Accordingly, which of the following is correct. a)Temperature inside the cylinder increases linearly with the radius b) The temperature inside the cylinder decreases linearly with the radius c) Temperature inside the cylinder is independent of the radius d) Temperature inside the cylinder changes logarithmically with the radius e) none
The fin efficiency is defined as the ratio of the actual heat transfer from the fin to a. The heat transfer from an equivalent fin which is infinitely long b. The heat transfer through the base area of the same fin c. The heat transfer from the same fin with an adiabatic tip d. The heat transfer from the same fin if the temperature along the entire length of the fin is the same as the base temperature
Shape factor for a cylinder whose length equals its diameter is 1.5 B. 0.5 1.0 D. 2.0
In a glass plant in Cavite, a furnace has fire-brick walls made up of the following two materials in series : Non-corrosive brick as inner layer (material 1) Clay brick as outer layer (material 2) Thickness 4.5 inches 8 inches Thermal conductivity k1 k2 The temperature inside the furnace (inside wall surface of the non-corrosive brick) is found to be 1105 oF while the outside temperature (outside wall surface of clay brick) is 365 oF. This is not the desired temperature inside the furnace so engineers thought of lagging the furnace walls with another material to reduce heat loss. The additional lagging material consists of magnesia layer which is 2 inches thick and has a thermal conductivity of 0.04 Btu /h.ft.oF. During a test run on the furnace with the magnesia lagging material now, new temperature readings were recorded : Point of measurement Temperature reading Inside furnace (inside wall surface of non-corrosive brick 1355 oF Interface between…
Thermodynamics A hollow cylindrical insulation of inside diameter 0.2 m and outside diameter 0.4 m conducts heat radially. If another layer of insulation of the same material of thickness of 0.4 m is added, the heat flow wil be changed by what ratio?
A truncated cone 30 cm high is constructed of aluminum. The diameter at the top is 7.5 cm, and the diameter at the bottom is 12.5 cm. the lower surface is maintained at 93 o C; the upper surface, at 540 o C. The other surface is insulated. Assuming one dimensional heat flow, what is the rate of heat transfer in watts?
What will be the rise in temperature in 30 minutes of a block of copper of 500-gram mass if it is joined to a cylindrical copper rod 20 cm long and 3.0 mm in diameter when a temperature difference of 80 degree Celsius is maintained between ends of the rod? The thermal conductivity of copper is 1.02 cal/cm2-sec-°C/cm (neglect heat losses). Please include FBD
Question 1.2:Consider heat loss through the two walls of a house on a winter night. The walls are identical, except that one of them has a tightly fit glass window. Through which wall will the house lose more heat? Explain. (03)
A metal spoon and a wooden spoon are left overnight in a room. Why do we feel colder when we touch the metal spoon than when we touch the wooden one? a. Since metals usually have a lower heat capacity than non-metals, the metal spoon loose more heat to the room and consequently has a lower temperature b. Metals release heat faster than non-metals because of their higher thermal conductivity c. This is merely psychological since we are conditioned to think of metals as “cold” d. Metals absorb heat faster than non-metals because of their higher thermal conductivity