- 22 1011 - 1012 +3812 812 12 13 - 413 + 141 3 24 -0

Q: 2. Design a clamper circuit to perform the function indicated. Vin 10 V -10V + Vin DESIGN + Vout…

A: We need to design a clamper circuit for given input and output waveform . We will design it with the…

Q: If the no load secondary voltage of a 1-phase transformer is 235 V and full load secondary voltage…

A: Given: A single phase transformer has, The no load secondary voltage, V2nl=235 V. The full load…

Q: The terminal p.d. of a d.c. source is 22.5V when supplying a load current of 10 A. If the emf is 24V…

A:

Q: 9. Use Norton to find Vo. 36 V 12 ΚΩ ΜΕ 24 ΚΩ www 2 ΚΩ www 10 ΚΩ Μ M Φ 3 mA ΙΚΩΝ Vo

A:

Q: Determine and sketch Vout for one complete cycle.

A: Given- Source sinusoidal wave with peak voltage = 15V To find- Output voltage for given circuit= ?

Q: The Laplace's equation in Cartesian coordinate is equal to (a^2 V)/(x^2)+(3^2 V)/(y^2)+(3^2 V)/(dz^2…

A: We need to tell about Laplace equation , whether the given statement is true or false

Q: Question 1 ( (a) Find the transfer function, G(s)= for the network shown in Figure 1. Solve the…

A: As per Bartleby guideline we need to answer the first question. Kindly repost the rest questions…

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A:

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A: Base current fluctuation with base-emitter voltage is an input characteristic. The fluctuation of…

Q: R₁ = 52 દે 1₁ род ↑ Vab Va R₂= гол 4 A

A:

Q: = For the base bias circuit shown in figure, ßnc = 85. Determine: IB, IC and VCE. R₁ 100 ΚΩ Vcc +12…

A: We need to find out the base current and collector current and collector to emitter voltage for…

Q: 1. When the inputs to an exclusive-OR circuit are alike, the output is binary 2. An exclusive-NOR…

A:

Q: 8.the letter D on the D flip flop stands for? 9. it is a logic circuit that is known for being time…

A: In this question,  We need to define the D flip flop.  We are discussing about the logic circuit…

Q: 2. Given the system below, determine K. in N/m and M. in kg so that the % Overshoot is 25% and the…

A:

Q: 1. Determine Vx. LOV (+ 202 M 202 2VX +- + 52 Ux

A: Given, The circuit is,

Q: Computed (Show complete solutions.) 1. Using the value of the DC power supply as the theoretical…

A: Given  DC Power Supply = 15 V   R1 = 10 ohms   R2 = 50 ohms   R3 = 75 ohms

Q: The total resistance of two resistors connected in series is 50 ohms. When connected in parallel,…

A:

Q: Find the power factor and apparent power unla cun v(t)=160 cos (377 t+10 grados) nos cuando se le…

A:

Q: x(t) e-i ²nft dt X (f) = -0 the Fourier transform of x(t) = 2 sin (5 лft) the signal of x(t) in the…

A:

Q: State Kirchhoff’s Current Law.

A:

Q: A large room is illuminated by twenty 150 watts lamps and thirty 100-100 watts lamps. If the…

A:

Q: 1. A single phase overhead transmission line delivers 4000 kW at 11 kV at 0-8 p.f. lagging. If…

A:

Q: ! Find I using Nortons then check by I any method. 14V. 2. 2.) 18V- 100, SL M 200-22 Ikr M. 3w.nz…

A:

Q: The magnetic field intensity outside the ? coaxial cable is H = 00 H = NV/DO H = 1p/2 pi a^20 H =…

A: Given  The magnetic field intensity outside the coaxial cable is.....

Q: WHAT IS THE MODULO OF THE CIRCUIT? WHAT IS THE OUTPUT (IN BINARY) AFTER 738 PULSES?

A: The modulo of the circuit is based on the number of flip-flops used to design the circuit. The given…

Q: S' R' A. From an Active Low SR Latch, Draw the normal and complemented output.

A: Given: Inputs S' and R' for active Low SR Latch.  To do: Draw normal and complemented output of…

Q: The AC EMF in this electric circuit is described by the following equation: ε = 30Ve¹(20) What is…

A:

Q: 3. Find the node voltages v₁, v₂, and v². 1 4Q www 20 www 30 V 2 Hi 202 www. 15 A www Supe 3 802

A:

Q: 14 A circuit of resistance 402 dissipates a power of 16W. Calculate (a) the current flowing through…

A:

Q: Find the power factor and apparent power v(t)=160 cos (377 t+10 grados) Onios Cuando se aplica un…

A:

Q: 4. Estimate the distance over which a load of 15000 kW at 0-85 p.f. can be delivered by a 3-phase…

A:

Q: A transformer takes 5,175 watts at a power factor of 0.85 when connected to a 2,300 volts…

A: Given, Active power taken by the transformer ,P=5175 watt. Operating power factor,Cos∅=0.85 Applied…

Q: The impulse function is :denoted by S(t) O u(t) O h(t) O u(t) or 8(t)

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is…

A: Given: Reactance = 1 PuVs=Vr= 1 PuPactive = 0.5 Pu Find: Load Angle ( δ ) = ?

Q: Does the following discrete system have the parameter of memory, y[n] = x[n-1] + x[n] ? O Maybe O…

A: Q.1) Memory system:-  A system is said to be memory system if its output is depends on past or…

Q: A field effect transistor operates with a drain current of 100 mA and a gate-source bias of-1V. The…

A: Grain current = 100 mA Gate to source bias = -1V gfs = 0.25 We have to determine the change in drain…

Q: 6. Determine Vo using mesh analysis. 30V 24V 182 Il 922² + + 14 1022 12 122 13 2002⁰ +48V

A:

Q: In the circuit shown in the given figure, a current of 5A flows from the supply source. Switch S is…

A: Current = 5A Inductance = 2 H Resistance = 10 Ω

Q: A coil takes a current of 2A from a 12V d.c. supply. When connected to a 240V, 50 Hz supply the…

A:

Q: (coso) (17) find the Power factor of the following clf. 452 w mmmm 355 Trizs Iter

A:

Q: Determine the system function of the discrete system described by difference equation y(n)-1/2…

A:

Q: 8. Let x(t) = e'u(-t) and h(t) =rect (¹2¹). Determine y(t) = h(t) *x(t) graphically. Write the…

A: According to the question, we need to find the value of y(t). yt=xt*ht;xt=et.u-t;ht=rectt-12;

Q: Example 14.52. An inductor of resistance 10 and inductance 100 mH is in parallel with a 10 nF…

A: Given: An inductor coil of Resistance : R=10 ohm  and L=100 mH=0.1 H is in parallel with a 10nF…

Q: A)What will be the frequency at C if the clock is 320 kHz? B) What is the modulo of the circuit?…

A: Answer:- A) From the given digital circuit , input to the every JK flip flop is 1. So, J =1 and K=1.…

Q: analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz. The…

A: We need to find out number of bits per sample , first we will find out the number of level then we…

Q: What is the step by step procedure to use light meter

A: Procedure to use Light Meter Part 1: Setting up an Analog Light Meter            There are various…

Q: he no load secondary voltage 1-phase transformer is 232 V and full load secondary voltage is 222 V,…

A: Given, VNL= 232 V VFL= 222 V % regulation = ?

Q: n = p = n₁ = √N₁N₁ exp(- Ec N₂ 2KT

A: We need to prove the given electron and hole concentration equation for semiconductor .we will use…

Q: Example 12.36. A capacitor of capacitance 10 uF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C =10 μfδ = 10∘f = 50 Hz Find:. Power Factor Angle φcPower Factor cosφc

Q: A 10 ohms and a 20 ohms resistance are connected in parallel and a 5 ohms is connected in series…

A: