Q 30 QUESTION 30If the following voltages are measured in T2, the probable fault is1:1S17.5 V15 VS2 7.5 VT2a partial short in the bottom of the secondarya partial short in the top part of the secondaryan open in the secondaryO no fault exists

When any partial short is there in the circuit, then the total voltage that appears across the…

If the following voltages are measured in T2, the probable fault is 1:1 S1 7.5 V 15 V S2 7.5 V T2 O a partial short in the bottom of the secondary a partial short in the top part of the secondary an open in the secondary O no fault exists

If the following voltages are measured in T2, the probable fault is 1:1 S1 7.5 V 15 V S2 7.5 V T2 O a partial short in the bottom of the secondary a partial short in the top part of the secondary an open in the secondary O no fault exists

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter9: Unsymmetrical Faults

Section: Chapter Questions

Problem 9.2P

See similar textbooks

Related questions

Q: 1. Find the transfer function Z(s)/F(s) for the following block diagram. Make sure that you simplify…

Q: .) A 220V 600-watt electric coffee maker is used to make a total of 10 cups of coffee in 45 minutes.…

A: Given V= 220V P=600W No of cups = 10 Time= 45min = (45/60)=0.75hrs a) P= V*I 600= 220*I…

Q: Home work: Determine the following for the common-gate config of Fig. (a) VGSQ (b) Ipo (c) VD- (d)…

A: The required parameter can be obtined by using the DC analysis of Common gate amplifier circuit.

Q: Example1/ An open wire T-L with R=10 KQ/Km ,L=3.7 mH/km , C=8.3× 10-°F/Km and G=0.4x 10-6U/Km , find…

Q: What will be the Nyquist's (minimal) sampling frequency (in Hz) to recover an input signal x(t)=…

A: Given data, Input signal xt=cos700t+cos500t

Q: An electro-magnet draws 3 kW of active power and 4 kvar of reactive power. a.) calculate the…

Q: Find the Laplace transform of the following functions +4 +5x 1 up Initial conditions are 0

A: Given data, d2xdt2+4dxdt+5x=1 Initial conditions are zero.

Q: Main elements of Electric Power System except A. Electricity Generation B. Single Phase Transformer…

A: There are four components of complete power system, namy, Generation Transmission Distribution…

Q: Find the Laplace transform of the following functions Initial conditions are 0

A: Given, d2xdt2+4dxdt+5x=1 Initial conditions are zero.

Q: Find the Laplace transform of the following functions f(t)=sinh 2t

Q: Answer the following problems (maxwell/mesh analysis)/Thevenin's circuit 1. + +V- R1 80 R2 20 11 R3…

A: Mesh analysis: This is a method for solving the current in the circuit. The circuit should be…

Q: The rating of current transformer is given as 200/5A 5P10 20VA. Assume that the secondary resistance…

Q: For the circuit shown in Figure , let v(0) = 10 V and i(0) = 1 A. Need help to use mesh analysis to…

A: We have shown the given circuit below. The initial conditions are vC0=10 Volts. iL0=1 A.

Q: Determine the Voltage V2. 0.6 A 19 2 12 V V2 OA 2.925 Volts OB.0.525 Volts OC O.125 Volts OD I.125…

A: Given,

Q: 1. Same figure, solve the loop and branch currents using Maxwell's theorem.

Q: Solve the power triangle at Z6 in the circuit diagram below.

Q: How high is the rated torque of separately excited shunt wound DC Motor?

Q: Which of the following binary numbers is equivalent to the decimal number 25? o a. 11001 o b. 10011…

A: Given, Decimal number is 25

Q: 6422 Res 2--X390 -82.22 200+390

Q: 4. De Morgans's Theorems Explain briefly two type of De Morgan's Theorem i1. i. Explain briefly the…

A: The Demorgan's law is used to reduce the Boolean expression and to convert the minterm to maxterm…

Q: Q.7: A 3-0, 4-wire, Y-connected, 380V line voltage with positive sequence (abc) system supply two…

Q: 2. Boolean expression Use only NAND gates to design a logic circuit to simulate the Boolean…

A: The given Boolean expression can be implemented by using NAND and the design can be achieved by…

Q: Law of Energy Conversion A. Connection of Power Plant to Consumers Energy converted from electrical…

A: The solution is given below

Q: 3. Find Thevenin's equivalent circuit for the circuit shown below

Q: -j V1 1Ω V2 3Ω I 2j +) 2245° V 2440°A wll

Q: b) Consider the below figure in which three hosts, with private IP addresses 10.0.1.12, 10.0.1.15,…

A: The given figure is shown below:

Q: Q.17: For the circuit shown, let Z,=Z2=Z, =10260°Q, and the line voltage be a balanced abc (+ve)…

Q: Exercise 2: 1- Precise the features of the Infinite Impulse Response (IIR

A: We are authorized to answer only one question at a time since you have not mentioned which question…

Q: A resistor of 50 ohms and an impedance pf 100 + j50 ohms are connected in parallel across a 220v…

Q: Find the ratio of permeability of the two media when the wave is incident on the boundary at 90…

Q: Example: Consider a control system with G(s) K s(s+1)(0.01s+1)' Design a closed feedback system such…

A: Closed-loop system: When the output of the open-loop system is feedbacked to the input and output…

Q: 9. From the truth table in Table 3, do the following: Write the minterm Boolean expression for the…

Q: QUESTION 29 The purpose of a transformer is to O transfer power O transfer current O transfer…

A: This question belongs to electrical machine . It is based on the concept of transformer . Have a…

Q: 3. Five cells each 3 volts and internal resistance of 0.1 ohms are joined in parallel and connected…

A: The circuit diagram according to the given condition can be drawn as shown below:

Q: 7. A stable first order transfer function must have a pole on the .. . o axis 8. A second order…

Q: Q.3: A 7KVA, 750/300-V, 50-Hz, single-phase transformer, the open and short circuit tests data are…

Q: find the current, Ix, for the circuit shown. (show all your work) ix 12Ω 30 Ω 5A + 30 V 0.5 ix

A: Given,

Q: USING SUPERPOSITION THEOREM FIND THE CURRENT FLOWING THROUGH ALL IMPEDANCES. SHOW YOUR…

Q: calculate the load current.

A: Voltmeter- Measuring device used to measure voltage. It is connected across (parallel) the element…

Q: te) oblain the closad loop frasshr hunchan CbR) by using Mason's lormula fy the syslon belows GE G3…

Q: The primary winding of a transformer connected to 2,200 volts circuit consists of two coils which…

Q: 9) Use super Position to Find Vx and Po wer dissi Puted by 1onresistor b) Use Source transformation…

A: Given: Consider the following circuit: To find: (a) Use superposition to find Vx and power…

Q: Q36) Determine the stabjljty of the following system (marginal, stable, unstable). Jústify your…

A: Brief description : In the above given question they have mentioned state space matrix of a control…

Q: The input of a certain regulator increases by 2.5 V. As a result, the output voltage increases by…

Q: What is the definition of electrical resistance?

A: In this question we will define electrical resistance....

Q: 4. Using the Voltage-Divider-Rule, find the value of resistance R for the network of Fig. P4. 2.2 kn…

A: Given:

Q: t=0 20и(-t)V v =0.2 F 10 Ω )ЗА +1

Q: Active Sensor is called as self generating sensors. Select one: O True O False

A: The solution is given below

Q: 2. Boolean expression Use only NAND gates to design a logic circuit to simulate the Boolean expre:…

Q: A rectangular air filled waveguide has a cross section of 4 cm x 10 cm. Determine the minimum…

A: We need to find cut off frequency.

Question

Q 30

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

17. Which section of the National Electrical Code provides the performance requirements and criteria foran effective ground-fault current path?A. 358.30B. 250.4(A)(5)C. 250.118D. 358.6
There is a zerouence current in line to line fault.Select one:TrueO False
1-what is meaning of contamination of condensate water and reasons and how to solve this fault, 2- mention function of LV 16 and LV 16A
Will upvote if right solution..
5.The most frequently occurring fault in electrical power systems is Immersive reader. A) Symmetrical three-phase fault B) Line to ground fault C) Line to Line Fault D) Double Line to Ground Fault E) N. A.
three transformers connected as indicated below to step the voltage down from 13,200V to 460V. a) determine the ratio of the transformer if the transformers are connected wye-delta. b) determine the ratio transformation if the transformers are connected wye-delta. c) determine the ratio of transformation if the transformers are connected delta-wye. d) determine the ratio of the transformation if the transformers are connected delta-delta. BOX THE FINAL ANSWER AND USE 4-5 DECIMAL PLACES FOR THE ANSWER subject: ELECTRICAL APPARATUS AND DEVICES
1. It describe the relationship of current voltage and resistance. 2. There are the available options for the pilot, In case of a single generator failure in large multiengine aircraft. Choose all the correct answers. 3. This system converts 115AC to 28VDC in most large body aircraft.
what would be the minimum size feeder conductor THHW 75 degrees for four 30- amp motor generator arc welders with a duty cycle of 70 ? 6 AWG THHW 4 AWG THHW 2 AWG THHW 3 AWG THHW
True or false 1. Three phase fault is the most commonly occurring fault than other types of faults. 2. The range of generator rotor angle for stable operation is 0°< s < 180°. 3. The infinite bus in power system is a large system with infinite voltage. 4. At value of (s= 90°) the maximum power transfer takes place. 5. Per unit system (PU) is a ratio of actual value in any units to the base or reference value in the same units.
Will Upvote for solution
TRUE or FALSE: During open-circuit test, the current in the high-voltage winding is equal to zero.
A 15 MVA, 6.6 kV, wye connected generator has X 1 = X 2 = 20%and X 0 = 10%. The neutral of the generator is groundedthrough a reactor of 5% reactance based on the generatorrating. A double line-to-ground fault occurs at terminals band c. What is the current in the ground?