35 Calculate the area of cross section using numerical techniques for a river 200 m wide. if the depth d in metres at a distance x metres from one bank is given as follows: 0.00 2.5 19.25 28.00 7.5 36.75 10 45.50 12.5 54.25 15 63.00 17.5 71.75 20 80.50 22.5 89.25 25 98.00 27.5 106.75 30 115.50 32.5 124.25 35 133.00 37.5 141.75 40 150.50 42.5 159.25 45 168.00 47.5 176.75 50 185.50 52.5 194.25 55 203.00 57.5 211.75 60 220.50 62.5 229.25 65 238.00 67.5 246.75 70 255.50 72.5 264.25 75 273.00 77.5 281.75 80 290.50 82.5 299.25 85 308.00 87.5 316.75 90 325.50 92.5 334.25 95 343.00 97.5 351.75 100 360.50

35 Calculate the area of cross section using numerical techniques for a river 200 m wide. if the depth d in metres at a distance x metres from one bank is given as follows: 0.00 2.5 19.25 28.00 7.5 36.75 10 45.50 12.5 54.25 15 63.00 17.5 71.75 20 80.50 22.5 89.25 25 98.00 27.5 106.75 30 115.50 32.5 124.25 35 133.00 37.5 141.75 40 150.50 42.5 159.25 45 168.00 47.5 176.75 50 185.50 52.5 194.25 55 203.00 57.5 211.75 60 220.50 62.5 229.25 65 238.00 67.5 246.75 70 255.50 72.5 264.25 75 273.00 77.5 281.75 80 290.50 82.5 299.25 85 308.00 87.5 316.75 90 325.50 92.5 334.25 95 343.00 97.5 351.75 100 360.50

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The enclosed areas within the contour lines for a reservoir were as follow: Contour value: 168 — 166 - 164 — 162 — 160 — 158 — 156 — 154-152 Areas (m?’): 576000 — 531000 — 477000 — 396000 - 319000 - 264000 - 94000 - 11000 — 2000 The elevation of the base of the reservoir was 152m, calculate the volume of the water when the elevation of the water in the reservoir is 168m using prismoidal and Trapezoidal methods.
For all the computed values with decimals, use four (4) digits after the decimal. A wide river that is connected to the proposed Kaliwa Dam was measured using a reciprocal leveling and the foresights and backsights were taken and tabulated below. If the elevation of M is 530.7962 meters, compute the elevation of point N. ASSUME THAT B=0, C=1, D=2, E=1, F=7, G=3
Water flows in a triangular channel at a velocity of 2.9ft/s. Find the depth of flow (in ft) if the channel slope is 0.0015. n=0.014 CHOICES: 2.57 7.52 5.72 5.27
A road embankment is § m wide and 200 m in length at che formation level, with a side slope of 1.5 Horizontal: 1 vertical. The embankment has arising gradient of 1 in 100 m. the ground levels at every 50 m along the center line are as in table 1. Take formation level of zero chainage is 166 m. Calculate the volume of earth work by Trapezoidal rule and Prismoidal rule. Distance (m) | 0 | 50 | 100 | 150 | 200 Ground RL(m) | 1645 1652 | 1668 | 1670 | 1672
HELP 3 DECIMAL PLACES a. From the results of a hydrographic survey of a lake the following data were obtained.Aa = 1240.71 sq.m. Ab = 752.79 sq.m. Ac = 397.77 sq.m. Ad = 178.44 sq.m. Ae = 48.33 sq.m.(area enclosed by the boundary of the water surface) (area enclosed by contour B)(area enclosed by contour C)(area enclosed by contour D)(area enclosed by contour E) If the vertical distance (h) between contour levels is 1.50 m, determine the total volume of water in the lake above the level of contour E. b. Resolve the above problem if the vertical distance between contour levels is 2.0m. Which has a larger value of volume? Make a conclusion on your answers.
Q2The areas within the contour lines at the site as follows: Calculate the volume of water between them Contour m 90 88 86 84 82 80 78 Areas m² 4760 4310 3770 2960 2190 1640 8400 *
Slope distances AB and BC measures 123.45 m and 321.76 m, respectively. The differences in elevation are 18.81 m for points A and B , and 14.96 m for points B and C. Assume that line AB has a rising slope and BC a falling slope. Determine the horizontal length of line ABC. (Draw the figure as part of your solution).
From the results of a hydrographic survey of a lake, the following area were obtained: a= 11236.12 m^2b= 11052.35 m^2c= 10968.69 m^2d= 10185.47 m^2e= 97458.98 m^2f= 89618.34 m^2g= 75961.78 m^2h= 62845.96 m^2If the vertical distance between contour lines is 6m, determine the volume of water in the lake above the level of contour H using average end area method.
From the results of a hydrographic survey of a lake the following data were obtained. Aa = 1240.71 sq. m (Area enclosed by the boundary of the water surface) Ab = 752.79 sq. m (area enclosed by contour B) Ac = 397.77 sq.m (area enclosed by contour c) Ad = 178.44 sq. m (area enclosed by contour D) Ae = 48.33 sq. m (area enclosed by contour E) if the vertical distance (h) between contour levels is 1.50m, determine the total volume of water in the lake above the level of contour E.
From the results of a hydrographic survey of a lake the following data were obtained. Aa = 1240.71 sq.m. (area enclosed by the boundary of the water surface) Ab = 752.79 sq.m. (area enclosed by contour B) Ac = 397.77 sq.m. (area enclosed by contour C) Ad = 178.44 sq.m. (area enclosed by contour D) Ae = 48.33 sq.m. (area enclosed by contour E) If the vertical distance (h) between contour levels is 1.50 m, determine the total volume of water in the lake above the level of contour E. Resolve the above problem if the vertical distance between contour levels is 2.0m. Which has a larger value of volume?
From the results of a hydrographic survey of a lake the following data were obtained. Aa = 1240.71 sq.m. (area enclosed by the boundary of the water surface) Ab = 752.79 sq.m. (area enclosed by contour B) Ac = 397.77 sq.m. (area enclosed by contour C) Ad = 178.44 sq.m. (area enclosed by contour D) Ae = 48.33 sq.m. (area enclosed by contour E) If the vertical distance (h) between contour levels is 1.50 m, determine the total volume of water in the lake above the level of contour E.
Water flows at a depth of 1.90 m in a rectangular canal 2.44 m wide. The average velocity is 0.579 m/s. What is the probable slope on which the canal is laid if C = 100? a.0.000148 b.0.001258 c.0.000552 d.0.000675