3.Using path-coordinates method, solve the magnitude of the acceleration in m/s² and the contact force (N) between the slider and the quarter circle rod right after the slider leaves the horizontal plane shown in the figure . The slider will move upward along the circular guide with an initial-velocity and mass of 3.2m/s and 0.5kg, respectively. The spring constant = 3.3kg/m and its unstretched length is 0.70m. Consider the coefficient of kinetic friction between the guide and the slider to be uk = 0.33. m HORIZONTAL PLANE 1.20m 13

3.Using path-coordinates method, solve the magnitude of the acceleration in m/s² and the contact force (N) between the slider and the quarter circle rod right after the slider leaves the horizontal plane shown in the figure . The slider will move upward along the circular guide with an initial-velocity and mass of 3.2m/s and 0.5kg, respectively. The spring constant = 3.3kg/m and its unstretched length is 0.70m. Consider the coefficient of kinetic friction between the guide and the slider to be uk = 0.33. m HORIZONTAL PLANE 1.20m 13

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter6: Energy Of A System

Section: Chapter Questions

Problem 26P

See similar textbooks

Similar questions

In a control system, an accelerometer consists of a 4.70-g object sliding on a calibrated horizontal rail. A low-mass spring attaches the object to a flange at one end of the rail. Grease on the rail makes static friction negligible, but rapidly damps out vibrations of the sliding object. When subject to a steady acceleration of 0.800g, the object should be at a location 0.500 cm away from its equilibrium position. Find the force constant of the spring required for the calibration to be correct.
A 75.0-kg firefighter slides down a pole while a constant friction force of 300 N retards her motion. A horizontal 20.0-kg platform is supported by a spring at the bottom of the pole to cushion the fall. The firefighter starts from rest 4.00 m above the platform, and the spring constant is 4 000 N/m. Find (a) the firefighters speed just before she collides with the platform and (b) the maximum distance the spring is compressed. Assume the friction force acts during the entire motion.
A horizontal spring attached to a wall has a force constant of 850 N/m. A block of mass 1.00 kg is attached to the spring and oscillates freely on a horizontal, frictionless surface as in Figure 5.22. The initial goal of this problem is to find the velocity at the equilibrium point after the block is released. (a) What objects constitute the system, and through what forces do they interact? (b) What are the two points of interest? (c) Find the energy stored in the spring when the mass is stretched 6.00 cm from equilibrium and again when the mass passes through equilibrium after being released from rest. (d) Write the conservation of energy equation for this situation and solve it for the speed of the mass as it passes equilibrium. Substitute to obtain a numerical value. (e) What is the speed at the halfway point? Why isnt it half the speed at equilibrium?
Review. A light spring has unstressed length 15.5 cm. It is described by Hookes law with spring constant 4.30 N/m. One end of the horizontal spring is held on a fixed vertical axle, and the other end is attached to a puck of mass m that can mow without friction over a horizontal surface. The puck is set into motion in a circle with a period of 1.30 s. (a) Find the extension of the spring x as it depends on m. Evaluate x for (b) m = 0.070 0 kg. (c) m = 0.140 kg, (d) m = 0.180 kg, and (e) m = 0.190 kg. (f) Describe the pattern of variation of x as it depends on m.
Figure 15.46 This child’s toy relies on springs to keep infants entertained. (credit: By Humboldthead, Flickr) The device pictured in Figure 16.46 entertains infants while keeping them from wandering. The child bounces in a harness suspended from a door frame by a spring constant. (a) If the spring stretches 0.250 m while supporting an 8.0—kg child, what is its spring constant? (b) What is the time for one complete bounce of this child? (c) What is the child's maximum velocity if the amplitude of her bounce is 0.200 m?
A block of mass M rests on a table. It is fastened to the lower end of a light, vertical spring. The upper end of the spring is fastened to a block of mass m. The upper block is pushed down by an additional force 3mg, so the spring compression is 4mg/k. In this configuration, the upper block is released from rest. The spring lifts the lower block off the table. In terms of m, what is the greatest possible value for m?
When a 4.25-kg object is placed on lop of a vertical spring, the spring compresses a distance of 2.62 cm. What is the force constant of the spring?
Some people modify cars to be much closer to the ground than when manufactured. Should they install stiffer springs? Explain your answer.
. A mass of 0.75 kg is attached to a relaxed spring with k = 2.5 N/m. The mass rests on a horizontal, frictionless surface. If the mass is displaced by 0.33 m, what is the magnitude of the force exerted on the mass by spring? If the mass is then released to execute simple harmonic along the surface, with what frequency will it oscillate?
We do not need the analogy in Equation 16.30 to write expressions for the translational displacement of a pendulum bob along the circular arc s(t), translational speed v(t), and translational acceleration a(t). Show that they are given by s(t) = smax cos (smpt + ) v(t) = vmax sin (smpt + ) a(t) = amax cos(smpt + ) respectively, where smax = max with being the length of the pendulum, vmax = smax smp, and amax = smax smp2.
Is it possible to have damped oscillations when a system is at resonance? Explain.
You are working in an observatory, taking data on electromagnetic radiation from neutron stars. You happen to be analyzing results from the neutron star in Example 11.6, verifying that the period of the 10.0-km-radius neutron star is indeed 2.6 s. You go through weeks of data showing the same period. Suddenly, as you analyze the most recent data, you notice that the period has decreased to 2.3 s and remained at that level since that time. You ask your supervisor about this, who becomes excited and says that the neutron star must have undergone a glitch, which is a sudden shrinking of the radius of the star, resulting in a higher angular speed. As she runs to her computer to start writing a paper on the glitch, she calls back to you to calculate the new radius of the planet, assuming it has remained spherical. She is also talking about vortices and a superfluid core, but you dont understand those words.