Answered: 3) In the circuit shown, the battery…

3) In the circuit shown, the battery has EMF of s=32 V. At what rate is thermal energy being generated in the 60 resistor? (Ignore the internal resistance of the battery)

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 3CQ: Show that the power dissipated by the load resistor is maximum when the resistance of the load...

See similar textbooks

Related questions

Q: How could you recognize that an electric current flowed in the circuit?

A: There are two main points by which the person can recognise that the current flowed in the circuit.…

Q: For circuits used for transporting electric power, a low power factor implies large power loss in…

Q: As load resistance is being increased in series connection, what happens to the current? How about…

A: According to the Ohm's law V = I R where V is the potential difference, R is the resistance, I is…

Q: Is it true that the sum of the voltages in a parallel circuit's loop equals zero? Give a brief…

Q: A 20-ohm toaster is turned on in a circuit that already has a 0.5 hp motor, five 75 W light bulbs,…

A: The given household circuit contains following components 0.5 hp motor 1 hp=735.5 watts so power…

Q: What happens to the current in a circuit if a 10Ω resistor is removed and replaced by a 20Ω…

Q: 3) In the circuit shown, the battery has EMF of ɛ=32 V. At what rate is thermal energy being…

A: Given data, EMF of the battery = 36 V Let, the current is divided into two loops as shown below :-

Q: 14 - chapter28-question21 In the circuit shown, the capacitor is initially uncharged. At time t = 0,…

Q: 19- Which of the following must be done in order for a current to flow through a conducting wire? A)…

A: For flow of current through the wire, there must be potential difference across the wire.

Q: What precaution should be taken to avoid the overloading of domestic electric circuits?

A: Avoid connecting more appliances to a single pocket. Avoid the usage of more appliances at the same…

Q: 13-15. For the circuit below, i, = 1.4 A. Calculate ix and the total power dissipated by the…

A: io = 1.4 ALet, Ro = 16 Ω, R1 = 8 Ω, R2 = 4 Ω, and R3 = 2 Ω

Q: Why is the series arrangement not used for domestic circuits?

Q: Does current get used up in a light bulb? Do charges get used up? Do electrons get used up?…

A: Current is the flow of charge. i.e

Q: 13 - chapter28-question14 Calculate the power (in Watt) delivered to resistor 20 in the circuit…

Q: which one of the followings are true in a electric circut 1-ampermeter has a huge inner resistence…

Q: An independent film student has a 2000 Watt movie lighting setup and wants to plug it into a single…

Q: An uncharged capacitor of capacitance C is charged through a resistor R with a battery of emf ε.…

A: An uncharged capacitor of capacitance C is charged through a resistor R with a battery of emf ε.…

Q: Question 34.) A short circuit in a 120 V appliance cord has a 0.35 Ω resistance. 1.) Calculate the…

Q: Small household electrical devices, such as vacuum cleaners, televisions, and floor lamps, each draw…

A: In series combination, the current is the same while the voltage is different across the circuit…

Q: A number of light bulbs are to be connected to a battery. Which will provide more overall…

Q: If the current through a resistor is decreased by a factor of 4, how does this affect the power…

Q: 80. An automobile battery has an emf of 12.6 V and an internal resistance of 0.0800 2. The…

A: Introduction: When number of electrical components are connected in the electrical circuit, such…

Q: An electric jug kettle has a rating of 2kW at 240 V. If the resistance per unit length is 3 ohm…

A: Given,Rating of electric jug kettle is 2KW at 240Vso, current rating I=2KW240V=2000W240VI=8.333Aso,…

Q: 11- chapter27-question5 An ordinary light bulb is marked "6ow, 120V". Its resistance is(in 2):…

Q: 24. What is a disadvantage of using a series circuits? a. If one section of the circuit fails, the…

Q: 13- chapter28-question33 The current in a single-loop circuit with one resistance R is 6.0 A. When…

A: Given :I = 6 A

Q: If electrons flow very slowly through a circuit, why does it not take a noticeably long time for a…

Q: If two identical resistors are connected in series to a battery,does the battery have to supply more…

A: Here, as given in the problem, R1 =R2 =R Total Resistance = R+R = 2R Electrical Potential = V We…

Q: Which of the following do not apply to a primitive network? (a) It has two terminals. (b) It is…

A: primitive network donot contain two terminals.

Q: If the voltage and resistance are doubled in a simple battery-resistor circuit, does thecurrent…

A: Using Ohm's law the relation between voltage, current and resistance is given as follows: V=IRI=VR…

Q: wound onto a cylindrical A certain resistor is made with a 51.6 m length of fine copper wire, 4.54 x…

A: We have to use the formula Resistance(R) = resistivity ×lengthArea of cross section

Q: In 20 20 1. II. 20 40 20 III. IV. Which 2 circuits have the same total resistance?

Q: A light bulb marked "60 W [at] 120 V" is screwed into a socket at one end of a long extension cord…

A: Given data The Light bulb marked at 60 W at 120 V. The resistance of the conductor is R = 0.801 Ω.…

Q: 054 When the lights of a car are Lights switched on, an ammeter in series with them reads 10.0 A and…

A: The current,

Q: 1. The resistance of an electromagnet winding of copper at 20°C is 302. Determine its resistance at…

A: Given: The resistance of an electromagnet winding of copper at temperature, T=20°C is R=30 Ω The…

Q: The coil of a certain galvanometer has a resistance of 63.8 Q; its needle shows a full-scale…

A: According to question we need to find--- (a) Determine the value of the auxiliary resistance…

Q: 16- What is the value of the ampermeter in the given circuit? NOTE: The internal resistances of the…

Q: Ohm’s Law: Resistance and Simple Circuits• Explain the origin of Ohm’s law.• Calculate voltages,…

A: The physicist Georg Simon Ohm (1787-1854) demonstrated an experiment in the year 1827. In the…

Q: 1. The equivalent resistance of the circuit is 2. The source current is A 3. The voltage drop across…

Q: -0.005- V DC Auto Range LAINMAX RANGE mV mA OFF 400 600V CAT 1000V CATI 10A FUSED COM n the above…

A: The multimeter is a multipurpose electronic device that is used to measure various electrical…

Q: 3. What happens when you only touch one probe to the resistor / resistive component?

A: ****NOTE : Provide the theoretical data or information or instruction provided along with the…

Q: A close inspection of an electric circuit reveals that a 480 ohm resistor was inadvertently soldered…

A: Given, Resistor soldered = 480 ohm Resistor needed = 350 ohm Without removing anything in the…

Q: Carbon-zinc dry cells (sometimes referred to as nonalkaline cells) have an emf of 1.54 V, and they…

A: Given: Carbon-zinc cell's emf, εmfCZn=1.54 V Common battery's emf, Eeq=9 V

Q: The severity of a shock depends on the magnitude of the current through your body. Would you prefer…

A: It would be preferable to be in series with the resistance.

Q: As the load resistance in parallel connection is increased, what happens to current? How about the…

A: Concept:- The given problem can be resolved using the concept of Ohm's law. According to Ohm's law,…

Question

3) In the circuit shown, the battery has EMF of s=32 V. At what rate is thermal
energy being generated in the 60 resistor? (Ignore the internal resistance of
the battery)
E = 32V
12Ω
20
20
Your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Concept

VIEW

Circuit diagram and calculation

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Refer to Figure 10.17 and the discussion of lights dimming when a heavy appliance comes on. (a) Given the voltage source is 120 V, the wire resistance is 0.800 and the bulb is nominally 75.0 W, what power will the bulb dissipate if a total of 15.0 A passes through the wires when the motor comes on? Assume negligible change in bulb resistance, (b) What power is consumed by the motor?
(a) What advantage does 120-V operation offer over 240 V? (b) What disadvantages does it have?
Can a wire carry a current and still be neutral-that is, have a total charge of zero? Explain.
A short circuit in a 120-V appliance cord has a0.500- resistance. Calculate the temperature rise of the2.00 g of surrounding materials, assuming their specific heat capacity is 0.200cal/gC and that it takes 0.0500 sfor a circuit breaker to interrupt the current. Is this likely to be damaging?
Refer to Figure 21.7 and the discussion of lights dimming when a heavy appliance comes on. (a) Given the voltage source is 120 V, the wire resistance is 0.400, and the bulb is nominally 75.0 W, what power will the bulb dissipate if a total of 15.0 A passes through the wires when the motor comes on? Assume negligible change in bulb resistance. (b) What power is consumed by the motor?
A 0.50-W, 220- resistor carries the maximumcurrent possible without damaging the resistor. If the current were reduced to half the value, what would be the power consumed?
What is the effective resistance of a car’s starter motor when 150 A flows through it as the car battery applies 11.0 V to the motor?
When working with high-power electric circuits, it is advised that whenever possible, you work "one-handed” or “keep one hand in your pocket." Why is this a sensible suggestion?
Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
Why isn’t a short circuit a shock hazard?
In the accompanying figure, the rails, connecting end piece, and rod all have a resistance per unit length of . The rod moves to the left at v = 3.0 m/s. If everywhere in the region, what is tire current in the circuit (a) when a = 8.0 cm? (b) when a = 5.0 cm ? Specify also the sense of the current flow.
Calculate the emfx of a dry cell for which a potentiometer is balanced when Rx= 1,200 , while an alkaline standard cell with an emf of 1.600 V requires Rs= 1.247 to balance the potentiometer.