Solve the application of differential equationRound off answers to the nearest thousandths.For answers that are less than one (in terms of its absolute value), include atleast 5 significant figures. 3.A thermometer reading 50°C is taken outside where the temperature is 30°C. Five minutes later the readingis 40°C. Find the temperature reading 8 minutes later after the thermometer was brought outside.

Answered: Image /qna-images/answer/d22323e9-e439-4802-978d-5620dd0ce647.jpg

3. A thermometer reading 50°C is taken outside where the temperature is 30°C. Five minutes later the reading is 40°C. Find the temperature reading 8 minutes later after the thermometer was brought outside.

3. A thermometer reading 50°C is taken outside where the temperature is 30°C. Five minutes later the reading is 40°C. Find the temperature reading 8 minutes later after the thermometer was brought outside.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 3P: Alcohol thermometers can measure temperatures in the range of 100 F to 200 F Determine the...

See similar textbooks

Related questions

Q: An earthen dam is constructed on a horizontal, impermeable bedrock layer. The distance from the…

Q: A simply supported 14 ft long beam carries a uniform load of 200 lb/ft over it entire length. The…

A: Given : Length of beam = 14ft Uniform load = 200 lb/ft Width of beam = 3.625 in. Depth of beam =…

Q: Use A36M steel material and select a double-angle tension member to resist the following service…

A: Answer We are given A36M steel Dead load DL = 225 KN Live load LL = 450 KN Wind load WL = 200 KN…

Q: 2. Given the shear diagram shown, draw the load and moment diagrams indicating different values of…

Q: When the U-tube is not rotated, the water stands in the tube as shown. If the tube is rotated about…

Q: B 20ink Find BC= ? ; c P = 1000 lb and AC = ? ; T Find the value of tension and compression at BC…

Q: A flexible shaft consists of a 0.20-in-diameter steel wire encased in a stationary tube that fits…

Q: -X- 20 kN 4 kN/m 10 m- 20 kN

Q: A simply supported beam with a span of 6 m carries vertical loading that increases uniformly from…

Q: For the figure shown below with 3 bar elements connecting two rigid walls, what is the stiffness…

Q: A baseline was measured using a 100m tape which is standardized at 15°C with a standar pull of 10kg.…

Q: Q- The staff reading taken on a workshop floor using a level is 0.645 m. The inverted staff reading…

A: Given- Staff reading of floor=0.645 m, Inverted staff reading=2.960, RL of floor=40.500 m,

Q: The populations of Abu Dhabi (National, Non-National, and Total) and UAE are shown in the following…

A: Population of Abudhabi and UAE is given in table.

Q: Explain about Marshall Stability and Flow of Asphalt Concrete in detail.

A: By first compacting asphalt specimens into moulds with manual or automatic Marshall Compactors then…

Q: Determine the equation of the deflection of the elastic curve for the beam shown and the value of…

Q: 3. Determine the support reactions for the below problem. Draw all appropriate FBD w=2 // FT. PIN…

Q: inflow and outflow resivor initally Vo=500m3 Qin=D200m3 Qout=195m3 e=0.05% Cin=0.01% set up a…

A: Inflow : Water is added to the various components of the hydrologic system through inflow. The…

Q: Determine the flowrate for the symmetrical channel shown in the figure if the bottom is smooth…

Q: D The position of member ABC is controlled by the hydraulic cylinder CD. For the loading shown,…

A: Given Data : Determine the force exerted by the hydraulic cylinder on pin C when angle is 55o?

Q: Determine the y-coordinate of the centroid of the shaded area shown.

Q: reservoir has a capacity of 6.0x106 m3 and a drainage area of 200 km2. The annual stream flow…

A: The reservoir capacity = 6.0x106 m3 drainage area = 200 km2 Annual depth of runoff = 350mm Sediment…

Q: The annual rainfall at a place for a period of 30 years is given below. Draw the rainfall frequency…

A: Given: Year Rainfall (cm) 1951 31.6 1952 30.1 1953 29.8 1954 39.9 1955 37.8 1956 31.3…

Q: Question Bank - Forces The cable system shown in the figure is being used to lift body A. The cable…

A: Given data Find tension in cable (TA, TB , TC and TD ) and mass of body-A (MA).

Q: 5m 4 kN 3 kN 2 kN 3 m- B 4 kN

Q: In the mechanism shown, bars EF and FG are made of steel while GH is made of aluminum. The compound…

Q: Given a bar of diameter d subjected to torques as shown in Figure 2. Determine d to satisfy the…

A: Answer We know from Torsion equation is given by TJ=ζr=GθL From above Torsion equation we get…

Q: 5 m El = constant 90 kN B

Q: Consider the beam shown in (Eigure 1). Set F= 65 kN. Neglect the thickness of the beam. Figure 2 m…

Q: Determine the maximum live load that the beam can carry if the beam depth is 600mm and beam width is…

Q: Determine the support reactions for the below problem. Draw all appropriate FBD. PIN w 10¹ ROLLER…

A: Given, Beam 'AB' has Uniformly distributed load of 2k/ft. Beam 'CD' has Inclined load of 5k at 5ft…

Q: بہت Show that 11 2 Sex Gs Wc 1404

Q: 3. If the specific gravity of the soil subjected to compaction is 2.70, a. Plot the compaction curve…

Q: Draw the shear and moment diagrams of the given beam shown below.

A: ∑MB=0-6×1×0.5 + 12×5×8×4 - RD×8 + 12×4×2×9=0RD=14.13 kN ↑∑V=0RB+RD=6×1 + 12×5×8 + 12×4×2RB+14.13=6×1…

Q: Assume that you know the reactions at A and F. Draw a free-body diagram that would allow you to…

A: Given data Find force in member BC.

Q: A simple horizontal curve of radius 350 ft connects two tangents that form an intersection angle of…

Q: Wastewater from a small rural town has been estimated to have a maximum design flow of 8,200 m³/day,…

Q: Newton's law of cooling states that the temperature of an object changes at a rate proportional to…

Q: 4. The 7° wedge is driven under the spring-loaded wheel whose supporting strut C is fixed. Determine…

Q: Use the area-moment method to determine the slope and deflection at point B of the beam shown below.

A: Given: Required: Slope and deflection at B

Q: using Double Integration Method, Determine the deflection at the free end of the beam shown

Q: need faasttt! just the reactions

A: we can make the given beam loading as follows

Q: Use DOUBLE INTEGRATION METHOD. By superposition, find the reactions of the structure shown. 5W…

Q: delivers air at 45°F, 1 atm to a duct system with three branches consisting of two 26-in.-diameter…

Q: 7. Which one of the following is not an element of strict liability? OA. With intent to mislead…

A: Strict liability is the imposition of liability on a party without a finding of fault.

Q: A velocity-controlled grit channel is planned for the maximum flowrate of 1.50m³/s. When the flow…

A: A velocity-controlled girt channel is given Maximum flowrate, Q = 1.50 m3/sec Flow velocity, v = 0.3…

Q: For the rectangular horizontal-flow sedimentation basin and influent particle- settling…

Q: A proposed earthen dam will contain 5,000,000 m3 of earth. Soil to be taken from a borrow pit will…

A: Basic Concept Terminology related to soil is applied like Void ratio , water content , degree of…

Q: Draw the orthographic side view of the given image with proper dimensions.

A: TO draw Orthographic Side View of the given image

Q: The compound beam is pin supported at C and supported by a roller at A and B. There is a hinge (pin)…

Q: 1. Determine the support reactions of the parabolic arch shown below and the internal forces at a…

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

Solve the application of differential equation Round off answers to the nearest thousandths. For answers that are less than one (in terms of its absolute value), include atleast 5 significant figures.

3.
A thermometer reading 50°C is taken outside where the temperature is 30°C. Five minutes later the reading
is 40°C. Find the temperature reading 8 minutes later after the thermometer was brought outside.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A thermometer reading 75 degrees F is take out where the temperature is 20 degrees F. 4 minutes later, the thermometer reading is 30 degrees F. Find the time (in minutes) taken for the reading to drop from 75 degrees F to within half degree of air temperature.
A thermometer reading 45℃ is brought outside where the temperature is 25℃. Five minutes later, the thermometer reading is 33℃. Determine the thermometer reading 10 minutes after the thermometer was brought outside. Your answer
If a thermometer is taken from a room in which the temperature is 75ºC into the open, where the temperature is 35ºC, and the thermometer reading is 65ºC after 30 sec, what will be the thermometer reading 3 minutes after the removal? Use 2. decimal places.
A glass of a hot water has an initial temperature 80°C, placed in a room where the temperature is 30°C. After one minute the water temperature drops to 70°C. What will be the temperature after 3 minutes? At what time the water cools down to 40°C?
The air temperature in a 26 in^3 container with a free sliding piston is initially measured at 45 degrees Fahrenheit. The temperature is raised to 180 degrees Fahrenheit. What is the new volume of the container? What are the absolute temperature readings initially and after the temperature has been raised? What is the volume in the cylinder after the temperature has been raised?
A thermometer reading is 60oF at 3:00 AM and a Civil Engineering student takes it outside where the air temperature is 20oF. At 3:10, the reading is 30oF. At 3:15, the thermometer is taken back indoor where the thermometer is 60oF. What is the thermometer reading at 3:20AM. a. What is the value of the constant of proportionality? b. The temperature of the thermometer at any time t is given by ____________?
A bottle of medicine must be stored at a temperature between 5°C and 10°C. What does this correspond to on the Fahrenheit scale? [Note: The Fahrenheit (F) and Celsius (C) scales satisfy the relation C=(5/9)(F-32).]
Two thermometer. one reading and the other are both immersed in a fluid. If the farenheit reading is half of the celcius reading, a.) What is the farenheit reading? b.)what is the equivalent temperature of the fluid in degrees rankine?
Solve the following application problems. The thermometer reading 70° F is placed in an oven preheated to a constant temperature. After ½ minute, the thermometer reads 110° F and it reads 145°F after 1 minute. What is the temperature in the oven?
3. Situation 1 - The pressure on a closed tank reads 58.86 kPa. What is the equivalent height, in meters, in terms of mercury? Round off to three decimal places.
What is the equivalent value of T = 120° F in kelvins?
On the suction side of a pump, a Bourdon pressure gage reads 40 kPa vacuum ( = - 40 kPa). What is the corresponding absolute pressure if the local atmosphere pressure is 100 kPa (abs)?[Answer in units of kPa]