Please do parts A and B 3: Consider the Rankine power cycle using vapor and liquid.a: Draw the T-s property diagram of the Carnot Vapor Cycle and explain what kindof problem the Carnot Vapor Cycle has in each process explicitly.b: Draw a T-s diagram for the ideal Rankine cycle and label each process explicitly.Write down the thermal efficiency in terms of enthalpy.c: There is an ideal reheating Rankine cycle in order to improve the efficiency of theideal Rankine cycle. Explain the cycle and its necessity in terms of the property diagramexplicitly.d: Name the gas power cycle which uses the same four processes in its cycle anddraw the T-s diagram and the P-v diagram for the gas power cycle.

a. Carnot Vapor Cycle The Carnot vapor cycle is a theoretical cycle that represents the maximum…

3: Consider the Rankine power cycle using vapor and liquid. a: Draw the T-s property diagram of the Carnot Vapor Cycle and explain what kind problem the Carnot Vapor Cycle has in each process explicitly. b: Draw a T-s diagram for the ideal Rankine cycle and label each process explicitly. Write down the thermal efficiency in terms of enthalpy.

3: Consider the Rankine power cycle using vapor and liquid. a: Draw the T-s property diagram of the Carnot Vapor Cycle and explain what kind problem the Carnot Vapor Cycle has in each process explicitly. b: Draw a T-s diagram for the ideal Rankine cycle and label each process explicitly. Write down the thermal efficiency in terms of enthalpy.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

How much does it cost to start and run a Gas Turbine Power Plant running on Diesel Fuel?
Figure P6.90 shows a simple vapor power cycle operating at steady state with water as the working fluid. Data at key locations are given on the figure. Flow through the turbine and pump occurs isentropically. Flow through the steam generator and condenser occurs at constant pressure. Stray heat transfer and kinetic and potential energy effects are negligible. Sketch the four processes of this cycle in series on a T-s diagram. Determine the thermal efficiency.
This is thermodynamics. Please complete solution A power plant operating on a Rankine cycle has steam entering the turbine at 500 °C and 2 MPa. The turbine and pump efficiencies are 85 and 90 percent, respectively. If the water enters the pump at 10 kPa at a rate of 162,000 kg/hr, calculate the (a) actual turbine power, (b) actual pump power, (c) actual heat added to the water in the boiler, (d) actual cycle thermal efficiency, and (e) actual condition of steam leaving the turbine.
A gas turbine power plant working on Brayton cycle, Explain the working principle of the cycle with physical diagram as well as P-V and T-s diagrams, and with all the required details
shown below is P-V diagram for a reversible cycle enclosed by 4 reversible process curves. The curve 1-2 and the curve 3-4 are reversible isothermal processes, and the curve 2-3 and the curve 1-4 are reversible adiabatic processes. If the cycle direction is counter clockwise, answer the question below. What is the cycle?____ A. Carnot cycle B. ideal heat engine cycle C. Carnot refrigeration cycle D. Reversed refrigeration cycle
Brayton cicle Based on a gas turbine with superheat and intercooling, determine: 1) The thermal efficiency (ƞterm), in %. Use the expression ƞterm= 1 –(qL/ qH)2) How does gas turbine intercooling influence thermal efficiency?3) How and why? It is said that the gas turbine cycle with intercooling, reheating and regeneration is close to the Ericsson cycle.
i.Drawaschematic diagramof each problem with labels of states of a substance; ii.For uniformity purposes, assign STATE 1 at the inlet of ahigh-pressure turbine.The states must be arranged in a chronologicalorder; iii.Ploteach cycle in a t-s diagramwith the states consistentto the states assignment in the schematic diagram; iv.Show a detailed solution An ideal reheat Rankine cycle with water as the working fluid operates the boiler at 10MPa, the reheater at 2MPa, and the condenser at 0.1MPa. The temperature is 4500C at the entrance of the high-pressure and low-pressure turbines. The mass flow rate through the cycle is 1.74 kg/s. Determine a)the rate of heat transfer in the reheater, and b) thecyclethermal efficiency.
Describe the components of a steam power plant and demonstrate the process of it undergoes.
Steam enters the turbine 5MPa and 600 and exits adiabatically at 100 kPa. For Actual cycle: turbine efficiency =90%, turbine brake efficiency=84%, generator efficiency=93% Mass flow rate of steam = 15 kg/s Determine the following: For Ideal Rankine Engine Find WT and e SR and HR For Actual Rankine Cycle Find WT’, WB, WK,e’, eB and eK Find SR’, SRB, SRK,HR’, HRB and HRK
A ____ cycle consists of two Rankine vapor power cycles that use different working fluids.
What are the types of thermodynamic cycle as to the type of output? Define each.
Specific Instruction: i.Drawaschematic diagramof each problem with labels of states of a substance;ii.For uniformity purposes, assign STATE 1 at the inlet of ahigh-pressure turbine.The states must be arranged in a chronologicalorder;iii.Ploteach cycle in a t-s diagramwith the states consistentto the states assignment in the schematic diagram;iv.Show a detailed solution 1.Consider a 200-MW steam power plant that operates on a simple ideal Rankine cycle. Steam enters the turbine at 8MPa and 400 0C and is cooled in the condenser at a pressure of 10 kPa. Determine (a) the quality of the steam at the turbine exit, and (b)themass flow rate of the steam.