13 - chapter28-question14 Calculate the power (in Watt) delivered to resistor 20 in the circuit shown in Figure. 2.00 2 Option1 Option2 Option3 Option4 Option5 28.4 1.33 4 14.2 3.00 2 1.00 Ω 18.0 V 4.00 2

13 - chapter28-question14 Calculate the power (in Watt) delivered to resistor 20 in the circuit shown in Figure. 2.00 2 Option1 Option2 Option3 Option4 Option5 28.4 1.33 4 14.2 3.00 2 1.00 Ω 18.0 V 4.00 2

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 3CQ: Show that the power dissipated by the load resistor is maximum when the resistance of the load...

See similar textbooks

Related questions

Q: 3. Find the equivalent capacitance of the circuit. C1 = 5µ F, C2 = 3µF, C3 = 4µF, C4 8µF, and Cs 7uF…

A: C1 = 5 μF C2 = 3 μFC3 = 4 μFC4 = 8 μFC5 = 7 μF

Q: %3D In the circuit shown, R1 = 30, R2 = 20, R3 = 50, ɛ1 = 4V, ɛ2 = 10V and ɛ3 = 6V. a E2+ E3+ I3 R1…

Q: An electric circuit consists of four resistors, R1 = 12 Ohm, R2= 12 Ohm, R3 R4 = 6 Ohm, are…

Q: 19- Which of the following must be done in order for a current to flow through a conducting wire? A)…

A: For flow of current through the wire, there must be potential difference across the wire.

Q: Calculate the power delivered to each resistor in the circuit shown in the figure below. (Let R, =…

A: the 2 ohm and 1 ohm resistors are in parallel connection, so the equivalent resistance of these two…

Q: Calculate the power (in Watt) delivered to resistor 20 in the circuit shown in Figure. 2.00a Option1…

Q: or R1=6, R2-D1, 11-4 A & K1=2 in the shown circuit, Find the Norton equivalents at terminals a-b of…

Q: Four resistors are connected to a 9.0-V DC voltage source so that R2 = 6.0 ohms, R3 = 13.0 ohms and…

Q: Given four resistors R1 = 100 ohms, R2=250 ohms, R3 = 350 ohms, and R4 = 200 ohms such that R1 and…

Q: When the switch shown in Fig. 19–45 is closed, what willhappen to the voltage across resistor R1 It…

A: When switch is closed, R2 connect parallel in the circuit. Hence, equivalent resistance of the…

Q: QUESTION 6 In Wheatstone bridge experiment, the relation between Rs and L2/L, that shown in the…

Q: Consider the circuit shown below. The voltage drop will be the largest AVtot = 120 V +||| R₁= 22 S2…

Q: DC Voltmeters and Ammeters• Explain why a voltmeter must be connected in parallel with the circuit.•…

Q: Calculate the power (in Watt) delivered to resistor 22 in the circuit shown in Figure. 2.00 S2…

A: The circuit diagram for the given problem is:

Q: 11- chapter27-question5 An ordinary light bulb is marked "6ow, 120V". Its resistance is(in 2):…

Q: 24. What is a disadvantage of using a series circuits? a. If one section of the circuit fails, the…

Q: 7. chapter27-question24 A metal wire of resistance R is cut into three equal pieces that are then…

Q: 13- chapter28-question33 The current in a single-loop circuit with one resistance R is 6.0 A. When…

A: Given :I = 6 A

Q: chapter28 In Figure, the ideal batteries have emfs & = 150 V and E = 50 V and the resistances are R…

A: Remember: If we are going in from negative terminal of battery to positive terminal, then use +ve…

Q: Question 18 I 12.0V O2.32 A Given the above circuit connected to emf of 12.0 V. Compute the current…

Q: R2 = 52 V = 16 V R1 = 32 hich statement is true? A If R1 were disconnected, R2 would also go out.…

A: Given data: Two resistors are connected in parallel R1 = 3Ω and R2 = 5Ω Battery voltage (V) = 16 V

Q: 18- chapter28-question19 Calculate the power (in W) dellvered to 4 0 resistor in the circuit shown…

Q: The circuit in the figure below contains a battery of emf V and four identical resistors connected…

Q: 20 - chapter28-question13 Calculate the current (in A) in 7 fl resistor if a potential difference of…

Q: Determine the power input of the whole circuit.( R1 5.9 Ohms, R2 8.8 Ohms, emf - 5.0 Volts) Hìnt:…

A: Given: The emf of the battery is 5 V. R1=5.9 ΩR2=8.8 Ω

Q: The circuit in figure consists of two identical parallel metal plates connecte identical metal…

A: Let c1 = 2 uF, as initial capacitance is not provided in the question

Q: 5. In the figure below, with an emf equal to 12.0 V, R, = 6.0 N and R2 = 18.0 N. How much energy is…

A: To be given emf V=12 VR1=6 ΩR2=18 Ωtime, t= 1m

Q: R1 Loop 1 A R2 Loop 2 I3 R3 Is this statement true or false about the circuit shown above: Applying…

A: The circuit contains resistors and an emf source . We are given two loops in the circuit. Kirchoff's…

Q: what is the value of a resistor color coded as red-orange-black-silver? 2. you can produce an…

Q: Refer to the given circuit. R2 = 50 R1 = 6 N R3 = 4 N R4 = 4 N R5 = 8 N DURACELL VT = 10 V Solve for…

Q: I 12.0V ww R₁ = 12 O 11.31 V O 12.0 V Given the above circuit connected to emf of 12.0 V. Compute…

Q: 13- chapter27-question33 When potential difference across a given copper wire increases, drift…

A: When potential difference across a copper wire is increased then the number of electrons flowing…

Q: 7.Which of the following circuit has a total resistance of 10 2 if the total current in the circuit…

A: Option A: Calculate the equivalent resistance. Hence, option A is incorrect.

Q: Ohm’s Law: Resistance and Simple Circuits• Explain the origin of Ohm’s law.• Calculate voltages,…

A: The physicist Georg Simon Ohm (1787-1854) demonstrated an experiment in the year 1827. In the…

Q: 10.0 Q 10.0 Q 10.0 Q Current 0.30 A

Q: 16 - chapter28-question34 A total resistance of 6.00 is to be produced by connecting an unknown…

A: Total resistance, RT=6 ῼ unknown resistance, R1=15 ῼ

Q: chapter28-question4 The RC-Circuit has R=8.7 kQ and C=3 µF. The capacitor is at voltage Vo at t=0,…

Q: 150 μA full scale galvanometer is used as a 3.00 A full scale ammeter when shunted by 3.3 Mega-Ohm.…

A: when a galvanometer convert into ammeter I = new current = 3A IG= galvanometer =150X10-6 G=…

Q: I 12-0 V ww R₁ = 12 O 19 ohm IZR₂ IR3 bon 22 Given the above circuit connected to emf of 12.0.…

Q: 1. The load across a 40-V battery consists of a series combination of three resistances R1, R2, and…

Q: 7. When the switch shown in Fig. 19–45 is closed, what will happen to the voltage across resistor…

A: When the switch is open, the current does not flow through the resistor R2. The current flows only…

Q: Given four resistors R1 = 100 ohms, R2=250 ohms, R3 = 350 ohms, and R4 = 200 ohms such that R1 and…

A: Given DataR1=100ΩR2=250ΩR3=350ΩR4=200Ω

Q: 11- 3. Several resistors are connected to two batteries as shown in Figure. According to Kirchhoff's…

A: To obtain these type equations from a circuit we use Kirchhoff's voltage law. Which states, net…

Q: If the emf is €=28V, R1=3 ohm, R2=6 ohm and R3= 12ohm in the circuit given in the figure, find the…

Q: 30) Four unequal resistors are connected in a parallel with each other. Which one of the following…

A: in this question we use combination of resistors with parallel with each other.

Q: 24. The polarity of a resistor's voltage drop is determined by a) the direction of the current…

A: Let a current flowing through a resistor = I Let the voltage drop across the resistor = V Let the…

Q: 14. Given the circuit below, find the following. R7 = I7 = R 11 AVt V =- 4=. R2= 70 12V V2 = = Rg=…

A: given , Resistance , R1 = 11 Ω R2 = 7 Ω R3 = 20 Ω total voltage , ∆Vnet =12 V

Q: 5: Given R1=102, R2=152, R3=22N and R4=102, find (i) the equivalent resistance of the circuit, (ii)…

Q: 34- In the circuit in the figure, the values of the currents (I₁, I₂, I₃), whose directions are…

A: We need to calculate the currents in the given circuit.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An electronic device designed to operate at any temperature in the range from -10.0°C to 55.0°C contains pure carbon resistors. By what factor does their resistance increase over this range?
A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
The temperature in Philadelphia, PA can vary between 68.00F and 100.00F in one summer day. By what percentage will an aluminum wire’s resistance change during the day?
In this problem, you will verify statements made at the end of the power losses for Example 20.10. (a) What current is needed to transmit 100 MW of power at a voltage of 25.0 kV? (b) Find the power loss in a 1.00 transmission line. (c) What percent loss does this represent?
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
Two different electrical devices have the same power consumption, but one is meant to be operated on 12G-V AC and the other on 240-V AC. (a) What is the ratio of their resistances? (b) What is the ratio of their currents? (c) Assuming its resistance is unaffected, by what factor will the power increase if a 120-V AC device is connected to 240-V AC?
Apply the loop rule to loop afedcba in Figure 21.47.
Integrated Concepts Use the ECG in Figure 20.34 to determine the heart rate in beats per minute assuming a constant time between beats. Figure 20.34 A lead II ECG with corresponding arterial blood pressure. The QRS complex is created by the depolarization and contraction of the ventricles and is followed shortly by the maximum or systolic blood pressure. See text for further description.
Consider the circuit below, (a) What is the initial current through resistor R2? when the switch is closed? (b) What is die current through resistor R2 when the capacitor is fully charged, long after die switch is closed? (c) What happens if the switch is opened after it has been closed for some rime? (d) If the switch has been closed for a time period long enough for the capacitor to become fully charged, and then the switch is opened, how long before the current through resistor R1 reaches half of its initial value?
Solve Example 21.5, but use loop abcdefgha instead of loop akledcba. Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
An automobile starter motor has an equivalent resistance of 0.0500 and is supplied by a 12.0-V battery with a 0.0100- internal resistance, (a) What is the current to the motor? (b) What voltage is applied to it? (c) What power is supplied to the motor? (d) Repeat these calculations for when the battery connections are corroded and add 0.0900 to the circuit. (Significant problems are caused by even small amounts of unwanted resistance in low-voltage, high-current applications.)
Knowing that the severity of a shock depends on the magnitude of the current through your body, would you prefer to be in series or parallel with a resistance, such as the heating element of a toaster, if shocked by it? Explain.