3. The head of water over an orifice of diameter 100 mm is 10 m. The water coming out from the orifice is collected in a circular tank of diameter 1,5 m. The rise of water level in this tank is 1.0 m in 25 seconds. Also the coordinates of a point on the jet, measured from vena contracta are 4.30 m horizontal and 0.50 m vertical. Find the device coefficients.

3. The head of water over an orifice of diameter 100 mm is 10 m. The water coming out from the orifice is collected in a circular tank of diameter 1,5 m. The rise of water level in this tank is 1.0 m in 25 seconds. Also the coordinates of a point on the jet, measured from vena contracta are 4.30 m horizontal and 0.50 m vertical. Find the device coefficients.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A horizontal Venturi meter 45cm by 60cm is used to measure the flow of air through a 60cm pipeline. A differential gage connected to the inlet and throat contains water which is deflected 10cm. considering the specific weight of air as 12.60 N/m3 , find the flow of air. Neglect head losses
A square tank 1.20m on each side, 3m deep is filled to a depth of 2.7m with water. A wooden cube having a specific gravity of 0.5 measuring 60cm on an edge is placed in the water so that it will float. Determine the depth of submergence of the cube in the water, the rise of water above the original liquid surface, and the distance of the bottom of the cube from the bottom of the tank.
Two compartments A and B are connected by a standard orifice of 30 cm^2 with C = 0.60 in a prismatic vessel. A has a horizontal cross-section of 30m^2 and B has a horizontal cross-section of 40m^2. At one point in time, the water in A is 6 meters above the orifice's center, whereas the water in B is 3 meters. When will the water's surface be 1 meter apart? Answer : 49 secs
A square tank 1.20m on each side,3m deep is filled to a depth of 2.70m with water. A WOODEN CUBE having a specifix gravity of 0.5 measuring 60 cm on an edge is placed in the water so that it will float. A.) Determine the weight of the water displaced by the cube Choices: 2.12 kN,1.06kN,1.15kN,2.30kN B.)Determine the rise of water above the original liquid surface Choices: 0.15m,0.088m,0.075m,0.30m C.) Determine the change in pressure force on one side of the tank Choices: 2.84kN,2.55kN,2.42kN,2.75Kn
A 1.5m square tank, 3m tall is drained by a 25mm-diameter orifice located at its bottom. If the tank is initially filled with water, how deep is the water in the tank after 45 minutes? Assume C=0.62
An airflows in a circular cylinder with a speed of 320 m/s the pressure is 121,751.5 N/m. What will be the pressure at the point of the surface of the cylinder, With an angle of 25degrees with the direction of airflow
Q1(b) Water flows through a pipe with a diameter of 2 m. Stagnation and static pressures measured by pitot tube are 0.3 m and 0.25 m of water, respectively. Calculate the velocity of flow
Estimate the height to which water will rise or fall in a capillary tube of diameter 3 mm. Use ? = 0.0728 N/m and ? = 9,810 N/m3for water.
An underground conical tank, standing on its vertex, is being filled with water at the rate of 18pi ft3/min. If the tanks has a height of 30feet and a radius of 15feet, how fast is the water level rising when the water is 12 feet deep? a. 3/4 ft/min b. 1/4 ft/min c. 1/2 ft/min d. 1/3 ft/min
Water flows upwards through a venturi section. The venturi section varies indiameter from 15cm at the top and bottom to 5cm at the narrowest point. A differential pressuretransducer measured a pressure difference of 43kPa. Assuming steady flow, determine the velocity ofthe flow through the narrowest region and the discharge through the meter. Assume that water has adensity of 1g/cm 3 .b) The discharge through the venturi section
*hydraulics *Use handwritten Water Flows uniformly at a steady rate of 0.40 m3/s in a very long triangular flume which has side slopes of 1:1. the bottom of the flume is on a slope of 0.006 and n=0.012. Determine the critical depth of flow Choices: A.) 0.504 m B.) 0.604 m C.) 0.704 m D.) 0.804 m
A horizontal 7.5 cm diameter sharp-edged orifice with Cc = 0.063 and Cv= 0.98 is under a head of 2.30 m of water (surface is atmospheric) compute the height to which the jet of water will rise above the orifice. a.3.123 m. b.2.208 m. c.1.202 m. d.0.782 m.