4. A 10 m. diameter cylindrical tank has a height of 5 m and is full of water at 20°C (unit weight = 9.789 KN/m³). If the water is heated to a temperature of 50°C (unit weight = 9.689 KN/m³). Determine the volume when heated at a 50°C a. 396.75 m³ b.392.70 m³ c.385.03 m³ b. 0.024 N/m 5. What is the value of the surface tension of a small drop of water 0.3 mm in diameter which is in contact with air if the pressure within the droplet is 561 Pa. a. 0.083 N/m d. 389.51 m³ c. 0.42 N/m d. 0.38 N/m

4. A 10 m. diameter cylindrical tank has a height of 5 m and is full of water at 20°C (unit weight = 9.789 KN/m³). If the water is heated to a temperature of 50°C (unit weight = 9.689 KN/m³). Determine the volume when heated at a 50°C a. 396.75 m³ b.392.70 m³ c.385.03 m³ b. 0.024 N/m 5. What is the value of the surface tension of a small drop of water 0.3 mm in diameter which is in contact with air if the pressure within the droplet is 561 Pa. a. 0.083 N/m d. 389.51 m³ c. 0.42 N/m d. 0.38 N/m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The open tank filled with a liquid in full as shown in the figure below has the height of h = 6.00 m. The inclined angle of the inclined wall is = 45.00 °. The width (perpendicular to the screen) of the inclined wall is w = 20.00 m. The specific weight of the liquid is = 9.81 kN/m3. (3) For the inclined wall, determine the vertical depth to the center of pressure._________ (m)
4. A reservoir supplies water to a horizontal 6′′ pipe 800 ft long. The pipe flows full and discharges into the atmosphere at the rate of 2.23 cfs. What is the pressure in psi midway in the pipe, assuming the only lost head is 6.20 ft in each 100 ft of length? indicaye free body diagram
A vertical cylindrical tank with a diametr of 12m and a depth of 4m is filled with water to the top with water at 20 degrees Celcius . If the water is heated at 50 degrees Celcius, how much water will spill over? Unit weight of water at 20 degrees Celcius and 50 degrees Celcius is 9.79 kN/m3 and 9.69 kN/m3, respectively. Answer: 4.7m3 Complete Solution
A cylindrical tank of diameter 3m and height of 8m is filled halfway with water. A small hole (ID = 3cm) is at the bottom of the tank, where the water is flowing out. Determine the volumetric flow rate of the water at the point where 0.5m of water is left in the tank.
A tank containing water moves horizontally (parallel to length) with a constant linear acceleration of 3 m/s2 . The tank is 3 m long and the depth of water when the tank is at rest is 1.5 m. (a) What angle (degrees) does the water make during acceleration? (b) What is the minimum height of the vessel for no spilling of water? (c) What is the maximum pressure head (m)?
diameter = 60 cm height = 60 cm The CLOSE cylindrical tank is two-thirds full of water. It is subjected to pressure = 10 kpag. Considering that the tank is to rotate about the axis at the center at 10 rad/s a. What is the pressure at point C? b. What is the pressure at point D?
A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev. 15m). The head loss from the reservoir (point 1) to the summit (point 2, elev. 22m) is 2.5 times the velocity head in the siphon and head loss from the summit to the discharge end is 4 times the velocity head in the siphon. What is the absolutepressure at the summit (point 2) assuming the atmospheric pressure to be 101.3 kPa?
A tank containing water moves horizontally (parallel to length) with a constant linear acceleration of 3 m/s2 . The tank is 3 m long and the depth of water when the tank is at rest is 1.5 m. FIND THE FOLLOWING: A. what angle (degrees) does the water make during acceleration? B. what is the minimum height of the vessel for no spilling of water? C. what is the maximum pressure head? (m)
Hydraulics ProblemAn open horizontal tank 1.5m high 2m wide and 5m long is full of oil with a specific gravity of 0.9. It is accelerated in the direction parallel to the longer length at 2.3 m/s2 a. What is the force acting on the wall of the tank with the shortest depth in KN? b. If the acceleration is increased by 0.88 m/s2. Determine the volume of oil that spilled out the tank?Note: Draw free-body diagram and used 4 decimal places
A pressure gage at Elev.8.00m on the side of a tank containing a certain liquid reads 57.4kPa, while a second gage at Elev.5.00m reads 80kPa. What is the specific weight of the liquid in kN/cu.m?
A right circular cylindrical tank container, 2m in diameter and 4m high is 1/2 full of water. When rotated about its vertical axis at the rate of 60 rpm:A.) How many meters will the water surface drop at the center of the vessel? B.) What is the pressure, in kPa, at the base of the container along the perimeter? C.) What is the volume, in m^3, of the paraboloid formed by the rotation of the vessel? (Show complete solution)
A square tank 1.20m on each side, 3m deep is filled to a depth of 2.70m with water. A wooden cube having a specific gravity of 0.5 measuring 60 cm on an edge is placed in the water so that it will float. a. Determine the weight of water displaced by the cube. b. Determine the rise of water above the original liquid surface. c. Determine the change in pressure force on one side of the tank.