Answered: = 2cosa y°i – yx²j V considering the…

= 2cosa y°i – yx²j V considering the density constant, find an expression for the pressure gradient in the x and y direction.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter4: Numerical Analysis Of Heat Conduction

Section: Chapter Questions

Problem 4.41P

See similar textbooks

Related questions

Q: Find the capillary rise ( h) in the tube shown in the figure for a water-air-glass interface with =…

Q: Q8:Find the value of the hydrostatic force and the direction and the position of (c.p.) on the…

Q: 4. The figure shows two cylinders of diameter D and 2D, connected to each other and containing an…

A: PRESSURE AT A=PRESSURE AT B Pa=Pb W2/A2=W1/A1 (1) where, A2=(2D)2π/4 A1=(D)2π/4

Q: The semicircular plate in the picture is 5 [ft] long and acts as a gate in a channel. The fluid is…

A: Given:

Q: 5. Calculate the net hydrostatic force per unit width on the rectangular panel AB and its location…

A: Answer: ◆The net hydrostatic force per unit width on the rectangular panel AB is 28.88304 kN. ◆ It's…

Q: Determine the location of the total hydrostatic force from thr bottom surface and the top surface…

A: Given DataPair=32kPaPoil=0.85×1000×9.81×1=8338.5Pa=8.338kPa…

Q: 2. If the bulk modulus for water at 70°F is 319 , determine the change in pressure required to in…

Q: The container is filled with water and air. The parameters are given in the figure. Determine the…

A: Given: There are two components in the container. One is water and the other is air. Because:…

Q: The viscosity of water at 70C is 0.000402 Pa-s. Determine the kinematic viscosity in m2/s and in…

Q: 3. The density p of a fluid varies with depth h, although its bulk modulus K can be assumed…

Q: Q2) Find the liner acceleration to the left that make the shape of the water in the tank as shown in…

Q: 3. A small drop of water at 80° F is in contact with the air and has a diameter of 0.0200 in. If the…

A: As per our guidelines we are supposed to solve only one question if multiple questions are asked .…

Q: When a liquid of volume 4 liter is subjected to an additional pressure of 5 x 107 N/m2, the change…

Q: An open tank contains 5.8 m of water covered with 3.2 m of kerosene (y = 8). Find the pressure (kPa)…

A: Given Data - In Open tank Water up to a depth of 5.8m cover with kerosene with a depth of 3.2m The…

Q: Obtain

Q: Caleulate the force F required to Keep the paraboli gate in static equilibrium shown in the Fiqure.…

A: given; a=8.8mb=4.8mwidth(w)=2mspecific gravity (SG)=8.4

Q: A = A . [1-x/ (2 L) ] Densityp L

A: Take a strip of thickness dx at a distance x. Then the force acting on the strip is,…

Q: 10. For the window shown below, find the resultant force on the gate and the location of the center…

Q: 3 sho + |니 31 tat

A: x¯= is the vertical distance of center of gravity x¯= 3+42 =5 m force in horizontal direction FH=…

Q: : Determine the pressure difference between the two points in figure below Oil (S=0.75) X- S =1 S,=1…

A: It is required to determine pressure difference between two points A and B

Q: A diver's watch is rated for 7 atm. If they dive a water with density of 62.4 lbm/ft3, how deep [ft]…

Q: Find the capillary raise of the water in the tube of diameter 2mm, which is immersed vertically in…

Q: A pipe contains oil (density = 850 kg/m 3) at a gauge pressure of 200 kN/m 2 . Calculate the…

Q: 9. The density of saturated vapor refrigerant -134a is expression in the form p= aT + bT +c, (where…

A: Given data :- T1= -15°C , P1= 164kpa T2 = 60 °C , P2 =1683kpa

Q: The capillary rise of water in the :glass tube is given by h= 40/x d. O h=20/x d. O h=60/x d. O h=…

A: Capillary effect When a tube with a radius less than 3 mm is dipped into the liquid then the level…

Q: If the pressure in container A in the given image is 538.55 kPa, compute the pressure in container…

A: Moving upwards negative sign is used moving downwards positive sign is considered with respect to…

Q: A water flows between parallel plates of infinite length. The bottom plate is fixed and the distance…

A: Couette flow In fluid dynamics, Couette flow is the flow of a viscous fluid in the space between two…

Q: Consider a simplified shape of a blood vein branching- similar to the Brachial vein. You like to…

A: V˙1=0.07 L/s=0.07*10-3m3/sr1=7.5 mm=7.5*10-3mP3=1.5 kPar3=4 mm =0.004 mr2=3 mmV˙2=0.02 L/s=0.02*10-3…

Q: Compute the mass for a lamina that occupies the given region and mass density Region bounded by y =…

A: Given data: - The equation y = -x. The equation y = 2x. The equation y = 3. The mass density is…

Q: if the velocity distribution over the plate is given by u = shear stress at y = 0 and y =2m. u + du…

Q: Patients suffering from decompression sickness may be treated in a hyperbaric oxygen chamber filled…

A: Given: The diameter of the cylindrical chamber is D=0.75 m The gauge pressure of oxygen in the…

Q: Oil flows in the boundary layer, as shown in figure. The plate is 1 ft wide perpendicular to the…

Q: Two horizontal plates are spaced 3 in. apart. The space between the plates is filled with mercury at…

A: (a) Write the given data. y=3 invupper=3 ft/s

Q: In a syringe of the figure shown, the drug had density of 900 kg/km' and absolute viscosity of 0.002…

Q: A beaker of height h is filled with a liquid of density p up to a certain limit. The beaker is…

A: Dear student, According to expert guidelines I am allowed to answer only one…

Q: Q4/ the velocity distribution over a plate is given by u= if the viscosity of liquid is 8 poise,…

Q: Q6:Find the hydrostatic force and direction and position of (c.p.) on the inclined submerged surface…

Q: An open container is filled with water to a depth of three metres and then with oil with a density…

A: For solution refer below images.

Q: Q2) When the force P is applied to the plate, the velocity profile for a Newtonian fluid that is…

Q: Evaluate the total force on the gate (unit width) and its direction. (specific weights of Water:…

Q: 2. An open tank contains water up to a depth Of 2 m and aBOVe In an ull UI SP. yr. 0.9 for a depth…

A: Solution is given below.

Q: A liquid flows over the plate as shown in the image below. The liquid behavior as a Newtonian fluid…

Q: 34. The two concentric cylinders shown in the figure are separated by an oil film with viscosity u=…

Q: 9. The density of saturated vapor refrigerant -134a is expression in the form p= aT + bT + c, (where…

A: Given data:- T1= -15°C T2 = 60°C P1=164 kpa P2=1683kpa

Q: A liquid flows over the plate as shown in the image below. The liquid behavior as a Newtonian fluid…

A: Newtons law of viscosity.

Q: The velocity gradient is 1000 / s. The viscosity is 1.2 X 10 -ª N s/m². The shear stress (N/m) *

A: Unit of shear stress is N/m2 and not N/m.

Q: 3) The viscosity of the Newtonian fluid with a density of 650 kg/m3 is determined with a viscometer…

A: Givenρ=650 kg/m3r1=4 cm, r2=6 cmω=6 rad/s, torque, T=3×10-7 N-m

Q: water is supported by a curved gate described by equation y= x. the gate is 5 supported with a…

A: Given , h = 5m , H= 7mLet the tension in string = 'T'Given y = xProjected area = ∫x dy…

Concept explainers

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.

Question

Plz answer ASAP

A frictionless and stable flow field is given
by
+= 2cosa?y°i - yx² j
V
considering the density constant, find an
expression for the pressure gradient in the x
and y direction.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The flow function for a flow field is given as ψ=x2*y-(y3/3).Find the speed potential. Provide detailed information about the current.
The stream function in a two dimensional flow field is given by sie= x2 - y2 .find the magnitude of the velocity at point (1. 1) .
Q1:- (a) Show that stream function exists as a consequence ofequation of continuity.(b) Show that potential function exists as a consequence ofirrotational flow
Can the flow be categorised as scalar potential? Find the scalar potential.
For the velocity field that is linear in both spatial directions (x and y) is V-›= (u, ? ) = (U + a1x + b1y) i-›+ (V + a2x + b2y) j-›where U and V and the coefficients are constants, calculate the shear strain rate in the xy-plane.
For the velocity field that is linear in both spatial directions (x and y) is V-›= (u, ? ) = (U + a1x + b1y) i-›+ (V + a2x + b2y) j-›where U and V and the coefficients are constants, calculate the linear strain rates in the x- and y-directions
The velocity field for a flow is given by V-›= ui-›+ ? j-›+ wk-› where u = 3x, ? = −2y, w = 2z. Find the streamline that will pass through the point (1, 1, 0).
1. Find the velocity field, and volumetric flowrate between two plates ofwidth W and separation distance H when the bottom plate is heldfixed and the top plate is pulled to the right with velocity V . Also findthe force necessary to push the top plate. 2. Now hold both plates stationary, but impose pressure p0 on the left endof the channel, and pressure p0 + ∆p (∆p > 0) on the right end of thechannel. Find the velocity field and volumetric flow rate. 3. What is the volumetric flow rate if you simultaneously move the topplate and impose the same pressure drop? 4. Lid-driven cavity flow is exactly this last situation, except that bothends of the channel are capped off, and the pressure drop is not imposed, but rather arises from the sliding of the lid combined with beingenclosed. What is the pressure drop that arises?
Find the resultant force in the y-direction Fr,y for a volumetric flow rate in the y direction of 100 L/hr, a pressure of 150 kPa, and a diameter of 3 cm. Use the equation Fr, y = -m1y1 - P1A1
2. Find the velocity field and volumetric flow rate for two stationary plates, imposing pressure p0 on the left endof the channel, and pressure p0 + ∆p (∆p > 0) on the right end of thechannel.
If a flow field is characterized by V⃗ = y2zx î+ x2yzt ĵ+ z2 k̂. a) Is the flow steady? b) Local acceleration c) Convective acceleration d) Is the field irrotational? e) Is the flow incompressible?f) All possible strains rates. Are shear forces present in this force field?
Find the stagnation point in the following two-dimensional velocity field: V=(3+x-y)i + (5+x+y)j