4. Use the labeled in the figure. current-division principle to find the currents i, = 3A (1 R₁ = 10 92 www R₂=. 20 92 www R3 = 15 92

Q: 15. For the circuit in Fig. 15.92: a. Find the total impedance Z, in polar form. b. Draw the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Point charges q1 and q2 are held in place at the (x,y) coordinates specified below. Point P is a…

A:

Q: What would be the barrier potential of a silicon diode when the junction temperature is at 50°C?…

A:

Q: or a uise litude modulated (PAM) transmission of voice signal having maximum frequency equal to fm =…

A:

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: We need to find out zener impedance for given current and voltage .

Q: Using nodal analysis, What is the power absorbed by the 15 Q resistor 5 A↓ 21 M 202 3Ω 15 Ω www +1₁…

A: Given,

Q: X Z D D f

A: The logic function is solved as below.

Q: Calculate the current in the loop, 20 V 10 Ω 5Ω 10 V 80 V 20 Ω

A: Apply KVL in the loop  Let the current in the loop be "i" in the clockwise direction.

Q: A telephone signal with a cutoff frequency of 5 kHz is sampled at a rate 60 percent higher than the…

A: Cutt-off frequency f = 5 kHz We have to determine the sampling rate.

Q: 6.3-3 A signal set has a vector representation of $₁ = (0,5) $₂=(2, 2) $3=(2, 2) (a) Assuming that…

A: According to the question, the vector representation of the signal set is given as, S1=0, 5;S2=2,…

Q: роз KCL @ node A, B, C kuci SA the 1252 V₁ 2512 20520 405 un V₂ 405 ↑) 7.5 A

A:

Q: 6. The open loop transfer function of a unity feedback system is given by K (s+3)(s+6) Calculate the…

A: We need to find out the phase and magnitude of given transfer function at given frequency

Q: In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A: When two inductance L1 and L2 are connected in series and coupled through mutual inductance M then…

Q: 40 m 10 V Figure 6.5 1202 Select one: A. 4 V B. 10 V C. 6 V D. 8 V + V₂ See Figure 6.5. What is the…

A: We need to find out the open circuit voltage for given circuit

Q: If we have Const Pie = 3.14, what is the value of this expression: Pie = Pie +1 Pie = 3.14 Pie =…

A:

Q: A conducting rod of length 0.5 m falls freely from the top of a building of height 7.2 m at a place…

A: Solution !! l = 0.5 m; h = 7.2 m; u = 0 m s-1; g = 10 m s-2; BH = 40378.7 nT The final velocity of…

Q: A transmission line with negligible attenuation has L = 0.1 uH/ft and C = 0.2 nF/ft and is typically…

A:

Q: to a 110V supply. At a temperature of 18°C, the current drawn is 0.575 A. After running the machine…

A:

Q: * The voltage Vout in the circuit shown is

A: Given data, Circuit diagram is given as,

Q: 9. Design the simplest circuit that implements the function Σm (0,1,2,4,5,6) using NAND gates. f(x₁,…

A:

Q: A d.c. series motor drives a load at 30 rev/s and takes a current of 10 A when the supply voltage is…

A: Types of DC Machine Seperetely excited DC Motor Self excited DC motor DC shunt motor DC series…

Q: Determine vo using nodal analysis. Answer: Vo = 8.2V 45 2.2 ЗА V الب 8R EVO 3.5 (1) 4A

A: In this question,  We need to determine the Vo .  We are solving this question using the nodal…

Q: The equivalent resistance between points A and B:(shown in figure) is? C r www B wwww

A: Solution !!

Q: Exampic Bandwidth of the input to pulse code modulator is restricted to 4 kHz. The input varies from…

A: We need to find out the number of bits per sample for given pcm signal . First we will find out step…

Q: The voltage Vo in the circuit shown equals 10Α 200 ἦν. Ο 5A 200 ΩΣ ЗА

A: Given data, Circuit diagram is given as,

Q: On full-load a 300 V series motor takes 90A and runs at 15 rev/s. The armature resistance is 0.1 ohm…

A: Given- For series motor- Voltage at terminal = 300 V Current = 90 A Speed = 15 rev/sec Armature…

Q: ܕܒܓ ܝܘ c(t) =1=e7r cos @at 1-g -sin out

A:

Q: A 320V shunt motor takes a total current of 80A and runs at 1000 rev/min. If the iron, friction and…

A:

Q: - In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A:

Q: Example 2.9 The resistance of a long piece of copper wire is 48 2 at 20°C. a. What would the…

A: Solution !! a. The temperature rise is degrees Celsius and the resistance increases 0.393% forevery…

Q: Apply DeMorgan's theorems to each expression:

A: It is given that: a. X=AB'C+D''b.Y=A+B'+C+D''+ABCD''

Q: 2. The pole zero plot of a ransfer function is shown below. The transfer function of the system is…

A: In pole zero plot poles are represented with symbol × and zeroes are represented with symbol o.…

Q: The voltage Vo in the circuit shown equals 104 SA ίδιο 200 ξ 200 ἦν. ЗА

A: Given data, Circuit diagram is given as,

Q: Divide in binary: (a) 11101001101 (c) 11100101001 (b) 110000001+ 1110 Check your answers by…

A: It is given that: a)11101001÷101 b)110000001`÷1110 c)1110010÷1001

Q: 4. In an Amplitude Modulation: a) Amplitude of the carrier varies. b) Frequency of the carrier…

A: Amplitude Modulation Amplitude modulation is a type of modulation used in electronic communication,…

Q: In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic…

A:

Q: Based on the signals below, find the Fourier transform of x(t) for (a)-(e). -2 x(t) n 2 (a) -2 -1…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: A 500V shunt motor runs at its normal speed of 10 rev/s when the armature current is 120A. The…

A:

Q: The power factor of a load on a 120-V 60-Hz source is raised from 0.707 lagging to 0.866 lagging by…

A: Given data, Frequency f=60 Hz Power factor, cosϕ1=0.707cosϕ2=0.866 Capacitance C=53 μF Voltage V=120…

Q: V2 40V R2 40 4A R1 60 R3 www 20 12 2A R4 30

A:

Q: A 50-ohm lossless transmission line has series inductance of 250 nH/m and shunt capacitance of 100…

A:

Q: A 3-phase 3-wire supply feeds a load consisting of three equal resistors connected in star. If one…

A: Given data, 3-phase 3-wire Supply:- Three-wire ac power circuits are used for three-phase power,…

Q: 3. Illustrate how science and engineering are related.

A: Here we need to discuss the relationship between science and engineering.

Q: A 160 resistor, an 830 inductive reactance, and a 20 capacitive reactance are in series. A 120V 60Hz…

A: In this question,  We need to determine the current in the circuit.  We know As per ohms law,…

Q: A coil has an ac voltage of 120 V. The current through the coil is 104-85° A What is the inductive…

A:

Q: The bode plot of a transfer function is given below. has

A: option (a) One pole and one zero

Q: Q1) Consider the signal x(t) = 3 *exp(-0.5t) * u(t), where u(t) is the unit step function. (a)…

A:

Q: 4. In ac circuit takes a load of 160 kVA at a lagging power factor of 0.75 when connected to a 460-V…

A:

Q: 1 2 Resistance Value 10 Q2 620 Ω First Color Second Color Third Color

A: The resistance, R=10 Ω The resistance, R=620 Ω

Q: (coso) 17 find the Power factor of the following ckf. 452 in somm

A: Given circuit diagram,      cosθ=?