29a. Up hill climb. A workman pushes a 111-lb load of dirt up an incline (ramp) whose slant length is 2.67 m and vertical height is 1.27 meters. What are the resistance force and minimum effort force needed to lift the load? INCLINED PLANE Resistance Effort Force 29b. If the efficiency of the ramp is actually 74.4%, what are the IMA, AMA, and actual IMA effort force E needed to move push the load up the ramp? AMA Effort Force

29a. Up hill climb. A workman pushes a 111-lb load of dirt up an incline (ramp) whose slant length is 2.67 m and vertical height is 1.27 meters. What are the resistance force and minimum effort force needed to lift the load? INCLINED PLANE Resistance Effort Force 29b. If the efficiency of the ramp is actually 74.4%, what are the IMA, AMA, and actual IMA effort force E needed to move push the load up the ramp? AMA Effort Force

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q5 A pull of 20 N at 30 ° to the horizontal is necessary to move a block of wood on a horizontal table . If the coefficient of friction between the bodies in contact is 0.25 , what is the weight of the block ?
A brand-new pick-up truck was driven and tested on a national highway. Due to a very light traffic, 8hp is highly required to drive the said vehicle with a mass of 1800kg at a speed rate of 60kph. Consider the friction and air resistance. a) How much power is needed in order to drive the truck at a same rate up a 10% grade (a hill rising 10m vertically in 100m horizontally)? (in hp)b) Meanwhile, how much power is required for the truck still at a same rate down a 1% grade? (in hp)
an electric motor driven conveyor belt is required to take 2,200 pounds of dirt, rocks per minute from an excavation site and raise it 15 ft vertically. If all friction in the machinery is neglected, what HP of motor is required?
A winch mechanism with a handle length of 30 cm and a drum diameter of 8 cm isused to lift a 45 kg load.a. What is the VR of the winch?b. If 73.5 N of force is required to lift the load, what is the MA?c. What is the mechanical efficiency of the winch?d. How many turns will be required to lift the weight 0.85 meters?
Show the fbd/figure, given and formula used. The engine of a motorboat delivers 40 hp to the propeller while the boat is moving at 10m/s. What would be the tension in the towline if the boat were being towed at the same time?
A ship with vertical sides near the water line, weighs 40 MN and draws 6.7 m in salt water (specific gravity = 1.026). Discharge of 2 MN of water ballast decreases the draft to 6.4 m. What would be the draft d of the ship in fresh water?
A car delivers 160 hp to a winch used to raise a load of 1260 kg . Determine the maximum speed of lift.
A Hydraulic press has a ram of 30 cm diameter and a plunger of 2 cm diameter. It is used for lifting a weight of 35 kN. How much force is required at the plunger? a. 311.1 kNb. 466.6 kNc. 233.3 kNd. 155.5 kN
A tractor is needed that can pull a drawbar force of 1,000 lbf at 4 mph in a soil that allows a tractive efficiency of 0.75. What brake horsepower tractor is required if there is 10% power loss between the engine and final drive of the rear axle?
Brigde was designed for ten years , and during the first four years was designed to carry 10 millions cars and one hundred thousand lorries ,at second four years was designid to cary 15 millions cars and two hunderd cars and during last two years was disigned to cary Smillions cars and one hunderd cars. Each car has fatique life of 10° cycles and each lorry of 10° cycles . Determine the brigde fatique life
A rope 17 cm is suspended between two hooks, 13 cm apart and at the same level. What is the pull on each hook, if a weight of 450 N is hanging 5 cm from the right hook?
6. A 5 lbm ball starts rolling up a 30deg incline at speed of 20 ft/s. Using conservation of energy, find out how much power(hp) gravity does on the ball when it travels from the bottom to the maximum height considering time consumed is 5s.