3- The 8086 Processor has several control lines, in considering that. Explain the following: a. Processor sends data to memory (write) and receives data (read) from memory on the data bus. How to determine (processor send/ receive?) b. How do 8086 distinguish between memory locations and I/O devices, when the CPU wants to access a particular memory location or I/O?
Q: Q1) Given a CPU time of 1 millisecond, a clock rate of 1 Ghz, and an instruction count of 10,000,…
A: Given, CPU time = 1ms Clock rate = 1Ghz Number of instructions = 10000
Q: a. On the IAS, what would the machine code instruction look like to load the contents of memory…
A: answer for a: Opcode is 00000001. Operand is 000000000010.
Q: d) Fill the table below with six types of 8086 registers, two for execution unit and three for bus…
A: The solution for the above-given question is given below:
Q: f) When multiple processing units are fabricated on a single chip, what does this processor called?…
A: f) When multiple processing units are fabricated on a single chip what does this processor called…
Q: Q4/ B- answer the following questions : 1- In which T-state does the CPU sends the address to memory…
A: Lets see the solution.
Q: CPU Datapath The following figure shows the overall datapath of the simple 5-stage CPU we have…
A: ANSWER: a) MUX 1 Input 1: Register A input 2:Register B b) MUX 2 Input 1: Register C input…
Q: 3-5Discussion:- 1- Which of the following instructions can't be coded in 8086 assembly language?…
A: (C) MOV BL,DX. Explanation: Size of both the registers is different. BL is of 8 bits and DX…
Q: (b) The following memory units are specified by the number of words times the number of bits per…
A:
Q: o you prefer a synchronous or an asynchronous bus for the utilizatio
A: NOTE: ACCORDING TO COMPANY POLICY WE CAN SOLVE ONLY 1 QUESTION. YOU CAN RESUBMIT THE QUESTION AGAIN…
Q: What is the function of the instruction pointer ? a- The IP and the CS are used to point to…
A: Explanation: The last register of interest is the IP (instruction pointer) register. This 32-bit…
Q: State the difference between parallel processors & coprocessors.
A: In the main processing computer has the arithmetic that can have parallel to the main processor of…
Q: 11. a. Draw flowchart of IAS operation for the following pair of instructions located in address…
A: Answer: a) The flowchart of the instruction goes this way:
Q: a) State 2 ways by which the 8088 and 8086 microprocessors differ. b) What is an instruction queue…
A: The question are:- Two difference between 8088 and 8086. The name of instruction queue in 8086. Two…
Q: 8. The 8086 LOOP instruction decrements register for a 0 to decide if a jump occurs 9. The last…
A: Dear Student, As per our company guidelines we are supposed to answer ?️only first 3️⃣ sub-parts.…
Q: 4. Answer all the questions given below. (a) Consider the following 8086 interfacing problem. A1 AO…
A: Example: Input String: "abba" Output: String is palindrome Input String: "abbca" Output: String is…
Q: Q4/ B- answer the following questions: 1- In which T-state does the CPU sends the address to memory…
A:
Q: Q: Suppose the hypothetical processor has two I/O instructions: 0011=Load AC from I/O 0111=Store AC…
A: Given data uppose the hypothetical processor has two I/O instructions: 0011=Load AC from…
Q: Digital Logic and Address Decoding
A: ANSWER: In Digital Electronics, discrete amounts of data are addressed by twofold codes. A paired…
Q: (b) Color your graph using as few colors as you can. Call the computers registers R1, R2, etc.…
A: GIVEN:
Q: Q5/ answer the following questions : 1- Which type of instruction dose INTO normally follow? Which…
A: 1) external interrupt 0(INT0) interrupts, when evoked serves or executes a particular set of…
Q: 1. The segment addresses are assigned as 0000H to F000H and the offset addresses values are from…
A: According to Bartleby Guidelines we need to answer only 3 sub questions so I have answered first…
Q: What are the two ways to control the microoperations of a cpu? What are the addvantages and…
A: Mnemonic instructions or (code names) of machine language's binary equivalent are assembly language…
Q: b) An 8051 subroutine is shown below: R0, #20H @RO, #0 MOV LOOP: MOv INC RO CJNE RO, #80H, LOOP RET…
A: a) To clear RAM Locations from 20H to 7FH b) MC Bytes Opcodes 1 2 78H 20H 1 2 76H, 00H 1 1…
Q: Suppose the hypothetical processor has two I/O instructions: 0011=Load AC from I/O 0111=Store AC to…
A: Given:- 0011=Load AC from I/O0111=Store AC to I/O
Q: Write the basic addressing modes of a CPU, and explain each one giving a simple instruction example
A: Actually, addressing modes are used to specify the address of operand.
Q: 2. Given the following series of instructions (left two columns). After each instruction has been…
A: In computer engineering, computer architecture is a set of rules and methods that describe the…
Q: Discuss the performance of processor. Briefly discus the performance of registers in processor?
A:
Q: 3. Given the following memory values and a one- address machine with an accumulator and a register,…
A: The following instructions are given in binary:1. 0101 0000 0001 00002. 0101 0000 0001 01003. 0101…
Q: (a) Explain reasons to divide the physical memory of 8086 into segments. Suppose that DS= XX00H, BX=…
A: The main reason to divide physical memory into 8086 of segments is to improve the speed of the…
Q: 5. How many bits are required to address a 4M X 16 main memory if a) main memory is byte…
A: Dear student, As per guidelines. I can do only first question with both subparts. Please repost your…
Q: For this question, use the register and memory values in the tables below. Assume a 32-bit machine.…
A:
Q: he connection between the CPU and memory should be made via an asynchronous or synchronous bus. Do…
A: Timer-controlled synchronous buses execute instructions in a specific order as the clock ticks. Each…
Q: Answer only (e,f,g, h, i) questions. (e) List the elements of the execution unit. (f) What is…
A: (e) Elements of the execution unit are: Arithmetic Logic Unit(ALU): responsible for performing the…
Q: Q.1- Make the right choice for the followings: 1. 8086 processor could be interfaced with memory…
A: The 8086 is a 16 bit microprocessor. The total number of output that are (a) 64 M The 8086 have 20…
Q: between the address
A: Step 1: The pins' names give you a hint.The 8088's eight lowest-order pins are referred to as…
Q: Discuss the advantages of Byte-wise Memory access in 8086. Explain the mechanism of accessing a Word…
A: Advantages of the Segmentation The main advantages of Byte -Wise segmentation are as follows: It…
Q: 4- What should be the value of {N} loaded to CX register in the following assembly subroutine so…
A: In the subroutine there is a loop, MOV CX, n Back:…
Q: (B)- Choose the correct answer for the following questions (Choose FIVE Only) 1. Assume AL register…
A: 1) Ans:- Option c Assume AL register 7FH, it would become 81H after executed NEG AL instruction. 2)…
Q: 148 This is what you're going to do. Let's say that a RISC processor takes 2 microseconds to do each…
A: Given that RICS require 2miliseconds, interruptions are disabled, and RICS instructions are…
Q: in 80886 microprocessor What is result of executing the following instruction sequence? MOV BX,…
A: MOV BX, 100H will load 100 to register BX, MOV [ BX], 0C0ABH the address of BX is now 0C0ABh MOV…
Q: Question 11 The decoding of 80x86 instructions are simpler than instructions in ARM processors. O…
A: Here, we have to provide True/False for the above questions.
Q: For the 8086 microprocessor, show the physical addresses and the contents of memory after execution…
A: The DW,DD and DB are data declaration directives 1. DW: Directive used to declare Word type…
Q: Topic: 8086 microprocessor Q 1c) AL= 53 CL=29 ADD AL, CL DAA What is the value of AL after…
A: 1 (c) given, AL=53 and CL=29 ADD command will add the value from CL with AL and store it back into…
Q: The 8086 microprocessor can employ two different types of Input/Output (I/O): ☺ What are these types…
A: I/O system: In a microprocessor, a peripheral needs to access data and to allow peripherals to…
Q: 2-The elements of the ISA for a particular type of CPU include a. addressing modes b. data…
A: QUESTION 1 The elements of the ISA for a particular type of CPU include CORRECT OPTION : (E) a, b…
Q: Segment registers are:Select one: a. Define the logical address b. All the given options here C c.…
A: 1. Segment registers are: option b) is correct As segment registers define the logical address.…
Q: (ii) Assume the processor is driven by a clock, such that each control step is 4 ns in duration. How…
A:
Q: 1) How many address lines in the 8086 microprocessor? 2) How many data lines in the 8086…
A:
Q: Do you prefer a synchronous or asynchronous bus for CPU and memory utilization? a bus that never…
A: A bus is a group of cables that connect one or more subsystems within a device. It has a shared data…
Step by step
Solved in 2 steps with 1 images
- Q:Answer the following sentence with (True) or (False) and correct the false answer: 1. You can input data of size 16-bit through the fixed port. 2. In the maximum mode, the status signals S₁, S₂ and S3 are controlled by the bus controller. 3. HLDA is an output signal. 4. In 8086, when executing the instruction MOV AL, [SI+100D H] where SI-100AH, Ao=0 and BHE=1 5. When S, is 0, the TF is disabled.Answer only (e,f,g, h, i) questions. (e) List the elements of the execution unit.(f) What is the highest and the lowest address in the 8086’s memory address space.(g) Is memory in the 8086 microprocessor organized as byte, words or double words ?(h) What is the value of the double word stored in memory starting at address B000316 if the contents ofmemory location B000316, B000416, B000516 and B000616 are 1116, 2216, 3316 and 4416 respectively ?i) What is the function of the stack?Do you prefer synchronous or asynchronous buses for CPU and memory utilization?A bus that never stops running, regardless of the hour? Explain.
- Problem Given the following memory values and a one-address machine with an accumulator, what values do the following instructions load into the accumulator? Word 20 contains 40. Word 30 contains 50. Word 40 contains 60. Word 50 contains 70. LOAD IMMEDIATE 20 LOAD DIRECT 20 LOAD INDIRECT 20 LOAD IMMEDIATE 30 LOAD DIRECT 30 LOAD INDIRECT 30Google is now present in Pakistan with the opening of a new office there. Someone has found you. Regarding the question of the microprocessor's speed, you posed the rhetorical question, "What will your answer be?"Provide you reflection on need to have different addressing mode in any given computer?
- Assume two secondary memory processes exist. In light of phase 1, one priority is higher than the other. Only one process can fit in main memory. How does the CPU work on it? Can you explain the whole CPU mechanism?Should the CPU-memory bus be synchronous or asynchronous? I'm interested in your reasoning.(a) Write the Assembly language instruction to move value 1234H into register BX.(b) Write the Assembly language instructions to add the values 16H and ABH. Place the result inregister AX.(c) No value can be moved directly into which registers ?(d) What is the largest hex value that can be moved into a 16-bit register ? Into an 8-bit register ? Whatare the decimal equivalents of these hex values ?
- Do you prefer a synchronous or asynchronous bus for CPU and memory utilization?a bus that never stops running in the background, regardless of the time? Explain.VMware and VirtualPC execute all x86 instructions in the exact same manner as a real x86 CPU would Group of answer choices True FalseSuppose, you as a designer of the CPU decide to add two general-purpose registers named D and E having a two-way connection with the internal bus of the CPU. Drawthe modified CPU diagram with these two registers. need solution for the above question.