4. (Equivalent Resistance) Calculate the equivalent resistance of the circuit given below. Show your calculations. Current, I, R1 100 R2 R3 200 300 5. (Kirchhoff's Current Law) For circuit given in Question 4, verify I, = I; + Is. Show your calculations. Hint: Calculate Equivalent resistance of R2 and R3, calculate total equivalent resistance of the entire circuit, calculate I, now V33=V7-V1, now calculate Iz and I; and show that I;=Iy+I3

4. (Equivalent Resistance) Calculate the equivalent resistance of the circuit given below. Show your calculations. Current, I, R1 100 R2 R3 200 300 5. (Kirchhoff's Current Law) For circuit given in Question 4, verify I, = I; + Is. Show your calculations. Hint: Calculate Equivalent resistance of R2 and R3, calculate total equivalent resistance of the entire circuit, calculate I, now V33=V7-V1, now calculate Iz and I; and show that I;=Iy+I3

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Direct-current Circuits

Section27.4: Rc Circuits

Problem 27.5QQ: Consider the circuit in Figure 27.17 and assume the battery has no internal resistance. (i) Just...

See similar textbooks

Similar questions

Given the circuit below: If all the currents flowing through R1, R2, and R3 (I1, I2, and I3, respectively) are going in the top junction, what is the equation resulting from applying the Kirchhoff's loop rule for a clockwise loop around the perimeter of the circuit? V1 + V3 + I1R1 - I3R3 = 0 V1 - V3 + I1R1 + I3R3 = 0 V1 - V3 + I1R1 + I3R3 = 0 V1 + V3 - I1R1 + I3R3 = 0 V1 + V3 - I1R1 + I3R3 = 0 None of the Above None of the Above
The diagram below shows a circuit where R1=4 Ω, R2=6 Ω, R3=5 Ω, V1=6 Volts, V2=10 Volts, and V3=7 Volts. What is the value of I1? In solving this problem, initially pick the current directions as shown. If the actual current turns out to be in the opposite direction, then your answer will be negative. If you get a negative number, enter it as negative. I can get the equations of: I1R1+V1-I2R2+V2= 0 -V2+I2R2-V1-I3R3+V3=0 I1+I2+I3 = 0 But I dont understand how to take these equations and solve for I1. Can you please do it step by step?
1. What current does a stereo receiver draw if used for 2 minutes and goes through 10 coulombs of charge? 2. How long can a flashlight run for if it draws 0.11 amps and its battery contains 10 coulombs of charge?
A resistor is dissipating 119milliwatts [mW] of power. The voltage across the resistor is 26 volts [V]. (a) What is the value of the resistance? Express your answer in units of ohms[Ω]using an appropriate SI prefix such that there are only one, two, or three digits shown to the left of the decimal. (b) What is the current through the resistor? Express your answer in units of amperes [A] using an appropriate SI prefix such that there are only one, two, or three digits shown to the left of the decimal.
A resistor is dissipating 114 milliwatts [mW] of power. The voltage across the resistor is 13 volts [V]. (a) What is the value of the resistance? Express your answer in units of ohms [Ω] using an appropriate SI prefix such that there are only one, two, or three digits shown to the left of the decimal. (b) What is the current through the resistor? Express your answer in units of amperes [A] using an appropriate SI prefix such that there are only one, two, or three digits shown to the left of the decimal.
What is the equivalent resistor, in units of Ohm, between the terminals a and b if you replace R1 by 4 Ohm, R2 by 1 Ohm and R3 by 5 Ohm resistor? Your result must contain two decimal places. Maximum of 5% of error is accepted in your answer.
Hi! Could you please answer the following questions? ThANKS! Q14; What does Kirchhoff's second law show? a. conservation of charge b. conservation of energy c. The sum of the currents entering a junction is the sum of the current leaving the junction d. In any closed loop, the sum of the e.m.f. is equal to the sum of the products of the current and the resistance (potential difference) Q15: For the circuit shown, the resistances are R1 > R2 > R3. What is true about the current through each resistor? a. I1 = I2 = I3 b. I1 > I3 > I2 c. I1 > I2 > I3 d. I1 < I3 < I2
1) A resistor has a value of 20 ohms (Ω) when it is at 15 degrees Celsius. If the coefficient of thermal resistivity is 3.5 x 10-3/ Celsius, determine the value of the resistance at 97 degrees Celsius. Write your result to 3 significant figures. 2) A certain copper wire has a resistance of 10.0 ohm (Ω). a) At what point should the wire be cut so that the resistance of one segment is 4 times the resistance of the other segment? b) What is the resistance of each segment?
On the basis of your second set of data, are there any patterns to the way that currents behave in a parallel circuit? At this time you should be able to write the general characteristics of currents, voltages and resistances in parallel circuits.
Consider the circuit shown in the figure(Figure 1). Suppose the four resistors in this circuit have the values R1= 13 Ω, R2= 6.4 Ω, R3= 6.3 Ω, and R4= 14 Ω, and that the emf of the battery is E= 18 V. Part A: Find the current through each resistor using the rules for series and parallel resistors. Part B: Find the current through each resistor using Kirchhoff's rules.
1. What is the equivalent resistance if you connect three 10.0 Ω resistors in series? 2. What is the equivalent resistance if you connect three 10.0 Ω resistors in parallel? 3. Calculate the current in each 10.0 Ω resistor in the series circuit and in the parallel circuit if the power supply is 60.0 V.
Six circuits containing a battery and two or more bulbs are shown here. D. What are the total resistance Rtot and the current flowing from the battery I in circuit 2?Rtot = ΩI = AE. In circuit 3, how is bulb C connected to A and B? ---Select--- series parallel neither What are the total resistance Rtot and the current flowing from the battery I in circuit 3?Rtot = ΩI = AF. In circuit 6, how is bulb C connected to A and B? ---Select--- series parallel neither What are the total resistance Rtot and the current flowing from the battery I in circuit 6?Rtot = ΩI = A