- الترد وتم - Y(s) 2s+1 U(s)

Q: 4 1722 Find V. (t) for tyo 5t de su(t) dx 122 124 Ve to F MA зл 3rf +385V -54 9t [v(t) = 4e 1 / 18e

A:

Q: What are the different types of write operations used in 8253?

A: Given: The given programmable timer used is 8253.

Q: Two long parallel current carrying wires are separated by 5 cm in air and are carrying current of…

A:

Q: Three Phase Full-Wave Fully Controlled Rectifier when highly Inductive load is connected: i. Draw…

A: Given: Three Phase Full-Wave Fully Controlled Rectifier when highly Inductive load is connected. To…

Q: 1. Substation 2A have a busbar made of aluminum with a length of 5 meters and a cross sectional area…

A:

Q: Assuming that a 4-bit ADC accepts analog input ranging from 0 to 6 volts, solve the following: a)…

A: ADC stands for analog to digital converter. It convert analog signal in to digital form . Digital…

Q: he current drawn by the a 230 V DC motor of armature resistance 0.5 Ω and back emf 200 V is ?

A: Given: Terminal voltage, V = 230 V. Armature resistance, Ra=0.5 Ω. Back emf, Eb=200 V.

Q: Find and sketch c(t) = x₁(t) * x₂(t) for the pairs of functions illustrated below. A x₁(1) 461- (a)…

A:

Q: 9. Determine the series resistance needed to convert a galvanometer to a voltmeter reading 15V on…

A:

Q: Q.3 When a line-to-ground fault occurs, the current in faulted phase 'a' is 100A. The zero-sequence…

A: Given- Line to ground fault- Current in the faulted phase=100 A, To Find- The zero-sequence current.

Q: What is the resistance (in ohms) of the network below as seen between terminals a and b? 9Ω a b-…

A: In this question,  We need to determine the equivalent resistance across the terminal a and b.  We…

Q: . Given D = 5x² ax + 10z az C/m², find the net outward flux crossing the surface of a cube 2m on…

A:

Q: 1. A 50kw generator has a full-load efficiency of 90.5%. Determine the total losses

A: It is given that: Generator Output=Pout=50 kW=50×103 WEfficiency=η=90.5 %=0.905

Q: 2.14 Calculate the value of I in the circuit in Fig. P2.14. m

A:

Q: 3. Solve the equivalent resistance across: a. “a” and “b” b. “c” and “d” a 32 6Ω Μ 38 b+ 3Ω Μ 4Ω C…

A:

Q: use a P-N junction ideal diode to simulate a circuit measure and plot its I-V characteristics as…

A: According to the question, we need to show the theoretical calculation for the large signal piece…

Q: Calculate the equivalent impedance of a circuit in which a coil of wire having a value of 5253.2° is…

A: The circuit is shown below:  The impedance of the coil is Z1=5∠53.20 Ω The impedance of the coil in…

Q: 6. A uniform sheet of charge with p=nC/m² is located at z = 5 m and a uniform 3π nC/m is located at…

A:

Q: The system that has the transfer function G(s) = Underdamped system Undamped System Critically…

A: Given data, Transfer function is given as, Gs=144s2+6s+144.

Q: The gate of a MOSFET transistor is initially uncharged.   A voltage of 3V is applied starting at t =…

A: Charger Q = ∫itdt C . And energy delivered E = ∫VI dt watts .

Q: A permanent magnet motor equipped with cobalt-samarium magnets loses 3% of its magnetism per 100°C…

A:

Q: A series circuit consists of a resistor, a coil, and a capacitor connected across a 300V, 60Hz AC…

A:

Q: Two-watt meters, which are connected to measure the total power on a three-phase system supplying a…

A: Given data, First watt-meter P1=10.5 kW Second watt-meter P2=-2.5 kW

Q: = Problem 6 Design the simplest sum-of-products circuit that implements the function f(x1, x2, x3,…

A:

Q: Derive an equation for the additional power seen at the output ter- minals of a radio telescope…

A: Given data: Bandwidth of receiver =B Hz Effective capture area of antenna =Ae m-2 Receiver is…

Q: Draw the circuitry that would implement the given. Using all possible combinations. Make a table to…

A: It is given that: X=A+DB+C

Q: (a) Describe the type of meter movement used in analog meters. (b) What device is used to extend the…

A: Meter The length of the path that light took in a vacuum over a time period of 1/299,792,458 seconds…

Q: Using logic gates, design an active low chip select for the memory a 256 K memory device starting at…

A: The Memory device starts at address=38000016 Active low chip select memory =256 k The memory space =…

Q: MNOP For the given logic circuit, find the following: a. Logic Equation or Output b. Simplified…

A:

Q: This symbol represents: фиш Select one: O A. Single-phase motor. OB. Transformer. O C. Compressor…

A: Given: Symbol

Q: 3. Design a sequential circuit specified by Table 6.1, using JK flip-flops. Table 6.1 Present State…

A:

Q: (a). If the current gain is 100 and the collector current is 10 mA, the base current is?

A: Given, Current gain, β=100. Collector current, IC=10 mA=10×10-3 A.

Q: Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-0 line…

A: Given: String of 3 Insulators  CeC= 0.153 phase Line Voltage = 33 kv

Q: Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-4 line…

A:

Q: Given the logic circuit, determine the Boolean expression of the output and simplify to a minimum…

A:

Q: About Natural gas, what are your takeaways in terms of its: 1. Sources 2. Principles of…

A:

Q: For the circuit shown, the potential of point A is zero. Determine the potential of poir 2.00 Q A…

A: Here basic properties are applied to solve it.

Q: Find the system’s time respons.

A:

Q: 4. Use the labeled in the figure. current-division principle to find the currents i, = 3A (1 R₁ = 10…

A:

Q: Q5: The output signal from an AM modulator is: s(t) = 5 cos(1800nt) + 20 cos(2000nt) + 5cos (2200nt)…

A:

Q: Predict the current, which would be induced in the conductors if a voltage of 40 V could be applied.

A: SOLUTION GIVEN-->              Applied Voltage V…

Q: Draw the circuitry that would implement the given. Using all possible combinations. Make a table to…

A: Given- Boolean expressions- X=A+D¯  B+C¯ To find- Implement given expression =?

Q: (a) A 4-pole generator, with wave wound armature, has 51 slots, each having 24 conductors. The flux…

A:

Q: Question The common emitter amplifier shown in the following figure is biased using a 1 mA ideal…

A: Given- A common emitter amplifier, Ideal current source = 1 mA, Resistance- RC=1 kΩ, To Find- The…

Q: The system that has the transfer function G(s) = Underdamped system Undamped System Critically…

A: In this question,  We need to choose the correct option.  A system can decided according to the…

Q: Q2) Determine and draw the output voltage for the circuit in Figure 2.

A: It is given that:

Q: Problem 2: Given the state equations ż (t) = [ 0 2 ;] a(t) +[i]u(t), y(t)=[1_0]z(t). -2 -5 * P (3)…

A:

Q: A coil has an ac voltage of 120 V. The current through the coil is 104-85° A What is the inductive…

A:

Q: Problem 9 300V Max Power Transfer 25r a AR TO R Find: a) The equation for the power PR clelivered to…

A:

Q: The stator of a 3-phase, a 4-pole induction motor is connected to a 50 Hz supply. The rotor runs at…

A: We need to find out the synchronous speed and slip for given motor .