4 +4 2 s²+35+2 4 2.3 G(s) = +45 +4 2.1 G(s) = S² 2.2 G(s)=- 25 7.4 G(S)=² +65 +25

Q: Calculate the maximum and minimum gain values ​​of the power circuit in the following figure.

A: The Thevenin equivalent of the circuit will here…

Q: If the input x(n) =(−2.5)" u(−n + 2) and the impulse response h(n) =28(n − 3) Find y(n) Sketch the…

A: In this question we need to find the output y(t) and sketch the block diagram of the given system.

Q: For R1=5000 2, R2=8000, R3-9000, R4-8000 , C1=0.008 F, C2=0.002 F & I1=0.002 A in the shown circuit,…

A:

Q: Find the currents 11 through 14 and the voltage Vo in the circuit of Fig below. (Ans: 4A; 2A;…

A: For the given circuit the value of unknown current and the voltage vo need to be calculated.

Q: Given a PNP transistor in the figure below, determine Vc and IB -22 V

A: In the given questions we need to do the DC analysis of the given circuit and need to calculate…

Q: 1. Design a quantum circuit for quantum teleportation if Alice and Bob start with the shared state…

A: Quantum circuit :  In quantum information principle, a quantum circuit is a version for quantum…

Q: Problem 4. What is the impulse response of the ideal bandpass filter drawn below with amplitude 1…

A: In the given question we need to find the impulse response of the given ideal bandpass filter

Q: PROBLEM 5 Find V, in the network shown. 8/30° V 202 www ji 202 www V₂ j4 0 — 0 j1 2 2/0° A

A:

Q: Şekildeki devrede anahtar açık ve kondansatörler yüksüzdür. t = 0'da S anahtarı kapatılıyor.…

A: According to the guidelines if questions are given in different languages then we can solve it by…

Q: What kind of cable utilises a connection shaped like a F

A:

Q: Find the difference equation of the system. Find the transfer function H(z) of the system

A: Here we have to find the difference equation and transfer function.

Q: Write the network equations for the mesh currents. And then, put the network equations into standard…

A:

Q: Find the poles, zeros and the pole-zero representation of the system with the transfer function:

A:

Q: What is the value of Vab in polar form. 4-1 mm 6j 100 420 TH § 2 ba 3³; bo 3 Sj 2 بیان

A:

Q: Find Vo for the circuit in Figure using Mesh Analysis

A: The value of voltage across the resistor needs to be calculated by using the mesh analysis.

Q: G(s) = 107(s+ 0.1) (s+50) (s+3160)

A:

Q: For the following circuit find currents through each light bulb in then find the source current Is…

A: For the given circuit, we need to find current through each bulb and the value of source current.

Q: Show that the power factor for the full-wave rectifier with RL load where L is large and the load…

A: The objective is to show that the power factor for the full-wave rectifier with RL load where L is…

Q: The following statement concerns the direction of the current I in the bottom loop (clockwise or…

A: step: 1   At t=0 current in the upper loop is in clockwise direction. By applying palm rule in upper…

Q: Determine the Thevenin and Norton Equivalents for the circuit below, for a load connected across…

A: Given: A network,  To find: Thevenin and Norton's equivalents for the given circuit between…

Q: 2/Design an FIR Linear Phase. For Band - Stop Filter having the ideal response Hd (w)=√ O IWICZ &…

A: Given: Frequency response of an FIR linear phase band stop filter,  Hdω=1;ω≤π60;π6<ω≤π31;π3≤ω≤π,…

Q: 6. Use current division to find the steady state expression for i, in the circuit below if i, = 400…

A:

Q: A rectangular waveguide is used to transmit power from a generator to a radar antenna. The guide has…

A: We use equations for calculating the electric and magnetic fields in a rectangular waveguide for…

Q: 3. A point charge, Q₁ = 20uC, is located at P₁(3,2,1) in free space, while Q₂ = -5uC is at…

A: point charges Q1 = 20 μC  at P1 (3,2,1)                        Q2 =  -5 μC  at P2 (1,2,5)

Q: Design the CMOS transistor circuit using PMOS and NMOS, in pull-up state and pull-down state. For…

A: We need to design pull up state and pull down state for given Boolean function.

Q: O www R₁ R₂ ww 1:0 Ideal

A: Two port Circuit is given we need to calculate Z12 and Z22

Q: Use the node-voltage method to find the steady-state expression for vo(t) in the circuit in (Figure…

A:

Q: The reading of ammeter A1 is____ A.The reading of ammeter A2 is____ A. The reading of ammeter A3 is…

A:

Q: Consider the cascaded Op Amp circuit shown below. 4 кл R= + Va= Voi Vb = Vol = 6 кл Va V 3V Please…

A: Think about a left side op-amp: The voltage at the non-inverting terminal of an ideal op-amp is…

Q: For L1=13 H, L2=10 H, L3=10 H, L4-30 H, L5=75 H, L6=30 H, L7=24 H & L8-59 H in the circuit shown…

A: Given: A network,  with, , and considering no energy stored in the inductors. To find: Equivalent…

Q: In the experiment of Charging and Discharging a Capacitor (Experiment 2); Two consecutive…

A:

Q: FIND i(t), t>0 t=0 -36V -6.02 12:02 2H

A:

Q: QUESTION 9 See the circuit below. If R1= 867 a, R2-222 a and R3-3890, calculate the current (in mA)…

A:

Q: R₂= 2300 2 Identify, write out the general formula for circut gain Determine output voltage for the…

A: Operational amplifier with negative feedback.

Q: Knowing that the voice signal has no noticeable spectral content from -300 Hz to approximately 300…

A: Given data Cutoff frequency = 3 db Max Frequency = 300 Hz Min Frequency = -300 Hz Voice Signal = 1.5…

Q: When a Discrete LTI system receives the input 2 -1 It generates the output 2 36-4 Calculate the…

A: it is asked to find the impulse response of given system based on input and output

Q: Find Vo for the circuit in Figure using: 1. Mesh analysis 2. Nodal analysis 3. Thevenin's theorem

A:

Q: The cost of a single phase overhead transmission line is Rs (25000 a +1500) per km where 'a' is the…

A: We have an 3-phase overhead line which has, Cost of transmission line = 25000 a + 2500 Rs/km a =…

Q: In the electrical circuit shown, the components have the following values: V = 120 volts R₁ R₂ = 69…

A: For the given circuit the total current in the circuit needs to be calculated. The total resistance…

Q: Kindly solve this clearly. Solve and maintain in 4 decimal places. Box the final answers.

A: Since you have posted the questions with multiple subpart and so we are supposed to answer 3 subpart…

Q: 2. For the network of Figure 2 with the measurement Vs = 1.7 V, determine: a. Ip b. VGS c. lpss d.…

A:

Q: Consider constellation plot of a B-PSK signalling scheme as shown in the figure below: S₂(t) -1×10-³…

A: Two-sided noise PSD is 10-6 W/Hz.

Q: In an n-type silicon sample, the donor concentration at 300 K is 5 x 1014/cm3 that corresponds to 1…

A: We need to find out the electrons and hole concentration of given sample .

Q: L1 L2 Voltage (V) 120 L3 E1 E2 + Local ac power network Frequency (Hz) 60 R₁ (22) + 300 11 12 R2, R3…

A: In this question We need to find the total active power, reactive power and apparent power.

Q: Determine the impulse response and the step response of this stable causal system using Z-transform.…

A:

Q: What is the inverse z-transform of X(z) = (2-1)/(z-2)? {-1}^nu[-n-1] {12}^n_u[n] {1/2)^nu[n] u[n] -…

A:

Q: A new planet is discovered with a diameter 4 times larger than Earth's. By what factor is the new…

A:

Q: 3. Obtain the Thevenin and Norton equivalent circuit as seen from terminals a-b. b 120 V 6Ω Μ a Μ 4Ω…

A: In the given questions we need to draw the thevenin and Norton equivalent circuit.

Q: An LTI system has an impulse response: h(t) = e¹u(t+1) This system is: Select one: Causal but not…

A: An LTI system  impulse response  h(t)=e4tu(t+1) We need to find the causal or not causal , Stable or…

Q: State four (4) advantages of the suspension type insulators.

A:

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).