4. A transmission line is terminated in its characteristic impedance as shown below. Explain what happens when the switch is closed Rs = 50 Q 100V 2o = 50 Q R_ = 0 Input 1. What is expected VSWR for a transmission line with a reflection coefficient of 0.377? What is the input impedance at a point one-eighth wavelength in front of a transmission line with a characteristic impedance of 50 Q terminated in an open.

4. A transmission line is terminated in its characteristic impedance as shown below. Explain what happens when the switch is closed Rs = 50 Q 100V 2o = 50 Q R_ = 0 Input 1. What is expected VSWR for a transmission line with a reflection coefficient of 0.377? What is the input impedance at a point one-eighth wavelength in front of a transmission line with a characteristic impedance of 50 Q terminated in an open.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A transmission line in air with characteristic impedance Z0=50 ohm is terminated with a load impedance ZL ohm. What is the propogation constant k of the transmission line (assuming a coaxial line) for a 100 MHz uniform plane wave? What is the equivalence impedance of Z(-l) at l=.75m when ZL=25-j200 ohm? Calculate the shunt admittance to be added at l=.75m so that the line matched.
How do I find the input impedance of a 60 ohm transmission line that is a quarter wavelength long if its terminated by i) a short circuit and ii) 1 - 2j ?
Calculate the guided intrinsic impedance at 20 GHz for the lowest-order mode of therectangular waveguide with dimensions a=0.7 in and b=0.3 in.Take relative permittivity as 2.76.
A load has a reflection coefficient of 0.5 when referred to 50 Ω. The load is at the end of a line with a 50 Ω characteristic impedance.(a) If the line has an electrical length of 45 degrees, what is the reflection coefficient calculated at the input of the line?(b) What is the VSWR on the 50 Ω line?
In microwave communications systems, for a carrier frequency of 6GHz and a distance of 40 km. determine the free space path loss in dB.
For this transmission medium for Temperature as 294 °K, what will be the Noise power in this bandwith?
A lossless coaxial cable transmission line has L = 10 uH/ft and C = 4 nF/ft. If the signal frequency is 1 GHz, what is the length between two successive oscillations of an electromagnetic signal?
3.) The received power at an airplane is calculated as Pr=-43 dBm at a range of 13 miles using free-space propagation. Determine the received power (in dBm) at a range of 52 miles.
Use the free space model to compute the free space path loss for a 900 MHz signal over a distance of 200 meters. Express your answer in dB. state the answer in the correct units and show all your computations to receive credit
The following lossless network is powered by a f=9 GHz microwave source. A matching circuit is designed for ZL=91 load and ZS. Since it is known that L=631,30220884613 pH here, what is ZS? π=3.1416
A transmitter delivers 50 W into a 600 Ω lossless line that is terminated with an antenna that has an impedance of 275 Ω, resistive. (a) What is the coefficient of reflection? (b) How much of the power actually reaches the antenna?
A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive load. What is the characteristic impedance of the quarter-wavelength line that can be used for impedance matching?