4.30 32 3. In the circuit the emf ɛ = 21.3 volts and the inductance L= 150 mH. What will be the energy in Joules in the magnetic field of the inductor 15.5 ms after the switch is closed? (State answer with 3 digits right of decimal. Do not enter unit.) ll

4.30 32 3. In the circuit the emf ɛ = 21.3 volts and the inductance L= 150 mH. What will be the energy in Joules in the magnetic field of the inductor 15.5 ms after the switch is closed? (State answer with 3 digits right of decimal. Do not enter unit.) ll

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 62P: A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine...

See similar textbooks

Related questions

Q: The current in a coil drops from 3.5 A to 2.0 A in 0.50 s. If the average emf induced in the coil is…

Q: A coil consisting of 800 turns, very closely spaced, has an inductance of 4mh and a current of…

Q: An emf of 9.7mV is induced in a coil while the current in a nearby coil is decreasing at a rate of…

Q: A direct current of 25A creates a flux of 1.4 X 10-4 Wb in a coil of 500 turns. What is the…

A: Given that, Current I = 25 A Flux ϕ=1.4×10-4 Wb Number of turns = 500

Q: The self-inductance of a coil is 50 mH. What is the emf induced when the current in the coil…

Q: What is the inductance of a coil if the coil produces an emf of 2.86 V when the current in it…

Q: What inductance must be connected to a 16 pF capacitor in an oscillator capable of generating 690 nm…

Q: What is the inductance of a coil in which the average emf induced is 21V when the current in the…

Q: How fast can the 150 A current through a 0.250 H inductor be shut off if the induced emf cannot…

A: Given: Current, i = 150 A inductance, L = 0.25 H Voltage, V = 75 V

Q: What value of inductance should be used if a 20.0 k2 reactance is needed at a frequency of 500 Hz?

Q: A solenoid of radius 4.5 cm has 620 turns and a length of 15 cm. (a) Find its inductance. mH (b)…

Q: An emf of 8V is induced in a given coil when the current in it changes at the rate of 32 A/ sec.…

A: Given data: Induced emf, ε=8V Current, dIdt= 32 A/sec

Q: Since inductors can be used as energy storage elements, how much inductance is needed to power up a…

Q: If you want a characteristic RL time constant of 1.20 s, and you have a 490 N resistor, what value…

Q: 4.30 2 3. In the circuit the emf e 19.5 volts and the inductance L 107 mH. What will be the energy…

A: Given: The emf of the battery is 19.5 V. The inductance of the inductor is 107 mH. The time interval…

Q: The current in a coil drops from 3.8 A to 1.8 A in 0.51 s. If the average emf induced in the coil is…

Q: A solenoid of radius 3.5 cm has 800 turns and a length of 25 cm. (a) Find its inductance. mH (b)…

A: Given: The radius of the solenoid is 3.5 cm = 0.035 m. { 1 cm =…

Q: An emf of 121.5 mV is induced in the windings of a coil when the current in a nearby coil is…

A: The formula for the induced emf in term of mutual inductance is:

Q: if the area of the coil is 6920 cm2 and magenetic field applied is increasing uniformly from 0.3 T…

Q: Suppose that a rectangular toroid has 1, 600 windings and a self-inductance of 0.070 H. If h = 0.13…

Q: A 4-79 permalloy solenoid coil needs to produce a minimum inductance of 1.5 Wb/m2 . If the maximum…

Q: The current in a coil drops from 3.8 A to 1.9 A in 0.52 s. If the average emf induced in the coil is…

A: The self induction of the coil is 3.28 mH

Q: A solenoid of radius 4.5 cm has 800 turns and a length of 25 cm. (a) Find its inductance. mH (b)…

Q: The current through a coil as a function of time is represented by the equation I(t) = Ae sin(wt),…

A: Induced emf due to the varying current in the first coil…

Q: A air-filed solenoid 18.3 cm diameter and length 23 cm, has 120 turns. If the current increases from…

Q: How many turns should a solenoid of cross-sectional area0.035 m2 and length 0.32 m have if its…

A: The solenoid’s cross-sectional area is, The solenoid’s length is, The inductance of a solenoid is,

Q: Two coils have a mutual inductance of 2.34 x 10 H. The current in the first coil increases at a…

Q: What is the magnetic field due to an inductor of length 10 cm that has 300 turns if 0.25 A of…

A: B = magnetic field due a inductor. B= uo n i Where n = number of turns i = current L= self…

Q: A series RL circuit includes a 8.05 V8.05 V battery, a resistance of ?=0.655 Ω, and an inductance of…

Q: What is the mutual inductance of two coils if an average electromotive force of 0.15 V was induced…

Q: The current of a coil of inductance L = 0.1 H varies with time according to I = 4 t2 - 6 t, where I…

Q: What value of inductance should be used if a 20.0 kΩ reactance is needed at a frequency of 500 Hz?

Q: If the peak value of a 60Hz generator is 160V, what is the instantaneous voltage after the loop has…

A: Given data The frequency of the generator is given as f = 60 Hz. The Peak value of the generator is…

Q: The current through a coil as a function of time is represented by the equation I(t) = Ae-bt…

Q: A pair of adjacent coils has a mutual inductance of 1.5 H. If the current in one coil changes from 0…

Q: The inductance of a closely packed coil of 400 turns is 8.0 mH. Calculate the magnetic flux through…

Q: 5. DETAILS ZILLDIFFEQMODAP11 3.1.029. A 40-volt electromotive force is applied to an LR-series…

Q: Two coils have a mutual inductance of 1.93x10-4 H. The current in the first coil increases at a…

A: Induced emf in the second coil is given by, ∈=M dIdt, M is mutual inductance and dIdt is rate of…

Q: What is the inductance of a coil in which the average emf induced is 20.0 mV when the current in…

A: E = 20mV 3.5 A to 7.7 A t = 0.33 sec L=?

Q: Suppose that a rectangular toroid has 2000 windingsand a self-inductance of 0.040 H. If h = 0.10 m ,…

A: Given Data: The number of winding is, N = 2000. The self inductance is, L=0.040 H. The height is, h…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

4.30 N
L
In the circuit the emf ɛ = 21.3 volts and the inductance L= 150 mH. What will be the energy in Joules in the magnetic field of the inductor 15.5 ms after the switch is
closed? (State answer with 3 digits right of decimal. Do not enter unit.)
%3D
ell

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
Show that N m /l and el(dl/dt), which are both expressions for se1f-inductance, have the same units.
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
A long, cylindrical solenoid with 100 turns per centimeter has a radius of 1.5 cm. (a) Neglecting end effects, that is the self-inductance per unit length of the solenoid? (b) If the current through the solenoid changes at the rate 5.0 AJs, what is the emf induced per unit length?
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?