=2nd 33 rads 020 03m -03m

Q: The ends of the O.72-m bar remain in contact with their respective support surfaces. End B has a…

A:

Q: For an interval of its motion the piston rod of the hydraulic cylinder has a velocity VA = 4.3…

A: Introduction: The instantaneous center of the velocity of a body is any place on a rigid body or its…

Q: The disk is originally rotating at 8 rad/s. If it is subjected to constant angular acceleration of 6…

A: wo = 8 rad/s alpha = 6 rad/s^2 V=? Answer: 22.0000 ft/s2

Q: The hoop is cast on the rough surface such that it has an angular velocity @ = 4 rad/s and an…

A:

Q: For the mechanism, shown on the figure, v=5 m/s, a =2 m/s²,J60° AB=0,4 m, ZOAB=90° and ZAOB=60° .…

A:

Q: In the position shown, the angular velocity and angular acceleration of bar AB are wAB = 3 rad/s…

A:

Q: the mechanism, shown on the figure, oBC c = const 5 s. %D 3DBC 0,3 m, AB=0,6 m. Determine: elocity…

A:

Q: In the following mechanism, se the vectorial approgch to determine osc and vc if the arm AB has a…

A: The simplest movable closed-chain linkage is a four-bar linkage, commonly known as a four-bar. It is…

Q: Q1) The angular velocity of the radar gun at point O is è = 0.2 rad/s when 0-40°, and the radius of…

A: The given data: θ˙ = 0.2 rad/sθ = 40°Radius of the road = r = 500 m

Q: The center O of the disk has the velocity and acceleration shown in the figure. If the disk rolls…

A:

Q: The disk is rotating with an angular speed of  = 4 rad/s and has an angle of  = 30°. Determine the…

A: Given Data w=4 rad/s r=3 ft

Q: By using both vector and velocity/acceleration diagrams, find the angular velocity and angular…

A:

Q: The ball rolls without slipping on the fixed surface as shown. What is the direction of the velocity…

A: We know that velocity vector is always tangent to the point. As it rolls without slipping hence…

Q: The rigid body is rotating about the y-axis. In the position shown in Fig. (a), the angular velocity…

A:

Q: The body is formed of slender rod and rotates about a fixed axis through point O with the indicated…

A:

Q: The square plate is constrained with the slots at A and B. At the instant when 0= 30°, point B is…

A: Draw the schematic velocity diagram of the square plate.

Q: find an acceleration of the center of the beam (marked as a blue point) which is connecting both…

A:

Q: Consider the thin rectangular plate. At the instant shown, point A has an acceleration of a…

A:

Q: Disc A has a clockwise angular velocity of w= 19 rad/s as shown. Using the Relative Motion Analysis…

A:

Q: the posture shown, slider4is moving tot he left with constant velocity Vc = 2 m nd the angular…

A:

Q: The ends of the 0.63-m bar remain in contact with their respective support surfaces. End B has a…

A: To Find : The angular acceleration of the bar and acceleration at end A. Given :  The velocity of…

Q: If crank AB rotates at a constant speed of Wab=24 rad/s (counterclockwise), calculate the angular…

A:

Q: If rod AB is rotating with an angular velocity WAB = 7 rad/s, determine the angular velocity of rod…

A:

Q: Point A of the circular disk is at the angular position 0 = 0 at time t = 0. The disk has angular…

A: To find: The velocity and acceleration of the point A. Given: The angular velocity of disc is…

Q: The large window in the figure is opened using a hydraulic cylinder AB. If the cylinder extends at a…

A:

Q: The epicyclic gear train consists of the Sun gear A which is in mesh with the planet gear B. This…

A: Introduction: The planetary gear is a gear system made up of spur gears. A central gear, known as a…

Q: 2. The motor on the car wash sprayer rotates counterclockwise at a constant rate of 120 rpm. At the…

A: Vector diagrams use a vector arrow to show the direction and relative magnitude of a vector…

Q: The ends of the 0.38-m bar remain in contact with their respective support surfaces. End B has a…

A:

Q: The hoop is cast on the rough surface such that it has an angular velocity ω = 5 rad/s and an…

A: aA=a0+aA/0a0= acceleration at center '0'aA/0=acceleration of point 'A' w.r.t.  to 0a0=2…

Q: At the instant shown, the disk is rotating with an angular velocity of wo = 3 rad in the clockwise…

A:

Q: 'oint C has a velocity of 12in/sec in the direction hown., and point B has a velocity of 10.4…

A:

Q: 1. Draw the free-body diagram for bar BC. 2. Using relative motion analysis, Express the…

A: for solution refer below images.

Q: At the instant shown, the shaft and plate rotate with an angular velocity of 14 rad/s and angular…

A:

Q: 7. In the mechanism the piston rod has a horizontal velocity of v =8 ft/sec to the left as shown at…

A: Given: Horizontal velocity of the piston is 8 ft/s.

Q: 5/7 The rectangular plate is rotating about its corner axis = 10 through O with a constant angular…

A: When an moves in radially or the circulatory motion, then the distance travelled by the object in…

Q: The robot moves the particle A (mass M) in the vertical plane using polar coordinate formulas r(t)…

A: Given: The position of particle in rad, θ(t) = (0.5-1.5cos2πt) rad The position of particle in…

Q: An external drive system actuates the mechanism by applying a moment M at bearing D. At the instant…

A:

Q: At the instant shown, point B has a velocity of 3 " to the right and accelerates at the rate of 13…

A:

Q: If rod CD is rotating with an angular velocity ocD. At the instant shown in the figure, which leter…

A:

Q: Crank OA rotates about a pin at O with the coastant clockwise angular velocity 15 Med/s. The slider…

A: Given: Crank slider mechanism To find: velocities and acceleration

Q: 50 140 AT 30 60 150

A:

Q: 1. The solid cylinder is rotating about the fixed axis OA with a constant speed N = 540 rev/min in…

A:

Q: P16-2. Establish the location of the instantaneous center of zero velocity for finding the velocity…

A: Given Data: The length of link OB is LAO =2 m. The length of the link AB is LAB = 0.5 m The…

Q: radian The angular velocity of a rigid body rotating about an axis of rotation is = - 7i + 8j – 11k…

A:

Q: 1. The solid cylinder is rotating about the fixed axis OA with a constant speed N = 540 rev /min in…

A:

Q: w = 3 rad/s 0.2 m a = 2 rad/s? 30 -0.3 m- -0.3 m

A:

Q: 01) instant represented where the links are shown on the picture (two non parallel velocities), the…

A:

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.