26821 lbm/h of a 80 weight % H2SO4 solution in water at 120F is continuously diluted with chilled water at 40F to yield a stream containing 50 weight % H2SO4 at 140F. What is the rate of heat transfer in Btu/h for the mixing process? Assume that the chilled water is saturated liquid.

Q: The reactants A form the product D and E at 1620 K. for a reaction rate expressed in gmol/L.s and…

A:

Q: 2. For the manometer shown, the manometric fluid is mercury and the other fluid on both pipes A and…

A:

Q: er, 4 mm thick, k-120 W/m. C disc is welded to 10 (heater). The system is exposed to air at 20 °C,…

A:

Q: tate results in: CA cosh I

A:

Q: In a plug flow reactor, a gaseous feed of pure A (2 mol/L, 100 mol/min) decomposes to give a variety…

A: Write the reaction as follows: A→2.5 products   The concentration of pure A, CA0 = 2 mol/L The molar…

Q: A solution of sodium hydroxide leave a dissolver at 100°C and it's to be cooled to 40 °C, using…

A: Note: We are not authorized to provide handwritten solutions, please follow the typed solutions. A…

Q: Calculate the theoretical flame temperature of a gas having 20% CO and 80% N2 when burnt with 150%…

A:

Q: Calculate the theoretical power for a pseudo plastic liquid

A:

Q: A certain gasoline gives a hydrometer reading of 66.5 oBaume at 15.6 oC. Using the Bureau of…

A:

Q: Q4) Consider a 20-cm-thick large concrete plane wall (k = 27°C and h1 = 5 W/m². 12 W/m² °C on the…

A: Given Data The thickness of concrete = 20 cm = 0.2 m Thermal Conductivity of concrete (k) = 0.77…

Q: A midsize steam-methane reforming plant is consuming methane at a rate of 125,000 mol/h and…

A:

Q: 1. If the atmospheric pressure is 101.325 kPa and the absolute pressure at the bottom of the tank as…

A: Given Data Atmospheric Pressure, PT= 101.325 kPa Pressure (absolute) at the bottom, PB = 250.50 kPa…

Q: An ordinary octane gasoline (C8H18) is to burn inside an internal combustion engine cylinder with 50…

A: Basis: 1 kg of octane gasoline (C8H18) The mass of fuel mf = 1 kg = 1000 g Molecular weight of C8H18…

Q: Natural gas composed of 60. mol% methane, 30. mol% ethane, and 10. mol% propane at 25 C and 500.…

A: Given that, for natural gas- Methane, CH4= 60 mol% Ethane, C2H6= 30 mol% Propane, C3H8= 10 mol%…

Q: 68: A fluid flows over a heated horizontal plate maintained at temperature Tw. The bulk temperature…

A:

Q: A steam pipe of i.d. 7.62cm and o.d. 10.2cm passes 1360 kg/hr of superheated steam at 260°c. The…

A: Given, The inner diameter of the pipe, di = 7.62 cm The outer diameter of the pipe, do = 10.2 cm The…

Q: 18. A homogeneous reaction ((R→ P) occurs in a batch reactor. The conversion of the reactant R is…

A:

Q: Benzene is stored in a tank. The pressure in the tank is 12 bar and the temperature is 375 oC.…

A: Given that- Temperature, T=3750C=648 K Pressure, P=12 bar= 1.2x106 Pa Volume of tank V= 1 m3…

Q: 10) A Petronas gas pipeline is delivering natural gas from a Petronas Gas processing Plant located…

A:

Q: A gas at T = 200 deg C is to be isothermally compressed from 10 bar to 20 bar in a cylinder.…

A: Temperature = 200 0C or 473.15 K Initial pressure, P1 = 10 bar Final pressure, P2 = 20 bar B = -388…

Q: Q8. In the reaction of hydrolysis of ethyl acetate in acid medium, the rate constant at 40°C is…

A:

Q: Exercise 4.1: CSTR Design Using Damköhler Number (Da) The elementary reversible reaction A + B 2 C…

A: A reversible, elementary reaction is carried out in a CSTR.

Q: 4. Consider the tank illustrated below where the density if the fluid is p. The resistances R₁ and…

A: According to question we have figure Where ρ-density qmi-inflow rate R1 and R2-Linear resistance…

Q: Five hundred kilograms of an aqueous feed containing 50 mass% acetone is contacted with solvent…

A: Given, The feed, F = 500 kg The mass percent of acetone in feed, zc = 0.5 The ratio of feed to…

Q: 10.3% and flows at the rat alculate: ressure of each component.

A:

Q: 9. If the rate of reaction is independent of the concentration of the reactants, the reaction is…

A: 9) In some reactions, the rate is apparently independent of the reactant concentration. The rates of…

Q: 100 mols per second of ammonia (NH3) is burned with 20% excess O2 based on fresh ammonia feed)…

A:

Q: A Carnot refrigerator has tetrafluoroethane as the working fluid. The cycle is the same as that…

A:

Q: Question Two Its required to pump a liquid of specific gravity (1.26) and dynamic viscosity of (15)…

A: Given: SG = 1.26  Density of liquid ρ = SG×ρwaterρ =1.26×1000ρ =1260 (kg/m3) Q = 22 L/sQ = 0.022…

Q: . A tank with a capacity of 2m³ (2000 liters) is initially full of pure water. At time t = 0, salt…

A:

Q: Which of the following pairs of metals would show the highest rate of corrosion in seawater and why?…

A: The correct answer is to be identified.

Q: I apologize upfront, but I do not understand the solutions here. I cannot follow along due to the…

A: Note: We are not authorized the provide the handwritten solution, please follow the typed solution.…

Q: Determine the energy loss if carbon tetrachloride at 25°C flows 250 m through a standard DN 100-mm…

A: Given: The inner diameter of a 100 mm Schedule 40 pipe is equal to D = 102.26 mm = 0.102 m The…

Q: An ideal Rankine cycle operates between tboiler P = 15 MPa and condenser P = 15 kPa. If the inlet T…

A: Temperature at the entrance of turbine, T1 = 773 K or 500 0C Pressure at the inlet of turbine, P1…

Q: A fuel of 20 oAPI at a temperature of 15.6 oC has a HHV of 44240 kJ/kg. Determine a) the HHV, in…

A: Given Data HHV= 44240 kJ/kg Temperature = 15.6 oC oAPI = 20o To find a) the HHV, in kJ/litter b) the…

Q: Franco is being drawn to design an evaporator that would remove water in an aqueous sodium…

A: Given that- for a triple effect evaporator with forward feed flow mechanism. Required achievement=…

Q: 2. According to the wettability picture, answer the following questions: a) The wettability for…

A: With the help of wettability picture, Find a)Wettability for both figures b)Factors that affect…

Q: People use 502 lb polystyrene (M = 30200 g/mol) dissolved in 4060 lb styrene (M = 104 g/mol). Find…

A:

Q: TRUE OR FALSE? Residual volume and residual enthalpy can be derived from Gibbs free energy as they…

A: Residual volume and residual enthalpy can be derived from Gibbs free energy as they are found in…

Q: Make a flow chart of the process, showing all the steps in the process and labeling all of the input…

A:

Q: CHAPTER 10 10-15 Water is to be boiled at atmospheric pressure in a mechanically polished steel pan…

A: Given:  Water is to be boiled in a polished pan of d = 30 cm or 0.3 m at atmospheric pressure. At…

Q: percentage of O₂ on a wet basis.

A:

Q: Example: Solid particles: m, = 300 kg, A = 0.3 m², Calculate LMFI APMF and VOMF D₁ = 0.12 mm, $, =…

A: Given data: Density of particles, ρ = 1000 kg/m3 Diameter of particles, DP = 0.12 mm Mass of solids,…

Q: mm thick, k-120 W/m. C di is exposed ter). The system PC. Calculate the rate of heat

A:

Q: A stock containing 1.526 kg moisture per kg dry solid is dried to 0.099 kg moisture per kg dry solid…

A:

Q: Air enters a rectangular duct measuring 30 cm x 40 cm with a velocity of 8.5 m/s and a temperature…

A:

Q: 10-32 A 1-mm-diameter nickel wire with electrical resis- tance of 0.129 2/m is submerged…

A: Given details: Diameter of wire, D=1 mm =0.001 m electrical resistance of wire , R=0.129 ohm/m…

Q: A wet sphere of gelatin gel at a temperature of 20 "C contains a uniform concentration of urea of…

A:

Q: A bituminous coal has the following compositions: C = 71.6 %, N2 = 1.3 %, A = 9.1 %, H2 = 4.8 %, S =…

A: Given data: C = 71.6 %, N2 = 1.3 %, A = 9.1 %, H2 = 4.8 %, S = 3.4 %, W = 3.5 %, O2 = 6.3 %.…

Q: Nitric oxide (NO, MW=30.1)(NO, MW=30.1) reacts completely with gas phase water to form ammonia…

A: base temperature T = 155 C. mass flow rate of NO = 2.48 g/s molar flow rate of NO in feed = (2.48…