21. A block of mass m = 2 kg is attached to the ends of two identical springs and rests on a frictionless surface, as shown. No force act on both springs in the position shown. If the mass is moved a little to the right and then released, what will be the frequency of the oscillation? k-200 N/m k = 200 N/m m A) 2.25 Hz B) 3.50 Hz C) 1.60 Hz D) 1.75 Hz

21. A block of mass m = 2 kg is attached to the ends of two identical springs and rests on a frictionless surface, as shown. No force act on both springs in the position shown. If the mass is moved a little to the right and then released, what will be the frequency of the oscillation? k-200 N/m k = 200 N/m m A) 2.25 Hz B) 3.50 Hz C) 1.60 Hz D) 1.75 Hz

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

6.4. A force of 300 N is sufficient to keep a 100-kg wooden crate moving at constant velocity across a wooden floor. What is the coefficient of kinetic friction?
1) An electric motor’s torque is a function of the speed at which it rotates. Many brushed AC motors have a linear toque curve as shown below. If the power output of the motor is equal to the torque (T) multiplied by the rotational speed in rad/s (w), what is the maximum power you can get out of the motor if the stall torque (Tstall) is 0.001 Nm and the no load speed (wno load) of 10,500 RPM? Give answer in Watts.
Machine Theory Question-1 a) A flywheel is attached to the engine so that the rotational speed of the engine remains between 100 and 110 r/s. If the energy fluctuation is 1.05 KJ here, find the inertia of the flywheel.
According to Newton's 3rd Law, an action and reaction are equal in____. weight shape size
1. A double-acting air compressor has 18 x 12 inches, 626 rpm. Determine the volume displacement in ft^3/min Answer in whole number 2. An air compressor piston displacement is 6,308 cm^3/min when operates at 964 rpm and volumetric efficiency of 75 %. Determine the capacity of air compressor in cm^3 per min.
The data provided by a company for the year 2020 – 2021 to carry out Break Even Analysis and provide them the results, complete analysis and suggestions. The data is as follows:Building rent 20000 R.O Every month instalments 30000 R.OThe estimated sales are 750000.0 R.OMaterial Cost / unit 15.0 R.OProduction cost / unit 8.0 R. OTransportation & other Costs / unit (Approx) 4.00 R. O Maintenance cost / unit 1.5 R. O Salary of the employees / unit 0.8 R.OMarketing and advertisement cost / unit 0.7 R. OEach unit is sold at price 35.0 R. O Construct the B.E.P chart on a graph sheet and indicate, B.E.P, M.o.S and also indicate the new B.E.P & M.o.S after the improvement measures has been taken (With different colours). Show the calculations for the following parameters separately before and after the measures taken.1. Determine the B.E.P2. Determine the profit 3. Margin of safety.Also write your decisions taken to improve the profits of the company and to reduce the B.E.P.
Vibration Engineering: Mass = 10 kilogramsSpring constant = 400 Newtons per meterPeriodic Force = 6 KilonewtonsForcing Frequency = 5 radians per secondDamping coefficient = 200 Newton second per meter Calculate: (Express the final answer in 4 significant digits) -the phase angle in radians -the natural frequency in radians per second -the amplitude of steady-state vibration in meters
It describes the rate at which an object rotates and the direction it rotates. A. Angular acceleration B. Angular displacement C. Angular velocity D. Angular position
A wind turbine has the maximum power output at the rated speed of 12 m/s and a rotor diameter of 82 meters. The cut-in and cut-out speeds for this type of wind turbine are 4 m/s and 23 m/s, respectively. The table below shows the annual wind data near a potential site for setting up a wind farm using this type of wind turbine and the power coefficient of the wind turbine at the specific wind speed. The air density is 1.22 kg/m3. (a). What is the maximum power output of this wind turbine, assuming Betz limit? (b). What is the average power output if the wind turbine is installed at this site?. (c). What is the capacity factor of the wind turbine at this site? (d). If a wind farm consisting of 100 such wind turbines is built at the site, how much energy does this wind farm generate in a year (in the unit of kWh)? (e). Is this a good site for using this particular type of wind turbine?
A physics lab consists of a large ball attached to a wire. Students hold on to one end of the wire, then whirl the ball around in circles and count the number of rotations per second. One group finds these numbers: ball mass= 320 gram, wire length= 1.3m, number of rotations/sec=2.5. The wire is made of steel with a diameter of 1mm and a Young's modulus of 20x10^10 N/m^2.How much does the wire stretch due to the tension on it? Should the students correct their data for the wire stretching?
The equivalent spring stiffness of an inclined spring whose k = 5 N/m and angle of inclination θ = 35° 3.355 N/m 4.095 N/m 5.867 N/m 4.511 N/m
A replacement electricmotor is being considered for purchase. It is capable of providing 176.68 hp. The data: Cost $3,178.65 Maintenance cost per year 201.74 Useful Life 14 years Salvage value $2,135.30 The motor is used for 400 hours/year and the cost of electricity is $0.06/kW*h (1 hp = 0.746 kW). What is most nearly the present worth using an interest rate of 10%?