Answered: 4) Find the conductance, G, of the…

Engineering

Electrical Engineering

4) Find the conductance, G, of the following Aluminium conductor, Take T=20°C: Aluminum: 1 = 200 ft d = 50 mils Ihint.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter10: Using Wire Tables And Determining Conductor Sizes

Section: Chapter Questions

Problem 10PP: Determine the ohms-per-mil-foot of an aluminum conductor located in an area with a temperature of...

See similar textbooks

Related questions

Q: Q36) Determine the stabjljty of the following system (marginal, stable, unstable). Jústify your…

A: Brief description : In the above given question they have mentioned state space matrix of a control…

Q: The open-loop transfer function of a unity feedback system is K G(s) = %3D %3D s(s²+16s+160) , H(s)…

Q: 4. A battery has an EMF of 24.0 V and an internal resistance of 'r'. Its terminals are connected to…

Q: admittance Y=0.06 - j0.08 mho, then conductance is

A: Solve the problem

Q: 1. Prove that the logic expression below are true i. AB + AB + AB = A + B (X + Z)(Y + Z)(X + Z) = XZ…

Q: Polarizability is defined as the

Q: Rank the waves in the figure below based on the following. Use numbers 1-5 where 5 is the…

A: The basic elements of sinusoidal waveform can be obtained by visually seeing the given graph. The…

Q: QUESTION 18 What is the approximate amplitude of this waveform when one division represents 2 volts?…

A: In this question, We need to choose the correct options What is amplitude of this waveform?

Q: Determine the thermal coefficient of resistance of copper at 500C, then use this value to determine…

Q: d. 4 2k Test I. Multiple Choices. Directions: Read each statement carefully and encircle the letter…

A: Solve the problem

Q: How high is the rated torque of separately excited shunt wound DC Motor?

Q: 2. Find the mesh currents in the circuit I kQ ww 1k2 12 V 10 v O ) 12 V www

Q: A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing…

A: In this question, We need to Find the emf induced in each phase winding and the terminal voltage?…

Q: Across a 230v, 60Hz power supply is a 15 ohm non-inductive resistor. What is the equation of the…

A: We need to find out current through resistor for given voltage .

Q: Find the mesh currents

Q: If the following voltages are measured in T2, the probable fault is 1:1 S1 7.5 V 15 V S2 7.5 V T2 O…

A: When any partial short is there in the circuit, then the total voltage that appears across the…

Q: 1200kVA, 6600V, 3phase, Y-connected alternator has an effective resistance of 0.4Ω and a reactance…

Q: ktenine the trans for function G6) = im the ginen gysten: T(6)

A: The transfer function for the given rotational mechanical system can be obtained with drawing the…

Q: A 460-V, 25-hp, 60-Hz, four pole, Y-connected induction motor has the following impedances in ohms…

Q: 3. Find Thevenin's equivalent circuit for the circuit shown below 8 ww RL 12 100 V

Q: 10. A 1000-V, 50-Hz supply to a transformer results in 650 W hysteresis loss and 400 W eddy current…

Q: EXERCISE 2: An air-filled 5- by 2-cm waveguide has Ezs = 20 sin 40nx sin 50ry eBz v/m at 15 GHz. (a)…

Q: Q Find The Powers suppLied by all Sources byusing ip nudyns M12R loov+ 4A ン 3x

A: In this question, We need to determine the power supplied by the source. We know, Power P= VI

Q: Q3: Consider the CT signal to compute y(t) = x(t) h(t) h(t) X(t) 1 2

A: Brief description: In the above given question they have mentioned two continuous time domain…

Q: For the circuit shown ,if the switch on at t=0, determine Vr, ir and vz as a function of time Ro

A: This circuit has a switch and is opened for a long time. It will close at time t=0. a) t=0, (t<0)…

Q: Two 10 H inductors are in parallel and the parallel combination is in series with a third 10 H…

A: Given: The inductors in parallel are L1=10 H and L2=10 H Inductor in series of parallel combination…

Q: Vcc= 20 V 56 k2 B-200 8.2 k2 2 ko

A: The solution is given below

Q: Follow the successive approximation ADC procedure to convert 3.23456 V

A: ADC- Full form of ADC is analog to digital conversions. And the electronics device used for…

Q: An electro-magnet draws 3 kW of active power and 4 kvar of reactive power. a.) calculate the…

Q: H.W.leFind the laplace ransformsof the fallawing funclionS (6) sinh? at

Q: please draw in paper The band stop filter block diagram

A: Brief description : In the above given question they want to know the block diagram of the Band stop…

Q: the current flow (a) in the collector and (b) in the emitter if the base current is 5mA

Q: A 300-Vo, 60-Hz, three-phase induction motor is drawing 20 A at 0.75 PF lagging. The stator copper…

A: Power input of a 3-phase induction motor can be expressed as : Pin= VinI.pfwhere,Vin= Input voltageI…

Q: How about the d and e

A: The mechanical power generated in the armature is Pmech=Eb·Ia,Pmech=491×18Pmech=8838 W.

Q: From the truth table in Table 2 below, do the following: Write the minterm Boolean expression for…

A: given here a truth table and asked to write the minterm expression for that truth table. in minterm…

Q: (b) Consider the block diagram shown in Figure 2. Define the form of connection for subsystems A and…

Q: Home work: Determine the following for the common-gate config of Fig. (a) VGSQ (b) Ipo (c) VD- (d)…

A: The required parameter can be obtined by using the DC analysis of Common gate amplifier circuit.

Q: pin insulators/suspension insulators)

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: nsider a signal y[n] which is related to two signals xi[n] and x2[n] by y[n] = x1[n+3] * x2[-n+1],…

A: We need to find out z Transform of given signal.

Q: DFind the folal transfer funchian Co) fr he ystem shown belowse RIS) -He

Q: What will be the Nyquist's (minimal) sampling frequency (in Hz) to recover an input signal x(t)=…

A: Given data, Input signal xt=cos700t+cos500t

Q: 12 V B=120 -40 kQ Vo 390 k2 10 5.6 k2 -8 V

A: Input impedance: It is the ratio of the voltage and current from the input side. In another way,…

Q: QI) For the periodic signals x(f) and y() shown below: a) Find the exponential Fourier series for…

A: A periodic signal is a signal which keeps on repeating itself for a fixed interval of time. A…

Q: How to find the maximum phase boost of a Type II and Type III Compensator?

A: The Type II and type III compensators are used for providing phase boost to any lagging signal with…

Q: Solve the following. Show complete solution, resistor combination and circuit transformation. Box…

A: We need to find out voltage for given circuit

Q: iven NPN transistor, if the base current is 10mA and the emitter current is 600mA, what would be the…

A: we know that in transistor Ie = Ib + Ic where Ie= emitter current Ib= base current Ic = collector…

Q: The parallel component of magnetic field intensity at the boundary of separation of the medium will…

A: The parallel component of magnetic field intensity at the boundary of separation of the medium will…

Q: A rectangular air filled waveguide has a cross section of 4 cm x 10 cm. Determine the minimum…

A: We need to find out cut off frequency for given waveguide .

Q: Create a circuit diagram for the given armature: 4 poles, 26 conductors, double layer,…

A: 4 poles, 26 conductors, double layer, simplex WAVE winding

Q: Find the ratio of permeability of the two media when the wave is incident on the boundary at 90…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

4) Find the conductance, G, of the following Aluminium conductor,
Take T=20°C:
Aluminum:
| = 200 ft
d = 50 mils
Ihint.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The puncture resistance of the insulator used in an AA cable with a conductor cross section of 150 mm2 is 200 kV / cm for the most convenient layout. Which of the following is the maximum effective value of the voltage that can be applied to this cable with relative dielectric coefficient kapasitesi, = 4.4, and the capacity of the unit length of the cable? Take the dielectric constant 8,86.10 ^ -12)
A cylindrical conducting wire which is 4658.98cm long, 83.02mm thick and resistivity of 8.92 ohm per meter has how much resistance
Find the resistance of a conductor at 500 degrees Celsius given that its temperature coefficient at 200 degrees Celsius being 1/420 per oC and resistance at 420 oC being 200 ohms.
The resistance of a conductor 1 mm^2 in cross-section and 20 m long is 0.346 Ω. Determine the specific resistance of the conducting material
Cylindrical-conductors has inner and outer radii of 2 mm and 25 mm, respectively. If V(p = 2 mm) = 150 V and V(p = 25 mm) = 0 V, ɛr = 10, dielectric conductivity 5×10¬4 s/m, the dielectric resistance equals to
The conductors of a 10 km long, single phase, two wire line are seperated by a distance of 1.5 m. The diameter of each conductor is 1 cm. If the conductors are of copper, the inductance of the circuit is ??
Compute the resistance of a conductor whose resistivity is 20.54 ohm-CM per foot with circularc ross-sectional area of 38 mm2a nd length of 5,000 meters. If the conductor is drawn until its resistance becomes 10 ohms, what will be its new length?
Circuit analysis. If the charge passing through the cross section of a conductor in 103.69 ms is 0.2 C, find the current. Please ignore Turkish translations.
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductors are transposed at regular intervals
A copper wire at 20 degrees C, and 164 cmil, has a K value of 10.4 ohms per mi-foot. If the distance to the load is 600 feet (183 m) calculate the resistance of the loop.
Determine the allowable ampacity of a 350 kcmil THW aluminum conductor installed in a raceway with four other current-carrying conductors when the expected ambient temperature is 44 degrees C.
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductorsare transposed at regular intervals.