3) Determine (Vx) for the circuits below using superposition.

Q: A single-phase full-bridge inverter has a DC input voltage of 123 V, and supplies an inductive load…

A: Given : Current i0=28.28 sin314.16 t-π5 A Voltage V=123 V (a)Sketch a single phase full bridge…

Q: Would it be b,d, and c? 2. Which of the following are characteristics of a closed loop control…

A: Given  Which of the following are characteristics of a closed loop control systems....

Q: Sketch the single-sided and double-sided spectra of x(t) = 2 sin (10nt -

A: Given, x(t)=2sin10πt-16π   To find: Sketch the single-sided and double-sided spectra.

Q: f transistor Q1 is a 2N2222, design the circuit to amplify 15 times a signal of ±50 mV amplitude,…

A: for the Given Fixed bias Amplifier: Given : Input Impedance = Zi = 10 Kohm = 10000 ohm  = RB…

Q: U V W XF 00 0 0 0 00 0 1 1 00 1 00 00 1 11 01 0 0 0 01 0 11 01 1 0 0 01 1 11 1 0 0 0 0 1 0 0 1 |0|…

A:

Q: Problem 3) Find the loop currents I and IB and the current Io in the circuit shown using loop…

A: Given circuit,

Q: 1. If the number of poles in a lap wound generator is doubled, then the generated emf will be a)…

A: Given: Number of poles in lap wound generator are doubled.

Q: 2. Two square metal plates, side 10 cm separated by a gap of 1.5 mm. Calculate the capacitance of…

A: Given: Side of square plates, a=10 cm. Separation in plates, d=1.5 mm. Relative permittivity of air,…

Q: 4. Find Req- 42 Req 360 80 Jal: 22 -WN- M 1202 402 M 1 of th 1 US -M 152 25 322

A:

Q: QUESTION 6 at is the value the following sinusoidal voltage signal v(t) = 183 cos (234t+53°) V at t…

A:

Q: Q2. (a) The circuit of Figure 3 has /₁ = 5mA, V₁ = 5V and R = 5kQ. Derive and sketch its Thévenin…

A: Given a circuit Thevenin equivalent  Load resistance for max power transfer

Q: For given BJT, β=200. The applied input frequency is 20 Mhz and net internal capacitance is 100 pF.…

A: The question is about CE short circuit gain at cutoff frequency.

Q: The BCD equivalent of decimal 88 is O a. 10000010 O b. 10000001 O c. 10001001 O d. 10001000

A: Given, The decimal number is 88.

Q: 28. Referring to Fig. 33.17, what will be the a.c. resistance of crystal diode at point P? (1) 10 Ω…

A: Given figure,

Q: (b) Starting with the voltage divider rule, show that the power transmission coefficient T of an RC…

A: Consider the circuit diagram shown below,

Q: An 8 pole, 50 Hz, 3 phase induction motor is running at 4% slip when delivering full load torque. It…

A: We have an 3-phaes induction motor with, Pole (P) = 8 frequency (f) = 50 Hz Slip (s) = 4% = 0.04…

Q: (b) Starting with the voltage divider rule, show that the power transmission coefficient T of an RC…

A:

Q: find the result

A:

Q: Example 17.32. A loudspeaker is connected across terminals A and B of the network shown in Fig.…

A: Given circuit,

Q: The color code on a resistor in a circuit indicates a value of R = 156,000Ω.a. Express in Powers of…

A: COLOR CODING OF RESISTOR: To denote their value and purpose, components & wires are color-coded.…

Q: 1) Determine the transfer function for the system given below. R(S) S+1 C(S)

A: In this question,  We need to calculate the transfer function .  Transfer function is define the…

Q: P1.71. Determine the value of vx and i, in the circuit shown in Figure P1.71. (1 10 V + + V₂ 0.5 Ω…

A: In this question,  We need to determine the current iy  and voltage vx  as shown the circuit.  We…

Q: In a short circuit test on a circuit breaker, the following readings were obtained on single…

A: We have been given readings of short circuit test on a circuit breaker as, Time to reach peak…

Q: A diesel engine power plant has one 600 kW and two 250 kW generating units. The fuel consumption is…

A: We have an diesel engine power plant with total of 3 units, 1 unit of 600 KW 2 unit of 250 KW Fuel…

Q: (II) Two 3.8µ Fcapacitors, two 2.2 KΩ resistors, and a16.0-V source are connected in series.…

A: In this question,  We need to calculate to time taken from its initial value to 1.50 mA.  We know,…

Q: An office with 30 m * 15 m is illuminated by 40 W fluorescent lamps of lumen output of 2200 lumens.…

A: We have been given an Office area and the given data, Working Area (A) = 30 m * 15 m = 450 m2…

Q: A single-phase full-bridge inverter has a DC input voltage of 123 V, and supplies an inductive load…

A:

Q: There are three input voltages: vI1=2 + 2 sin(wt) V, vI2= 0.5 sin(wt) V and vI3= -4 V. Using an…

A:

Q: In which of the following instrument air friction damping is used. A Moving iron B Galvanometer C…

A: A relatively simple and simple type of dampening is air friction damping. By moving the piston in…

Q: Describe the band diagram structure of a pn junction at the equilibrium state and how it is formed,…

A: Given: PN Junction in the equilibrium state

Q: Consider the series R-L circuit shown in figure below. For obtaining transient free response, switch…

A:

Q: Kindly give explanation i already have answer  A business uses two 3 kW fires for an average of 20…

A:

Q: Q3: For the circuit of Fig. (2), find the current I by using Nodal analysis metho Es EMA

A:

Q: 2. Write the Boolean equation for the following circuit & Simplify the equation, A B C- X

A: Given Boolean circuit,

Q: Problem 1: 12V What is the output voltage when the input Vin is low? When Vin is high? R, =8KO V.…

A: Given data,

Q: For the voltage-divider bias circuit of Fig. 3.33, determine IRQ ICQ VCEQ Vo V₂ V 16 V D wwwww wwww…

A:

Q: 89. If the ripple voltage in a full-wave rectifier is 25 V at a load current of 60 mA, its value at…

A: Given, For a full wave rectifier, Ripple voltage, V1=25 V Load current, IL1=60 mA For load current,…

Q: Full scale deflecting torque of a 20A -5 moving iron ammeter is 5 x 100 N-m, the rate of change of…

A: Given, Full scale deflecting torque, τd=5×10-5 N-m Current, I=20 A

Q: b) What are the major differences between MOS and BJT transistors? D AL J..11. M Abdul Hadi 200

A:

Q: Calculate total monthly bill of a library having 200 fans (65 W), 50 Tubelights (60 W), 50 CFL (45…

A: We have been asked to calculate monthly bill of an library and the load of library is as below,…

Q: N Find the inverse Laplace: S a) F(s) = s³ (s - 3)² s-1 s² +2s+2 Show the details of your work. b)…

A:

Q: The voltage across R₁ resistor in the circuit shown below is? 春 V1 10 *R1 50 R2 50

A: Given, The circuit is,

Q: Ques 2. Two coils connected in parallel across a 100V DC supply, take 10 A current from the supply.…

A:

Q: Plot the polar plot and mark the crossover frequencies frequencies & margins for the T.F. G(s) = 27…

A:

Q: 23. (a) A 12V DC voltage source (of negligible output resistance) is suddenly connected across a…

A:

Q: Find the number of turns N, required to establish a flux p = 12 × 10¹ Wb in the magnetic circuit…

A: ⇒ϕ=N2I2lμμoA⇒12×10-4D=40×3×μ×4π×10-7×0.00120.2⇒μ=1326.29

Q: When is the resistance of an ideal ammeter is zero?

A: Given: When is the resistance of an ideal ammeter is zero?

Q: Complete the RIVP table. express your answers in mA or mW 19V 21 V + 4Ω www 3 Ω + | + 222 6Ω

A:

Q: For given BJT, β=200. The applied input frequency is 20 Mhz and net internal capacitance is 100 pF.…

A: According to the question, it is given that β = 200 Input frequency = 20 Mhz  Internal capacitance =…

Q: 2) Determine the current (Ix) in the following circuits. 20 Ω 80 V 80 V 20 Ω Μ Μ | ν 20 Ω 30 Ω 3 30…

A:

Current Division Method

The generalized current divider formula is given by the following relation below,