3. Two identical 600 kW, 230 V dc generators are operating in parallel and take equal shares of an 800 kW, 250 V busload. The voltage regulation of each machine is 5%. If one of the generators is accidentally tripped off from the line, what is the voltage of the remaining machine?

3. Two identical 600 kW, 230 V dc generators are operating in parallel and take equal shares of an 800 kW, 250 V busload. The voltage regulation of each machine is 5%. If one of the generators is accidentally tripped off from the line, what is the voltage of the remaining machine?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: 10. Determine the shunt resistance needed to convert a galvanometer to an ammeter with a full scale…

A: In this question, We need to determine the shunt resistance needed to convert the galvanometer to…

Q: 4.17 The circuit shown in Fig. P4.17 is known as a noninverting integrator. For the ele- ment values…

Q: 2. superposmon a) 6V(+ 2mA OITTe 2 km www 4th 2kf Cons 6 kn ww 01

Q: - الترد وتم - Y(s) 2s+1 U(s)

Q: A magnetic circuit has a m.m.f. of 400 AT and a reluctance of 2 x 105 AT/Wb. The magnetic flux in…

Q: Q3/ Consider the circuit in Figure (2), answer (a)-What type of circuit is this? (b)-What is the…

Q: The zeros of the transfer function * s²+2s+2 s4 +6s3 +4s²+7s+12

A: Given transfer function: F(s)=s2+2s+2s4+6s3+4s2+7s+12

Q: Q.3 When a line-to-ground fault occurs, the current in faulted phase 'a' is 100A. The zero-sequence…

Q: an output voltage of 20V across a 1K0 load with an input that will vary between 30V and 50V. That…

A: The required resistance and the maximum current have been identified.

Q: H (jw) = Y(jw) 105 (10 + jw) (1000 + jw) X (jw) (1 + jw)(100 + jw)(10000 + jw) =

Q: Q2) Determine and draw the output voltage for the circuit in Figure 2.

A: It is given that:

Q: Vin C₁ HE 0.0022 μF 4 mH 4 00000- R₁ 150 22 Vout What is the bandwidth in the given circuit. If the…

Q: Two long parallel current carrying wires are separated by 5 cm in air and are carrying current of…

Q: An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 900Hz.…

Q: For a 4 pole induction motor find the synchronous speed if its running at 440V, 50 Hz A.C. supply.

A: Given, For an induction motor, Total number of poles, P = 4. Supply voltage, Vs = 440 V. Frequency,…

Q: A DSB-SC modulation generates a signal y(t) = Acm(t) cos (wet+0). (a) Sketch the amplitude and phase…

Q: Question 7: A 415V, three-phase, 50 Hz, 4-pole, star-connected induction motor runs at 24 rev/s on…

A: NOTE: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts…

Q: A loss-less transmission line having characteristics impedance Zo is terminated in a load of Z₂. If…

A: Given, A lossless transmission line having, Characteristics impedance = ZO. Terminated to load…

Q: The electron concentration in a piece of Si at 300 K is 10^5 cm^-3. What is the hole concentration?

Q: Find current i using mesh current analysis for the circuit. 4.3 V 2.2 V 6.8 ΚΩ Μ 3.3 ΚΩ Σ 9.1 ΚΩ

A: Given circuit,

Q: What factor is directly proportional to PC in ?Normal AM Amplitude of signal Signal types O carrier…

A: Modulation: Modulation is a process enhancing the strength of the signal. Modulation increases the…

Q: :One kilowatt-hour is the power consumed by a 1kW- load during one hour.a None of the answers is…

A: Kilowatt-hour: It is the standard unit of measurement of representing electrical energy. It is…

Q: A 100 kV, 50 Hz supply is fed to a rectifier ammeter (using a bridge rectifier) through a capacitor.…

A: The PMMC meter problem is solved as below

Q: What are the modes of operations used in 8253?

Q: 1. Two shunt generators A and B operate in parallel, and their load characteristics may be taken as…

Q: 7 3- 4- The directivity of the Infinitesimal dipole equal to dB. 5- The return loss (RL) equal to…

Q: We have a nonlinear resistor that is approximated by a piecewise linear model, as is shown in Fig.…

Q: N₁ = h(t) = [1-e-Ju(t) No = ? to find (t). 18 N Use the convolution theoren to find

Q: 5.5 Straight Outta Compton In class, we looked at Compton Scattering of a photon and a free…

A: Solution of question (A): It is asked to discuss the relation between the change in wavelength and…

Q: What are the advantages of switching from copper to fiber optics as a transmission medium?

A: Optical fiber cables have been the strongest transmission medium as well as a technology that…

Q: A drawing hall 30 m by 15 m with a ceiling height of 5 m is to be provided with general illumination…

A: Given,Area of the hall, A=30m×15mCeiling height, h=5 mGeneral illumination, E=120 luxUtilization…

Q: B: Drive the radiation intensity equation of an isotropic antenna.

A: ISOTROPIC ANTENNA PROPERTIS No pre- specified direction of the radiated wave It can radiate in any…

Q: In an ac circuit if the peak value of the voltage is 200 V what is the rms value?

Q: A current of 20A flows through a load having a resistance of 2 ohm. Determine the power dissipated…

A: Current I = 20 A Load resistance RL= 2 Ω Coil resistance Rc = 0.01 Ω We have to find the the value…

Q: For the closed-loop system shown, and given: 5 G(s) 20 8²+ 2.938+ 5 Pref + C(s) control G(s) plant…

Q: 4. Find the unknown currents marked in below figure. A 20 A B 50 A D 15A 13 120 A F E 15 40 A

Q: Given the following nodes from A to G as shown in the diagram, determine the shortest path network…

Q: A magnetic circuit has a m.m.f. of 400 AT and a reluctance of 2 x 105 AT/Wb. The magnetic flux in…

A: Given- m.m.f of magnetic circuit = 400 AT , Reluctance=2×105 AT/Wb , To find - Magnetic flux in…

Q: 5- The return loss (RL) equal to source. ............ when all power injected to the antenna…

A: These have been answered.

Q: A communication channel has magnitude spectrum and phase spectrum defined as: H()=1 0h() = sin 2xƒT…

A: We need draw magnitude and phase response ,

Q: Determine alpha dc if I E = 2.8 mA, I C = 2.75 mA and ICBO = 0.1 mA

Q: Assuming that a 4-bit ADC accepts analog input ranging from 0 to 6 volts, solve the following: a)…

A: ADC stands for analog to digital converter. It convert analog signal in to digital form . Digital…

Q: Find the voltages U₁ and ₂ f

A: Given data, In the given circuit there are two unknown variables V1 and V2 when two resistors R1 and…

Q: Figure 2-17. 08. +||||| 0} I T I I T ||||||| T I I 1 1 1 1 T " I T 100 1111

Q: 22. Minimize the Boolean function F(A,B,C,D) = Em(0,1,3,5,8,11)+ Edm (2,7,10,15) using K map in both…

Q: For the circuit shown, the potential of point A is zero. Determine the potential of poir 2.00 Q A…

A: Here basic properties are applied to solve it.

Q: Find the complement of the Boolean function F F(x, y, z)=x + yz Select one: O a. y'z O b. O c. x'y'…

A: Given, The Boolean function, Fx,y,z=x+yz.

Q: The formula used to fit ILED versus VLED was Y = a (1-e^-bx). Compare this equation to the shockley…

A: SOLUTION GIVEN--> Y = a(1- e-bx) Compare this…

Q: pe or basic meter is configured as a wattmeter? 6. Two 150V voltmeters are being compared; meter A…

Q: A workshop 100 m x 50 m is to be illuminated with intensity of illumination being 50 lux. Determine…

Question

Neeeded answer of it

3. Two identical 600 kW, 230 V dc generators are operating in parallel and take
equal shares of an 800 kW, 250 V busload. The voltage regulation of each
machine is 5%. If one of the generators is accidentally tripped off from the line,
what is the voltage of the remaining machine?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What conditions must be met before two alternators can be paralleled together?
Two identical 800 kW, 230 V DC generators are operating in parallel and take equal shares of an 900 kW, 260 V bus load. The voltage regulation of each machine is 6%. if one of the generators is accidentally tripped off from the line, what is the voltage of the remaining machine?
. A 20 kW compound generator works on full load with terminal voltage of 250 V. The armature, series, and shunt windings have resistances of 0.05-ohm, 0.025 ohm, and 100 ohms, respectively. If the machine is connected short shunt, the emf generated is nearest to. (Our subject is Electrical Machines 1 ) (I need a clear answer and solution. Thank you so much)
Two identical 20 MW three-phase alternators operate in parallel. The governor of first machine is such that the frequency drops uniformly from 50 Hz on no-load to 48 Hz on full load. The corresponding uniform speed drop of the second machine is from 50 Hz to 47.5 Hz. How will the two machines share a load of 30 MW?
DC GENERATOR A shunt generator is connected to a load that draws 28.8 kW. Ra = 0.04 ohm and Rsh = 48 ohms. If the power delivered in the armature is 106.3 % of the power delivered to the load. Determine the terminal voltage of the generator. Please include complete solution.
Try to solve this in 30 minutes. .( An 22 kV, 200 MVA alternator is grounded through a resistor of 5 Ω. The CT's have a ratio 2000/ 10. The relay is set to operate when there an out of balance current of 2 A. What percentage of the generator winding will be protected by the percentage differential scheme of protection?.. )
Two compound generators are operated in parallel. If generator A has a series-field resistance of 0.0015 ohm is adjusted to take 30 percent of the line load while generator B with a series field resistance of 0.001 ohm takes the remainder of the load, determine the current flow in the two series fields and the equalizer when the load is 230 kw at 230 volts.
In a 110-V compound generator, the resistances of the armature, field and serieswindings are 0.06Ω, 25Ω and 0.04Ω respectively. The load consists of 200 lampseach rated at 55 W, 110 V. Find the total electromotive force and the outputpower when the machine is connected: a. long shunt, 2.1a EMF and 2.1b Pob. short shunt, 2.2a EMF and 2.2b Po
Six generators are operating in parallel supply a total current of 3500 A. Each machine has a field resistance of 60 ohms and an armature resistance of 0.01 ohm. The emfs generated of these generators are 250, 270 ,280, 290, 300, 310 volts respectively. Find the share of each of the generator.
Two shunt generators are operating in parallel and taking equal shares of a 2400 A, 230-V load. The ratings of the generators are as follows: Machine Parameters Regulation (%) Rated Power (kW) Rated Voltage (V) Generator 1 3 500 250 Generator 2 4 600 250 If an additional load of 600-A is connected to the bus, determine the current delivered by each generator at this condition
A DC series generator is supplying a current of 10 A to a series lighting system through a feeder of total resistance of 2 Ω. The terminal voltage is 2500 V. The armature and series field resistances are respectively 20 and 10 Ω, respectively. A 15-Ω diverter resistance is shunted across the series field. Determine the power developed in the armature of the generator.
10 kW, 230 V, d.c shunt generator is operating at rated condition with 80% efficiency. Input power and the total loss are respectively